Atlantic F129 Design CMG-BD 1 Bedienungsanleitung

F129 DESIGN

Operating manual

BD1

0628726

ELECTRICAL CONVECTOR

This product is only suitable for well insulated spaces or occasional use.

WARNING

Caution, hot surface.

WARNING: Some parts of this product may become

very hot and cause burns on contact. Special care

must be taken if children and vulnerable adults are

present.

- Children under 3 years must be kept away from this appliance,

unless they are constantly supervised.

- Children between 3 and 8 years should only put the unit on or

off, to provided that the latter has been placed or installed in a normal

position and that these children have supervision or have received

instructions on using the machine safely and understand the potential

hazards. Children aged between 3 and 8 years must not connect or

adjust or clean the device and perform maintenance or user.

- This unit can be used by older children at least 8 years and by

people with physical, sensory or mental capabilities or lack of

experience or knowledge, if they are monitored correctly or

instructions for using the appliance safely given to them and if the

risks were apprehended. Children should not play with the appliance.

Cleaning and maintenance by the user should not be performed by

children without supervision.

- This appliance may only be plugged in or connected by an

authorized person, according to valid regulations and rules.

- If the power cable is damaged, it should be replaced by the

manufacturer, his after-sales department or by a person of similar

qualification to avoid any danger.

- The user manual for the appliance is available from the after-

sales department, on the number shown on the warranty form

included with this manual.

- With the first setting in heating, a light odor can appear

corresponding to the evacuation of the possible traces related to the

manufacturing of the device.

Caution: For safety reasons, and to avoid overheating, do

not cover the heating appliance.

Appliances carrying this symbol must never be disposed of

with household waste, but must be collected separately for

recycling. At the end of their life, products must be collected

and recycled according to local regulations and ordinances.

When an appliance is installed at a higher altitude, the air

output temperature rises (around 10°C per 1000 m rise in

ground).

In case of use of the device in mobile version:

- Do not use it near a bath-tub, a shower or a swimming pool.

- Do not use this heating appliance near a bath, shower or

swimming pool. Do not use this heating appliance in small rooms,

when people with limited mobility are present who cannot leave the

room unaided, unless constant supervision is provided.

F129 DESIGN WITH ELECTRONIC THERMOSTAT

Atlantic brand founded in 1968 is known for its specialization in

heating systems, thermal comfort and energy saving technologies.

New F129 Design model purchased by you comes with 40 years of

experience and innovations. We hope that our product will fully meet

your needs. Thanks for your trust in Atlantic brand!

For more detailed information about all our solutions, please visit our

website: www.atlantic-comfort.com

Zona 1

Zona 2

INSTALLATION

Where to install the device?

- This appliance has been designed to be installed in residential

premises. Please consult your dealer if other circumstances apply.

- It must be installed in accordance with professional standards,

and comply with the regulations in force in the country of installation.

- The appliances are class II and protected from water splashes

to IP 24. They may therefore be installed in zone 2 of shower rooms.

It is forbidden to install the device in

zone 1. It must be impossible for

anyone using the shower or bath to

reach the appliance’s controls,

however.

- Respect minimum distances

to obstacles when positioning the

appliance.

- The appliance’s support

bracket allows to maintain a free

space behind the appliance so as

not to interfere with its adjustment.

The gap between the appliance and the wall shall not be obstructed

in any way. (The dimension are given in centimetres)

For appliances equipped with absence detector:

- To optimize the absence detection of your appliance, avoid installing the

device in narrow corner or behind furniture.

Do not install the appliance

- In a draught that could affect its adjustment (beneath a

centrally-controlled mechanical fan unit, etc.).

- Underneath a fixed mains socket or near curtains or any other

flammable materials.

- The air outlet grid and control unit must be visible at the top of

the appliance. It is forbidden to mount a vertical device horizontally

and vice versa.

Mobile version

Your model can be installed both in portable (mobile) and fixed

version. CAUTION! The appliances which are not equipped with

plug cannot be used in mobile version.

- The appliance must be placed on a horizontal surface. Please refer to feet

kit assembly instruction on page 2 of this booklet or to instructions with

feet (ref. 0517300, 0517400).

Wall mounting version

- Release the appliance’s latching bar.

We recommend you place the appliance flat on the ground. Use a

screwdriver to raise the tongue of the fitting, carefully so as not to

distort it. While keeping the tongue raised, push the latching bar

downwards to release the latches at the top. Pivot the latching bar

around the lower latches. Remove the latching bar.

- Fix the latching bar. Place the latching bar on the floor against the

wall. Locate the drilling points A. These show you where the lower

fastenings are. Lift the latching lug, aligning it with the drilling point A

to locate the drilling points B. These show you where the upper

fastenings are. Drill the four holes, and insert the plugs. If extra

support is needed, use special plugs (e.g.: in plasterboard). Position

the latching bar and screw in place.

- Lock the appliance onto latching bar. Place the appliance at an

angle on the supports S1. Pivot the appliance to place it on the

supports S2. Lower the appliance onto latching bar. The appliance

clicks in place, showing it is fixed and latched. To release the

appliance from the latching bar, use a flat-head screwdriver and push

the tongue (top left of the latching bar behind the appliance) towards

the wall. Lift the appliance while holding the tongue with the

screwdriver. Swing it forward then lift it off the supports S1.

Electric connection

- The power supply to the appliance is 220-240V, 50Hz/60Hz.

- In damp atmospheres, such as bathrooms and kitchens, the

junction box must be located at least 25 cm from the floor. The

appliance’s power supply must be connected straight to the mains,

after the all-pole cut-off, with a contact opening gap of at least 3mm

with no intermediate switch. The appliance must not be earthed.

OPERATING PRINCIPLE

- Increasing and decreasing

temperature (7°C to 30°C in Manual

Mode only) without further mandatory

confirmation

- Navigation through the menu;

- Confirmation;

- Switching off;

Blocking

unlocking

OPERATING MODES

The appliance has 2 operating modes:

Manual

The appliance constantly maintains the temperature set in the settings.

Prog

The appliance runs an internal program configured for each day of the

week. Once the appliance is switched on, the user can set the following

adjustment ranges:

Monday, Tuesday, Thursday and Friday, Comfort from 6.00 to 8.00 and

from 18.00 to 22.00. Wednesday Comfort from 6.00 to 8.00, from 12.00 to

14.00 and from 18.00 to 22.00. Saturday and Sunday, Comfort from 6.00

to 22.00. The user can change the specified ranges and set up to 3-time

ranges in Comfort mode for each day of the week. During execution of

these Comfort ranges, the set temperature can be adjusted with or

. Outside the Comfort ranges, the set temperature is the Eco temperature,

which can be set in Temp. ECO section (see “Menu in PROG mode”

section).

SWITCH

On the back of the appliance’s control unit there is On/Off button.

Use this switch only when you stop the heating for a long time (out of

heating season). To energize the appliance, set the On/Off button into

position. If the appliance is disconnected from the supply voltage, you will

have to re-set the date and time when switching on your appliance.

FIRST USE

Select your language, and then date and time. When you switch on the

appliance for the first time:

- MANUAL mode will be activated.

- the set temperature will be 20°C.

TURNING THE HEATING ON/OFF

To turn the heating off, press and hold down . Confirm "OFF" command

by pressing . To switch the appliance on, press and hold down .

CONTROL LOCK

To prevent changing the settings by children, you can lock the appliance

controls by pressing and holding down . Select “Lock” and confirm by

pressing . To unlock the controls, select “Unlock” .

TEMPERATURE SETTING

In MANUAL mode:

MANUAL

20.0º

19:30

Increase using (max: 30 °C).

Decrease using (min: 10 °C).

Can be decreased additionally to 7°C (anti-freezing temperature, which

is unchangeable) using .

In PROG mode:

PROG

20.0º

19:30

If the display shows PROG, you can set the programming range in

Comfort mode.

Increase the temperature using (max: 30°C).

Decrease the temperature using (min: 10°C).

PROG ECO

16.0º

19:30

If the display shows PROG ECO, you can set the programming range in

ECO mode. To change the temperature in ECO mode range, go to Temp.

ECO menu (see “Menu in PROG mode” section).

PROG

7.0º

19:30

If the anti-freezing temperature (7°C) is set, then when switching to ECO

mode programming range the display will show 6°C (automatic decrease

by 1°C).

When returning from ECO programming range to Comfort programming

range, the display will show the temperature that was pre-set in Comfort

mode, or, if it is the first use, – the temperature set in MANUAL mode.

Inhaltsverzeichnis

Andere Atlantic Heizung Handbücher

Atlantic

Atlantic KEA Bedienungsanleitung

Atlantic

Atlantic Panama Series Bedienungsanleitung

Atlantic

Atlantic Maradja Digital Bedienungsanleitung

Atlantic

Atlantic Doris mixte Ventilo Series Betriebsanleitung

Atlantic

Atlantic THEOLA Bedienungsanleitung

Atlantic

Atlantic Maradja Digital Bedienungsanleitung

Atlantic

Atlantic SOLIUS Bedienungsanleitung

Atlantic

Atlantic Maradja Digital Bedienungsanleitung

Atlantic

Atlantic F17 Kurzanleitung

Atlantic

Atlantic F17 Bedienungsanleitung

Atlantic

Atlantic Odyssee F117 Bedienungsanleitung

Atlantic

Atlantic Oniris RAF3H-i2g Bedienungsanleitung

Atlantic

Atlantic SFLC DIG2 Betriebsanleitung

Atlantic

Atlantic LST 1000W Gebrauchs- und Wartungshandbuch

Atlantic

Atlantic DIVALI Bedienungsanleitung

Atlantic

Atlantic DORIS Digital Mixte Bedienungsanleitung

Atlantic

Atlantic F18 Bedienungsanleitung

Atlantic

Atlantic DORIS Bedienungsanleitung

Atlantic

Atlantic Aeromobile 3000W Betriebsanleitung

Atlantic

Atlantic 2012 Bedienungsanleitung

Atlantic

Atlantic GALAPAGOS RFM5H Bedienungsanleitung

Atlantic

Atlantic Tatou Digital Bedienungsanleitung

Atlantic

Atlantic SOKIO Bedienungsanleitung

Atlantic

Atlantic 3410538311078 Bedienungsanleitung

Beliebte Heizung Handbücher anderer Marken

oventrop

oventrop Regucor Series Bedienungsanleitung

Blaze King

Blaze King CLARITY CL2118.IPI.1 Bedienungsanleitung

ELMEKO

ELMEKO ML 150 Bedienungsanleitung

BN Thermic

BN Thermic 830T Bedienungsanleitung

KING

KING K Series Leitfaden

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Kurzanleitung

Well Straler

Well Straler RC-16B Bedienungsanleitung

EUROM

EUROM 333299 Bedienungsanleitung

Heylo

Heylo K 170 Bedienungsanleitung

Eterna

Eterna TR70W Bedienungsanleitung

Clarke

Clarke GRH15 Bedienungsanleitung

Empire Heating Systems

Empire Heating Systems WCC65 Bedienungsanleitung

Wetekom

Wetekom 92 86 43 Bedienungsanleitung

Desa

Desa SPC170-F Bedienungsanleitung

Watlow

Watlow Watrod Electric Tubular Heaters Bedienungsanleitung

Haverland

Haverland ECO-DRY GPS Series Stücklistenhandbuch

Stelpro

Stelpro ASILVC2060 Series Bedienungsanleitung

iLO

iLO IHP2424 Betriebsanleitung