Axxess GMOS-044 Bedienungsanleitung
Installation instructions for part GMOS-044
Axxess Integrate
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
Connections to be made..................................... 2-3
Installing the GMOS-044 ....................................... 3
Initializing the GMOS-044...................................... 3
Adjusting the GMOS-044 ....................................... 4
Personalization Menu............................................ 4
No OE Steering Wheel Controls ............................. 5
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Used in amplified or non-amplified systems
• Retains chimes
• Provides NAV outputs (parking brake, reverse, mute, and speed sense)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• Retains OnStar/OE Bluetooth
• Adjustable volume for chimes and OnStar
• High level speaker input
• Micro “B” USB updatable
• Retains balance and fade
FEATURES
• Cutting tool • Crimping tool • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
TOOLS REQUIRED
GMOS-044
Chevrolet Cruze 2011-2015 / Cruze Limited 2016
(with monochrome screen)
• GMOS-044 interface • GMOS-044 harness
INTERFACE COMPONENTS
Table of Contents
GMOS-044
2
Connections to be made
From the 16-pin harness to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• Connect the Orange/White wire to the illumination wire. If the aftermarket
radio has no illumination wire just tape off the Orange/White wire.
• If equipped with a factory amplifier, connect the Blue/White wire to the amp
turn on wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Brown wire to the mute wire. If the aftermarket radio does not
have a Mute wire, tape up the Brown wire.
The following (3) wires are only for multimedia/navigation radios that require these wires
.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
From the 18-pin harness to the aftermarket radio:
• Connect the Black wire with the ring terminal to the radio chassis with the ISO
screw that is supplied with radio.
Note: This wire must be connected as instructed otherwise the interface
will not be functional.
• The Black/Yellow wire will be discussed later in this manual.
• If the vehicle does not come equipped with steering wheel controls, connect
the Green/Orange wire to the Green/Orange wire on the ASWC-STALK (sold
separately) to retain the personalization features. See the “No OE Steering
Wheel Controls” section for more information and wiring of the ASWC-STALK.
From the 44-pin harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Green wire to the left rear positive speaker output.
Continued on the next page
GMOS-044
3
Connections to be made Installing the GMOS-044
Initializing the GMOS-044
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output of the
aftermarket radio.
• Connect the Purple/Black wire to the right rear negative speaker output of the
aftermarket radio.
• Connect the RCA jacks to the audio AUX-IN jacks (if applicable).
Note: (a) This will allow you to retain the 3.5 AUX-IN jack in the console.
(b) The 3.5 jack can only be used if it is a single AUX-IN jack.
(c) If the AUX-IN jack has a USB port, neither can be used.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (not included) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard
this harness. If it will be used, please refer to the ASWC-1 instructions for radio
connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.
Note: The relay attached to the GMOS-044 is only for audible turn signal clicks.
No extra steps are required to retain this, so leave it as-is.
With the key in the off position:
• Connect the GMOS-044 harness into the interface, and then into the vehicle.
Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an ASWC-1 connect it after you initialize
and test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.
GMOS-044
4
Your vehicle must be equipped with OE steering wheel controls in order to access
or change the personalization features in your vehicle. If your vehicle did not come
equipped with OE steering wheel controls, please refer to the “No OE Steering
Wheel Control Section” of this manual.
Note: Personalization menu can be set before the factory radio is removed. Time
and date cannot be adjusted in vehicles without the factory steering wheel controls.
Note: OE Screen can be disconnected in models without factory steering
wheel controls.
1. Turn off your aftermarket radio.
2. Press and hold the Off Hook button on the steering wheel for 3-seconds. After
3-seconds the personalization menu will show up on the display.
3. To scroll through the menus, use the Seek Up and Seek Down buttons on the
steering wheel.
4. To make a selection, use the Source button on the steering wheel which is the
center button between the Seek Up and Seek Down buttons.
5. Use the Off Hook button to exit the personalization menu.
Personalization menu
Adjusting the GMOS-044
Chime level adjustment:
• With the vehicle on, turn it off and leave the keys in ignition. Open the driver’s
door; chimes will be heard.
• Wait 10 seconds, and then with a small screwdriver, turn the potentiometer
clockwise to raise the chime level; counterclockwise to lower the chime level.
• When the chime is at a desired level, remove the keys from the ignition. This
will lock the chime volume at its current level.
OnStar level adjustment:
• Press the OnStar button to activate it.
• While OnStar is speaking, press the VOLUME UP or VOLUME DOWN buttons on
the steering wheel to raise or lower the OnStar level.
• If the vehicle does not come equipped with steering wheel controls, find the
Black/Yellow wire on the 18-pin harness.
• While OnStar is speaking, tap the Black/Yellow wire to ground. Once the
OnStar level is set, it will stay at that level until the Black/Yellow wire is tapped
to ground again.
GMOS-044
5
Notes
If your vehicle did not come equipped with OE steering wheel controls, you can
purchase an ASWCSTALK to retain both the clock setting function, and the ability
to change the personalization features in your vehicle. Below are the wiring
instructions on wiring and using the ASWCSTALK.
Note: The ASWCSTALK cannot be used to control the aftermarket radio,
i.e., volume, seek, mute, etc. You can only use the ASWCSTALK for controlling the
personalization menu.
1. Connect the two Black wires of the ASWCSTALK to 12-volt accessory power.
2. Connect the Green/Orange wire from the ASWCSTALK to the Green/Orange
wire on the 18-pin harness of the GMOS-044.
3. Tape up the Green/Black wire from ASWCSTALK, as it has no connection
in this application.
4. Turn on ignition and test the ASWCSTALK. The following are the buttons that
apply to this application. All other buttons will not be used in this application.
No OE Steering Wheel Controls
ENTER/SELECT EXIT UP DOWN
Inhaltsverzeichnis
Andere Axxess Autozubehör Handbücher
Axxess
Axxess Automobile Parts Bedienungsanleitung
Axxess
Axxess LC-GMRC-LAN-09 Bedienungsanleitung
Axxess
Axxess AXDI-MB1 Bedienungsanleitung
Axxess
Axxess AX-ADFD01 Bedienungsanleitung
Axxess
Axxess AXDSPL-NI2 Bedienungsanleitung
Axxess
Axxess AX-ADXSVI-GM1 Bedienungsanleitung
Axxess
Axxess AXDSPL-TY3 Bedienungsanleitung
Axxess
Axxess AXSWC Bedienungsanleitung
Axxess
Axxess GMOS-13 Bedienungsanleitung
Axxess
Axxess AXDSPL-CH3 Bedienungsanleitung
Axxess
Axxess AX-BM90112 Bedienungsanleitung
Axxess
Axxess GMOS-LAN-07 Bedienungsanleitung
Axxess
Axxess AXi-MBEIRC-R Bedienungsanleitung
Axxess
Axxess AXAC-MZ1 Bedienungsanleitung
Axxess
Axxess AX-VL90042 Bedienungsanleitung
Axxess
Axxess AX-GMCL2-SWC Bedienungsanleitung
Axxess
Axxess AXXESS OESWC-6502-STK Bedienungsanleitung
Axxess
Axxess AXDSPX-CH5 Bedienungsanleitung
Axxess
Axxess AXDSPX-HK1 Bedienungsanleitung
Axxess
Axxess AXi-HA20-R Bedienungsanleitung
