2.1. Car Installation
Insert the metal clip on the ack of the speaker and clip it on driver’s car visor. Make sure the speaker
is firmly attached with the microphone pointing towards the driver.
2.2. Charging
Prior to using the speaker the first time, it is recommended to fully charge the attery. Normal full
charge time is approximately 2 hours. The red LED will stay on while charging and will e off as soon
as it is completed.
IMPORTANT:
- Charging indication will e delayed y a few minutes if the speaker has not een used for a long time
or the attery is drained.
- To prolong attery life, it is recommended to charge the speaker as soon as the low attery indicator
is shown.
2.3. Power On / Power Off
Power On: press and hold the MFB utton for 3 seconds until you hear a short eep. The flashing lue
LED light indicator comes on, and the speakerphone automatically connects to the mo ile phone it has
een paired with already.
Power Off: press and hold the MFB utton for 3 seconds until you hear a short eep. The flashing red
LED light indication goes off.
2.4. Pair and connect
Refer to the Bluetooth pairing procedures in the mo ile phone user manual.
When the speaker is off, long press the MFB utton for a out 5 seconds until the light indicator flashes
red and lue alternatively, then release the utton. The alternated flashes indicate that the speaker is in
pairing mode.
Search for Bluetooth devices in the phone, select “BeeWi BBS010” on display and enter the pass key
“0000” to add the speaker to the pair list. When pairing is complete, the lue and red LED light will
stop flashing, and the speaker will automatically connect to the phone and go in stand y mode with the
lue light flashing every 3 seconds.
Check the connection y placing a call from your phone.
Note: If the pairing cannot e completed within 2 minutes after the pairing mode is activated, the
speaker will power OFF automatically. Repeat the steps a ove to pair the speaker and mo ile phone
again.
2.5. Status indicators
Status LED Descriptions
Power On Blue 3 seconds flash
Power Off Red 3 seconds flash, then Off
Pairing Blue/Red Alternated linking
Stand y Mode (Connected) Blue Blinking every 3 seconds
Stand y Mode (Disconnected) Blue Blinking twice every 3 seconds
During Communication Blue Blinking every 6 seconds
Low Battery Red Blinking every 3 seconds
Charging Red Light on
Charging Completed Red Light off
2.6. Connection
The speaker automatically connects to the last connected device when it is turned on. If the device is
not found, the speaker will connect to a previous device in the paired list.
In case the connection is not made automatically, it is possi le to reconnect manually either from the
speaker y pressing the MFB or from the mo ile device (refer to the phone user manual). It is also
