BEGA 98 019 Handbuch

Beliebte Außenleuchte Handbücher anderer Marken

Sealey

Sealey LED37 Bedienungsanleitung

nordlux

nordlux VEJERS Benutzerhandbuch

SImx

SImx ELITE LED LHTC637 Bedienungsanleitung

GEV

GEV CAROLINE 10833 Bedienungsanleitung

NEBO

NEBO NEB-LSP-0020 Bedienungsanleitung

WE-EF

WE-EF PFL540 LED Bedienungsanleitung

Lindby

Lindby 9949029 Bedienungsanleitung

HEPER

HEPER DOGO Side LW6048.585-US Montage- und Bedienungsanleitung

HEPER

HEPER LW8034.003-US Montage- und Bedienungsanleitung

Maretti

Maretti VIBE S 14.6080.04.A Bedienungsanleitung

HEPER

HEPER MINIMO Montage- und Bedienungsanleitung

LIGMAN

LIGMAN BAMBOO 3 Bedienungsanleitung

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Bedienungsanleitung

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Bedienungsanleitung

urban ambiance

urban ambiance UQL1273 Bedienungsanleitung

TotalPond

TotalPond 52238 Bedienungsanleitung

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Bedienungsanleitung

LIGMAN

LIGMAN DE-20023 Bedienungsanleitung

Installation and Technical Information

BEGA

Due to the dynamic nature of lighting products and the associated technologies, luminaire data on this sheet is subject to change at the discretion of BEGA North America. For the most current technical data, please refer to bega-us.com

BEGA 1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 © copyright BEGA 2021

Overview:

LED Watts: 35.7 W

System Watts: 39.7 W

Controllability: 0-10V, TRIAC, and ELV dimming to 1%

Weight: 33.0 lbs.

Protection Class: IP65

Tools Required:

• 5mm Hex key

• 6mm Hex key

• 8mm Hex key

Indirect pole-top luminaire - Adjustable with cut-o󰀨 optics 98 019

Notice to Installer:

1. Do not open luminaire.

2. For pole top applications only.

3. Slip ts 3” O.D. pole top or tenon.

4. Luminaire requires at least 3-1/2” of straight diameter pole or tenon.

5. LEDs are high-quality electronic components! Please avoid touching diode of LED

module when installing.

Pole top reector assembly:

1. Loosen the (2) 8mm hex screws at the top of the support rods and remove

screws and xing plates.

2. Attach the reector disk to the support rods by positioning the joint shells over the

joint bearings. Make sure the drip edges are oriented downwards.

3. Replace the xing plates and screws.

4. Tilt the reector to the desired orientation (0-30 degrees).

5. Tighten the (2) 8mm hex screws to secure in place.

98 019 Installation:

1. Route luminaire wiring down to base of pole.

2. Make supply wiring connections:

MAIN VOLTAGE SUPPLY WIRE TO BLACK WIRE

NEUTRAL (COMMON) SUPPLY WIRE TO WHITE WIRE

GREEN GROUND SUPPLY WIRE TO GREEN WIRE

Dimming (if applicable):

DIMMING CONTROL SUPPLY WIRE (+) TO POSITIVE DRIVER DIM

CONTROL WIRE

DIMMING CONTROL SUPPLY WIRE (-) TO NEGATIVE DRIVER DIM

CONTROL WIRE

4. Slip luminaire over the top of the pole.

5. Tighten the (6) 5mm set screws evenly to secure to pole.

Dimensions

A: 31-1/2’’

B: 21-1/4’’

Maintenance:

Clean regularly with solvent-free cleaner

removing dirt and debris. Do not use high

pressure cleaners.

Replacement Parts

See label inside of xture for LED replacement

part number.

Consult factory for all other replacement

components.

Accessories

Please refer to the appropriate accessory installation

sheet for further instruction when applicable.

Updated: 03/30/21

98 019 1 of 2

B

A

Installation and Technical Information

BEGA

Due to the dynamic nature of lighting products and the associated technologies, luminaire data on this sheet is subject to change at the discretion of BEGA North America. For the most current technical data, please refer to bega-us.com

BEGA 1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 © copyright BEGA 2021

Product Safety Warnings:

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON

FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

SUITABLE FOR WET LOCATIONS.

MIN 90°C SUPPLY CONDUCTORS.

CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, PAR UNE PERSONNE QUI CONNAÎT

BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS.

CONVIENT AUX EMPLACEMENTS MOUILLÉS.

LES FILS D’ALIMENTATION 90°C MIN.

Updated: 03/30/21

2 of 2

98 019

Indirect pole-top luminaire - Adjustable with cut-o󰀨 optics 98 019