Barco RLM-W14 Bedienungsanleitung

1 of 149

PROJECTOR

Service Manual

BARCO RLM W14

Rev.01

2 of 149

DLP DIGITAL PROJECTOR rev.01

Revision

Description

Date

Rev.00

Preliminary

7/4/2014

Rev.01

Chapter 2-2. Block Diagram –Page 11

Chapter 5. PROGRAM SETTING AND SOFTWARE DOWNLOAD –

Page 72

Chapter 8. SPART PARTS LIST & SPARE PARTS PHOTO –Page

121

Chapter 6-4. Focus Adjusting –Page 112

8/4/2014

3 of 149

CONTENTS

1,COMPLIANCE OF SAFE REPAIR..........................................................................5

1-1 Cautions during disassembling and assembling .................................................6

1-2 Lamp.........................................................................................................................6

1-3 Lens..........................................................................................................................6

2. SPECIFICATIONS ..............................................................................................7

2-1 Optical Specifications .............................................................................................7

2-2 Block Diagram…………………………….….…………………………………………...11

2-3 Fan Location. .........................................................................................................13

3. TROUBLESHOOTING.......................................................................................15

3-1 RS-232 Protocol Command..……………………………………………….…………..15

3-2 Troubleshooting & Error Code...……………………………………………………….35

4. KEY PART REPLACEMENT & WIRE DRESSING…...……………………….…………...…40

5. PROGRAM SETTING AND SOFTWARE DOWNLOAD……………………………………..72

5-1 Firmware Downloads Procedure for Main Formatter Board……….………..…….72

5-2 Firmware Downloads procedure for sxW2 Board…………..……………….….…...76

5-3 Firmware downloads procedure for RJ-45 Board…………………………………...79

5-4 Recover Process Procedure for NXP MCU…………………………………………...84

5-5 Firmware downloads procedure for Motor Board…………………………………...90

5-6 Firmware downloads procedure for Ballast Board………….……………………...94

5-7 Firmware downloads procedure for HDBASE T Board…….………….…………...98

6. ADJUSTING……………..…………………………….…………..………..….…...…101

6-1 FIP Convergence (CG) Adjusting….……………………….…………………………101

6-2 Folding Mirror Adjusting..………..………………………….…………………………107

6-3 P7 Color Calibraton………………..………………………….…………………………108

6-4 Focus Adjusting…..………………..………………………….…………………………112

7. MAINTENANCE………………………..…………………………………………..…………….117

7-1 Cleaning the projector………………………………….….…….……………………...117

7-1-1 Cleaning the cabinet.….………………….……….…………..………...…117

7-1-2 Cleaning the Lens.……...……….……….…….…….………….……........117

7-1-3 Cleaning the filters.…………..………….…….…….…….…………….…117

7-1-4 Cleaning the optical parts………………….….….…………….……..….118

7-2 Replacing Consumable Parts………………………….….…….…………………..…119

7-3 Replacing the Lamp……….…………………………….….…….……….………….…120

4 of 149

7-4 Replacing the Filter……….….………………………….….…….……………………..123

8. SPART PARTS LIST & SPARE PARTS PHOTO………..…………………………..………126

9. PRODUCT PACKAGING…………………..……………………...……………….…………..138

9-1 Full Set Unit Packaging….…..………………………….……….……….………….…138

9-2 Model Accessory Part..………………………………….……….……….………….…139

9-3 Carton…………………………..………………………….……….……….………….….140

9-4 Serial NO. Label Explanation……...………………….……….……….…..……….…141

9-5 AIR & SEA Shipping Packaging……………………….……………….…..……….…142

APPENDIX TIMING TABLE……………………………………………….…….…..……….…143

5 of 149

BARCO RLM W14 Projector

PLEASE NOTE

The information contained herein is based on the experience and knowledge relating

to the subject matter gained by Barco prior to publication. No patent license is granted

by this information.

Barco reserves the right to change this information without notice, and makes no

warranty, express or implied, with respect to this information. Barco shall not be liable

for any loss or damage, including consequential or special damages, resulting from

any use of this information, even if loss or damage is caused by Barco’s negligence or

other fault.

This equipment includes parts and assemblies sensitive to damage from

electrostatic discharge. Use caution to prevent damage during all service

procedures.

6 of 149

1. COMPLIANCE OF SAFE REPAIR

Be sure to read this Service Manual before providing services.

In the projector, full consideration is taken to ensure the safety for fire, electric shock, injury, harmful radiation,

and substance. Therefore, observe the notice described in this Service Manual so that safety is kept when

providing services. Moreover, be sure to observe the notice described in the Instruction Manual.

Pay attention to the following during service inspection.

1-1 Cautions during disassembling and assembling

1. This equipment contains parts under high voltage. When making repairs, etc. Be sure to pull out the power

plug beforehand to insure safety.

2. Parts may be very hot immediately after use. Make sure the equipment has cooled off sufficiently before

carrying out repairs.

3. Make sure that parts and screws and wiring, etc. are returned to their original positions. Tube, tape and

other insulation materials have been used for safety reasons. The internal wiring has been designed to

avoid direct contact with hot parts or parts under high voltage when using clamps or other tools.

4. The parts used in this device have special safety features such as flame-resistance and anti-voltage

properties. When replacing parts, always use parts supplied from the factory.

5. After finishing operations make sure that all parts and wires have been returned to their original position and

that there has been no deterioration of the area around the location that was worked on.

6. Be sure to use an earth band (wrist band) during repair and inspection.

1-2 Lamp

During current conduction, the lamp is in the high-temperature state. In this case, pay careful attention

because a high voltage is used. When replacing a lamp, replace it after confirming that the lamp has cooled

sufficiently.

1-3 Lens

Do not look into the lens during projection. This damages your eyes.

7 of 149

2. SPECIFICATIONS

This section provides technical information about the projector's performance.

2-1 Specifications

*Item

Description

Projection system

It is designed with DMD LVDS 0.96" 1920*1200 1200P SPD DC3 DLPTM 3-chips channel

high-definition images projector.

Resolution

WUXGA 1200P (1920 x 1200) pixels

Lamp

Dual Lamp System - LAMP 465W x 2 NSH

Brightness

13,500ANSI Lumen; 14,500 ANSI Lumen (Center)

Brightness Uniformity

>83%

Contrast Ratio

> 1650:1

Focus

Balance focus over the entire image area with Barco 2~ 2.8 Lens (wide) at 100 inch screen, and

check the white “ME” text of center and four corners must be visible.

Flare

Center <= 1.5 pixel (not include pixel itself)

Corner<=2 pixel (not include pixel itself)

with Barco 2~ 2.8 Lens (wide) at 100 inch screen by 0.5 m

Dust & Blemish

No visible dust and blemish @ 100% Black & Full white image by 2.5 m

Color Band

No visible color band around 4 edges and corners @ 100% Black & Full white image

Flicker

No visible flicker around 4 edges and corners @ 100% Black & Full white image

Lens shift

Vertical Lens Shift: Lens shift (Up) >125% ; Lens shift (Down) > 70%

Horizontal Lens Shift: Lens shift (Right) >30% ; Lens shift (Left) >30%

8 of 149

Projection Lens

R9862000-TLD+ (0.73:1)

R9840775-TLD+ (1.2:1)

R9862010-TLD+ (1.5 - 2.0:1)

R9862020-TLD+ (2.0 –2.8:1)

R9862030-TLD+ (2.8 –4.5:1)

R9862040-TLD+ (4.5 –7.5 :1)

R9829997-TLD+ (7.5 –11.2:1)

R9862005-TLD+ Ultra (1.25 –1.6)

9 of 149

Inputs / Outputs

●HDMI input

●SDI/HDSD/3G Input

●SDI/HDSD/3G Output

●D-SUB 15 input (RGBHV)

●HDBaseT Input (Digital Video)

●SYNC Input

●SYNC Output

●5-BNC Input (RGBHV)

●3-RCA Input (YPbPr)

●RS-232 input (Support RS-232 standard, Firmware download, Switch on & off, RS-232

commands)

●IR input x 2 (Front-IR & Back-IR)

●Triggers Input

●RJ-45 (LAN) input (Provide Ethernet Connectivity & Web Server)

●DVI-3D Input (DVI-D Dual Link)

Audible Noise

Bright Mode 46 dBA (typical at 25℃/77℉)

ECO Mode 42 dBA (typical at 25℃/77℉)

Power Requirement

100 ~240 VAC; 50/60 Hz

Power Consumption

1230 W (Max) @ 110 VAC

1140W (Max) @ 220 VAC

Power Consumption in

ECO mode

955 W (Max) @ 110 VAC

895 W (Max) @ 220 VAC

Power Consumption in

Standby mode

＜2 W

10 of 149

Temperature

Non- Operating : -20~ 60 °C

Operating : 0~ 40 °C

Altitude

Non-Operating : no definition

Operating : up to 3,000 m @ 25°C

Humidity

Non-Operating : 90%

Operating : 0 ~ 90%

Dimensions

504.8 mm (W) x 631 mm (L) x 277 mm (H)

Weight

33.5 kg

Andere Handbücher für RLM-W14

Inhaltsverzeichnis

Andere Barco Projektor Handbücher

Barco

Barco XLM HD30 Bedienungsanleitung

Barco

Barco ClickShare CSE-200 Bedienungsanleitung

Barco

Barco OVERVIEW D 50" Bedienungsanleitung

Barco

Barco F400 Bedienungsanleitung

Barco

Barco Galaxy NW12 Montageanleitung

Barco

Barco R9002110 Bedienungsanleitung

Barco

Barco R9002240 Bedienungsanleitung

Barco

Barco SIM 7QP HB Bedienungsanleitung

Barco

Barco ACTAS 2 Bedienungsanleitung

Barco

Barco SIM 7C R9011206 Bedienungsanleitung

Barco

Barco SIM 5R Bedienungsanleitung

Barco

Barco R9010010 Bedienungsanleitung

Barco

Barco FLM HD18 Bedienungsanleitung

Barco

Barco IQ-Graphics 300 Bedienungsanleitung

Barco

Barco R9002380 Bedienungsanleitung

Barco

Barco Graphics 808s R9000904 Bedienungsanleitung

Barco

Barco Loki Bedienungsanleitung

Barco

Barco OV-713 Bedienungsanleitung

Barco

Barco R9000901 Bedienungsanleitung

Barco

Barco RETRO DATA 2100LC Bedienungsanleitung

Barco

Barco Cineo12 Bedienungsanleitung

Barco

Barco HDF W series Bedienungsanleitung

Barco

Barco R9002260 Bedienungsanleitung

Barco

Barco R9001950 Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung

NEC

NEC NP600S EDU Bedienungsanleitung

BenQ

BenQ SH753P Bedienungsanleitung

Eiki

Eiki EK-623U series Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Christie

Christie LHD700 Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Acer

Acer C20 Series Bedienungsanleitung