Billion BiPAC 7700N Bedienungsanleitung

BiPAC 7700N

Wireless-N

ADSL2+ Firewall Router

Quick Start Guide

Billion BiPAC 7700N Wireless-N ADSL2+ Firewall Router

BiPAC 7700N Wireless-N ADSL2+ Firewall Router

CD containing the on-line manual and Setup Wizard Utility

RJ-11 ADSL/ telephone cable

Ethernet (RJ-45) cable

Power adapter

Quick Start Guide

Splitter/ Micro-filter (Optional)

Warning

PLEASE READ THE QUICK START GUIDE AND FOLLOW THE

STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU

INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE.

IF YOU NEED MORE INFORMATION ON THIS SOFTWARE

CONFIGURATION, PLEASE REFER TO THE USER MANUAL ON

CD-ROM.



Do not use the

router

in high humidity or high temperatures.

Do not use the same power source for the router as other

equipment.

Do not open or repair the case yourself. If the router is too hot,

turn off the power immediately and have it repaired at a qualified

service center.



Avoid using this

product

and all

accessories

outdoors.



Place the router on a stable surface.

Only use the power adapter that comes with the package. Using a

different voltage rating power adaptor may damage the router.

Attention

Billion BiPAC 7700N Wireless-N ADSL2+ Firewall Router

The Front LEDs

The bottom Casing

When the system is

ready, it will be lit

green. Lit red when the

device fails to boot.

Lit green when successfully

connected to an Ethernet

device. Blinking when data is

being transmitted / received.

Lit green when the

device is successfully

connected to an ADSL

DSLAM. (“line sync”)

Lit green when a

wireless connection

is established. Unlit

when wireless is

disabled.

Lit red when WAN port fai

ls to

get IP address. Lit green when

WAN port gets IP address

successfully. Unlit when the

device is in bridge mode or

WAN connection is absent.

Press for more than 5

seconds to restore the

device to its factory

default mode.

Flash green when

WPS configuration

is in progress.

Billion BiPAC 7700N Wireless-N ADSL2+ Firewall Router

The Rear Ports

Note: For WPS configuration, please refer to the WPS section of User Manual.

Connect it with the

supplied power

adapter.

Connect the supplied

RJ-11 cable to this port

when connecting to the

ADSL/telephone network.

Connect your computer to

a LAN port, using the

included Ethernet cable

(with RJ-45 cable).

Power

ON/OFF

switch

Push WPS button

to trigger Wi-Fi

Protected Setup

function.

Press to enable wireless

when wireless is disabled

and the WLAN LED lit.

Press to disable wireless

when wireless is on and

the WLAN LED will be OFF.

Billion BiPAC 7700N Wireless-N ADSL2+ Firewall Router

1. Power Connection

Plug the supplied power adapter in to th

e wall jack and the other side to the router.

Please note that the plug type may differ according to country.

2. Ethernet Connection

Connect the supplied RJ-45 Ethernet cable to one of the Fast Ethernet (LAN)

ports, and the other side to the PC’s Ethernet interface.

3. ADSL Connection

Connect the supplied RJ-11 phone cable to the router’s ADSL port, and the other

side to the phone jack on the wall.

Billion BiPAC 7700N Wireless-N ADSL2+ Firewall Router

4. Splitter/ Micro-filter Connection

The Splitter / Micro-filter are important for ADSL installation, they help direct

high-frequency signals to the ADSL modem & low frequency signals to the

telephone or other analogue device to prevent inter-modulation distortion & get

good speed/stable ADSL sync rate.

a) Splitter connection

If the installation has only a single telephone and a single ADSL modem, then a

splitter can be employed.

b) Micro-filter connection

If the installation has several telephones or other analog devices, then an

internal micro-filter can be employed at each analog device.

After you complete the hardware installation insert CD into the CD Drive to run the setup utility.

The setup utility will auto-run. Follow the step-by-step configuration wizard & it will guide you to

setting up the basic network configuration.

1. Open the web browser and type http://192.168.1.254 in the browser's address box. This

number is the default IP address for this router. Press Enter.

2. A username and password window will appear. The default username is “admin”, and

password is “admin”. Press OK to proceed.

Billion BiPAC 7700N Wireless-N ADSL2+ Firewall Router

3. You will get a status report web page and main menu screen.

Please see the relevant sections of user manual for detailed instructions on how to

configure your router.

1. None of the LEDs are on when you turn on the router.

Check the connection between the adapter and the router. If the error persists, you may have

a hardware problem. In this case you should contact technical support.

2. Can’t ping any PCs on the LAN.

Check the Ethernet LEDs on the front panel. The LED should be on for a port that has a PC

connected. If it is off, check the cables between your router and the PC. Make sure you have

uninstalled any software firewall for troubleshooting. Verify that the IP address and the subnet

mask are consistent between the router and the workstations.

3. Frequent loss of ADSL line sync (disconnections).

Ensure that all other devices connected to the same telephone line as your router (e.g.

telephones, fax machines, analogue modems) have a line filter connected between them and

the wall socket (unless you are using a Central Splitter or Central Filter installed by a qualified

and licensed electrician), and ensure that all line filters are correctly installed and the right

way around. Missing line filters or line filters installed the wrong way around can cause

problems with your ADSL connection, including causing frequent disconnections. If you have

a back-to-base alarm system you should contact your security provider for a technician to

make any necessary changes.

Most problems can be solved by referring to the Troubleshooting section in the user manual.If

you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer

where you purchased this product.

WORLDWIDE

http://www.billion.com

BiPAC

7700N

V1.

Andere Handbücher für BiPAC 7700N

Andere Billion Netzwerk-Router Handbücher

Billion

Billion BiPAC 5210S RC Betriebsanleitung

Billion

Billion BiPAC 7300 RA Bedienungsanleitung

Billion

Billion myGuard 7500GL Bedienungsanleitung

Billion

Billion BiPAC 7402NX Bedienungsanleitung

Billion

Billion BiPAC 8501 Bedienungsanleitung

Billion

Billion BiPAC 7402 Bedienungsanleitung

Billion

Billion BiPAC 5200 RC Bedienungsanleitung

Billion

Billion BiPAC 5200G R4 Series Bedienungsanleitung

Billion

Billion 800VGT Bedienungsanleitung

Billion

Billion BIPAC-7402 Bedienungsanleitung

Billion

Billion BiPAC 7800(N) Bedienungsanleitung

Billion

Billion BiPAC 7300WX Installations- und Betriebshandbuch

Billion

Billion ADSL Modem / Router BIPAC-711C2 Bedienungsanleitung

Billion

Billion BiPAC 7402(G)X(L) Series Bedienungsanleitung

Billion

Billion BiPAC 7402NX Bedienungsanleitung

Billion

Billion BiPAC 4500NZ(L) Bedienungsanleitung

Billion

Billion BiPAC 7800NL Bedienungsanleitung

Billion

Billion BIPAC 5102 Series Bedienungsanleitung

Billion

Billion BiPAC 7300G RA Bedienungsanleitung

Billion

Billion BiPAC 7402G Bedienungsanleitung

Billion

Billion BiPAC 7820NZ Bedienungsanleitung

Billion

Billion BiPAC 7402(G)(L) R3 Series Bedienungsanleitung

Billion

Billion BiPAC 7300N Bedienungsanleitung

Billion

Billion BiPAC 7402(G)X(L) Series Bedienungsanleitung

Beliebte Netzwerk-Router Handbücher anderer Marken

Allnet

Allnet ALL0333AU Bedienungsanleitung

HomeSeer

HomeSeer HT-SEL Bedienungsanleitung

Sercomm

Sercomm Genesis OC3505D Bedienungsanleitung

TP-Link

TP-Link TD-8817 Bedienungsanleitung

Motorola

Motorola MR1900 Bedienungsanleitung

Digi

Digi IX14 Bedienungsanleitung

Cisco

Cisco NCS 540 Handbuch

XAVi

XAVi X8821e Bedienungsanleitung

BEC

BEC 6200WZL Bedienungsanleitung

MikroTik

MikroTik hAP ac3 Series Bedienungsanleitung

Korenix

Korenix JetNet 5428G Series Bedienungsanleitung

NETGEAR

NETGEAR FS526T - Switch Bedienungsanleitung

Automated Logic

Automated Logic ZN551 Betriebsanleitung

Cisco

Cisco ASR 1000 Series Bedienerhandbuch

EnGenius

EnGenius ESR-9710 Bedienungsanleitung

Cisco

Cisco 805 Series Bedienungs- und Sicherheitshinweise

LevelOne

LevelOne FBR-1416 Bedienungsanleitung

Dynacord

Dynacord Promatrix 6000 Bedienungsanleitung