Black Box ACU315A Bedienungsanleitung

THE RGB TO DVI(/VGA) CONVERTER

Welcome to the RGB to DVI(/VGA) Converter

Family!

Thank you for purchasing an RGB to DVI(/VGA) Converter! We appreciate your business,

and we think you’ll appreciate the many ways that your enhanced RGB Graphic system will

save you money, time, and effort.

That’s because our ACU315A Converter is all about breaking away from the traditional

model of attaching a new display to an old graphic source. You can encounter many potential

problems in connecting a flat screen to an RGB graphic source – unless you use our

ACU315A Converter products! Attach a flat screen to any graphic source and match the

output to your requirements. The ACU315A Converter – the one-stop answer for all your

RGB adapting needs! And with a special adaptor cable (not supplied as standard), you can

also attach a screen to a CGA or EGA source.

This manual will tell you all about your new ACU315A Converter, including how to install,

operate, and troubleshoot it. For an introduction to the Converter, see Chapter 2. The

Converter product codes covered in this manual are:

ACU315A

THE RGB TO DVI(/VGA) CONVERTER

Copyrights and Trademarks

the prior written consent of the manufacturer.

Information in this document is subject to change without notice and the manufacturer shall

not be liable for any direct, indirect, special, incidental or consequential damages in

connection with the use of this material.

All trademark and trade names mentioned in this document are acknowledged to be the

property of their respective owners.

Disclaimer

While every precaution has been taken in the preparation of this manual, the manufacturer

assumes no responsibility for errors or omissions. Neither does the manufacturer assume any

liability for damages resulting from the use of the information contained herein. The

manufacturer reserves the right to change the specifications, functions, or circuitry of the

product without notice.

The manufacturer cannot accept liability for damage due to misuse of the product or due to

any other circumstances outside the manufacturer’s control (whether environmental or

installation related). The manufacturer shall not be responsible for any loss, damage, or injury

arising directly, indirectly, or consequently from the use of this product.

Cautions and Notes

The following symbols are used in this guide:

CAUTION. This indicates an important operating instruction

that should be followed to avoid any potential damage to

hardware or property, loss of data, or personal injury.

NOTE. This indicates important information to help you make the best use of this

product.

FCC/CDC STATEMENTS

FEDERAL COMMUNICATIONS COMMISSION

AND CANADIAN DEPARTMENT OF COMMUNICATIONS

RADIO-FREQUENCY INTERFERENCE STATEMENTS

This equipment generates, uses, and can radiate radio-frequency energy, and if not installed

and used properly, that is, in strict accordance with the manufacturer’s instructions, may

cause interference to radio communication. It has been tested and found to comply with the

limits for a Class A computing device in accordance with the specifications in Subpart B of

Part 15 of FCC rules, which are designed to provide reasonable protection against such

interference when the equipment is operated in a commercial environment. Operation of this

equipment in a residential area is likely to cause interference, in which case the user at his

own expense will be required to take whatever measures may be necessary to correct the

interference.

Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

Shielded PC-equipment cables must be used with this equipment to maintain compliance with

radio frequency energy emission regulations and ensure a suitably high level of immunity to

electromagnetic disturbances.

This digital apparatus does not exceed the Class A limits for radio noise emission from digital

apparatus set out in the Radio Interference Regulation of the Canadian Department of

Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites

applicables aux appareils numériques de la classe A prescrites dans le Règlement sur le

brouillage radioélectrique publié par le Ministerié des Communications du Canada.

THE RGB TO DVI(/VGA) CONVERTER

EUROPEAN UNION DECLARATION OF CONFORMITY

This is to certify that, when installed and used according to the instructions in this

manual, together with the specified cables and the maximum cable length <3m, the

Units are shielded against the generation of radio interferences in accordance with the

application of Council Directive 89/336/EEC as well as these standards:

EN 55022: 1999 Class B

EN 55024: 1999

IEC 61000-4-2: 2001

IEC 61000-4-3: 2001

IEC 61000-4-4: 2001

EN 61000-3-2 2001

EN 61000-3-3 2002

The device was tested in a typical configuration with PC.

NOM STATEMENT

NORMAS OFICIALES MEXICANAS (NOM)

ELECTRICAL SAFETY STATEMENT

INSTRUCCIONES DE SEGURIDAD

1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el

aparato eléctrico sea operado.

2. Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura.

3. Todas las advertencias en el aparato eléctrico y en sus instrucciones de operación deben

ser respetadas.

4. Todas las instrucciones de operación y uso deben ser seguidas.

5. El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo, cerca de la tina de

baño, lavabo, sótano mojado o cerca de una alberca, etc..

6. El aparato eléctrico debe ser usado únicamente con carritos o pedestals que sean

recomendados por el fabricante.

7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado

por el fabricante.

8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo

descrito en las instrucciones de operación. Todo otro servicio deberá ser referido a

personal de servicio calificado.

9. El aparato eléctrico debe ser situado de tal manera que su posición no interfiera su uso.

La colocación del aparato eléctrico sobre una cama, sofá, alfombra o superficie similar

puede bloquea la ventilación, no se debe colocar en libreros o gabinetes que impidan el

flujo de aire por los orificios de ventilación.

10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de calor como

radiadores, registros de calor, estufas u otros aparatos (incluyendo amplificadores) que

producen calor.

11. El aparato eléctrico deberá ser connectado a una fuente de poder sólo del tipo descrito en

el instructivo de operación, o como se indique en el aparato.

12. Precaución debe ser tomada de tal manera que la tierra fisica y la polarización del equipo

no sea eliminada.

13. Los cables de la fuente de poder deben ser guiados de tal manera que no sean pisados ni

pellizcados por objetos colocados sobre o contra ellos, poniendo particular atención a los

contactos y receptáculos donde salen del aparato.

THE RGB TO DVI(/VGA) CONVERTER

14. El equipo eléctrico debe ser limpiado únicamente de acuerdo a las recomendaciones del

fabricante.

15. En caso de existir, una antena externa deberá ser localizada lejos de las lineas de energia.

16. El cable de corriente deberá ser desconectado del cuando el equipo no sea usado por un

largo periodo de tiempo.

17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre

la cubierta u orificios de ventilación.

18. Servicio por personal calificado deberá ser provisto cuando:

A: El cable de poder o el contacto ha sido dañado; u

B: Objectos han caído o líquido ha sido derramado dentro del aparato; o

C: El aparato ha sido expuesto a la lluvia; o

D: El aparato parece no operar normalmente o muestra un cambio en su desempeño; o

E: El aparato ha sido tirado o su cubierta ha sido dañada.

SAFETY PRECAUTIONS AND INSTALLATION GUIDELINES

Safety Precautions and Installation Guidelines

To ensure reliable and safe long-term operation, please note the following installation

guidelines:

• Only use in dry, indoor environments.

• The Converter and any power supplies can get warm. Do not locate them in an enclosed

space without any airflow.

• Do not place a power supply directly on top of a unit.

• Do not obstruct a unit’s ventilation holes.

To safeguard against personal injury and avoid possible

damage to equipment or property, please observe the

following:

• Only use power supplies originally supplied with the

product or manufacturer-approved replacements. Do not

attempt to dismantle or repair any power supply. Do not

use a power supply if it appears to be defective or has a

damaged case.

• Connect all power supplies to grounded outlets. In each

case, ensure that the ground connection is maintained

from the outlet socket through to the power supply’s AC

power input.

• Do not attempt to modify or repair this product

THE RGB TO DVI(/VGA) CONVERTER

Contents

1. Quick Setup 10

1.1 Video Input/Output 11

1.2 Command Summary 12

2. Overview 13

2.1 Introduction 13

2.2 Glossary 13

2.3 Features 15

2.4 Product Range 16

2.5 Compatibility 17

2.6 How to Use This Guide 18

3. Installation 19

3.1 Package Contents 19

3.2 Connection Cable Requirements 20

3.3 System Setup 21

3.4 Diagnostic LEDs 23

4. Device Control 24

4.1 Opening the OSD 25

4.2 Using the OSD 27

5. Monitor Setup 36

6. RGB to DVI(/VGA) Converter Setup 37

6.1 Overview 37

6.2 Setup Instructions for RGB Input 38

6.3 Setup of a new Video Mode 40

7. Troubleshooting 42

7.1 Video 42

CONTENTS

Appendix A: Example Applications 44

Appendix B: Rack Mount Options 45

Appendix C: System Upgrade 47

Appendix D: Supported Video Modes 47

Appendix E: Calling Technical Support 50

Appendix F: Specifications 53

Appendix G: Connectors and Cables 54

THE RGB TO DVI(/VGA) CONVERTER

1. Quick Setup

This section briefly describes how to install your RGB to DVI(/VGA) Converter and optimize

the video signals. Unless you are an experienced user, we recommend that you follow the full

procedures described in the rest of this manual. Refer to the command summary on page 12

when following this procedure.

Install system

1. Connect the RGB to DVI(/VGA) Converter to the RGB (video) source.

2. Connect a display to the RGB to DVI(/VGA) Converter.

3. Power up the system.

Carry out the Monitor Setup

procedure (please refer to the

monitor’s manual and see

page 34 in this manual).

Carry out Setup of a new Video Mode procedure

(please follow the instructions on page 38).

Done

Yes

Do you have a

DVI monitor?

Is the RGB video

mode in the list of

supported modes?

(see page 46)

Do you

have a flat screen

(TFT)?

Yes

Inhaltsverzeichnis

Andere Black Box Medienkonverter Handbücher

Black Box

Black Box AC340A Bedienungsanleitung

Black Box

Black Box LMC5207A-R2 Bedienungsanleitung

Black Box

Black Box AC1031A-2 Bedienungsanleitung

Black Box

Black Box LH1709A-SCTS-US Bedienungsanleitung

Black Box

Black Box MicroConverter G.703 Bedienungsanleitung

Black Box

Black Box KVUSB-PS2 Bedienungsanleitung

Black Box

Black Box IC107A-R3 Bedienungsanleitung

Black Box

Black Box VS-2001-ENC Bedienungsanleitung

Black Box

Black Box LPD500A Bedienungsanleitung

Black Box

Black Box AVSWSC-MULTI-HDMI Bedienungsanleitung

Black Box

Black Box MultiLink LB1350A-ST Bedienungsanleitung

Black Box

Black Box LE1605A-ST-US Bedienungsanleitung

Black Box

Black Box IC832A Bedienungsanleitung

Black Box

Black Box IC199A-R4 Bedienungsanleitung

Black Box

Black Box LMC100C-M Bedienungsanleitung

Black Box

Black Box LGC5211A Bedienungsanleitung

Black Box

Black Box IC483AE-R2 Referenzhandbuch

Black Box

Black Box LHC001A Bedienungsanleitung

Black Box

Black Box LBMC300-MMST Bedienungsanleitung

Black Box

Black Box AC500A-R2 Bedienungsanleitung

Black Box

Black Box AC600A Bedienungsanleitung

Black Box

Black Box IEEE 1284 Bedienungsanleitung

Black Box

Black Box LMC5207A Bedienungsanleitung

Black Box

Black Box LH1500A-R3 Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung