9
Digital Video Baby Monitor EN
Installation location and installation of the baby monitor
1. Baby unit
■When using the baby monitor inside acar, install the baby unit A1on awindows so that the camera
B3is pointing at the child but at the same time is out of the child'sreach. To attach the baby unit
A1to the window, use the included holder A2.
■When using the baby monitor at home, locate the baby unit A1in the room where you wish to monitor
your child. We recommend an elevated location at asufficient distance away from equipment and
devices that could cause signal interference. Using holder A2, attach the baby unit A1on to awindow
pane, furniture, etc.
■When the baby unit A1is to be powered from an external power source, locate it within reach of
apower socket. In order to minimise electro-smog, the baby unit A2powered from apower socket,
should be located at least 1 m away from your child.
Attention:
Before connecting the power adapter A3to apower socket, to make sure the voltage stated on its
rating label corresponds to the voltage in the power socket. Do not locate the baby unit A1, power
adapter A5or the 12V car charger A6within your child'sreach.
■Based on the aforementioned instructions, first select asuitable location, then install the holder A2
and connect the baby unit A1to it. The holder A2can be attached to smooth surfaces such as
glass, furniture, etc. To release the suction cup D3, release clip D5. Place the suction cup D3
against asuitable surface and secure clip D5. This will attach the holder A2. Before connecting the
baby unit A1to the holder A2, make sure that the suction cup D3has properly adhered to the
surface. Otherwise, the holder A2could fall. If this happens, it is necessary to move the holder A2
to adifferent location or to select adifferent type of surface.
■Once the holder A2is properly installed, screw the thread B9located at the rear of the baby unit
A1, on to the head D4. When the head D4is properly screwed in the thread B9, you may set
the camera B3to the required angle. To set the required angle of the camera B3, loosen the screw
D1and set the swivel joint of the arm D2so that the lens of the camera B3covers the area that
you wish to monitor. To lock the arm in the required angle, tighten screw D1.
■Before removing the holder A2, first remove the baby unit A1. Then release the clip D5, grab the
lip D6and remove the holder A2.
2. Parent unit
■When using the baby monitor inside acar, connect the parent unit A3using holder A4to the front
windscreen so that you can comfortably watch the picture coming from camera B3on screen C1.
Install the holder A4with the parent unit A3so that it does not interfere with the driver'svisibility.
■When using the baby monitor at home, locate the parent unit A3in the room where you will be
located. Using holder A4, attach it to awindow pane, furniture, etc. or freely put it down on an even,
dry, stable and clean surface, e.g. atable, kitchen countertop, etc.
■When the parent unit A3is to be powered from an external power source, locate it within reach of
apower socket.
