Black Box LB9020A-R2 Bedienungsanleitung

Installation

This installation guide gives step-by-step instructions about how to install the Express Plus Ethernet Switches:

LB9020A-R2

Selecting a Site for the Express Ethernet Switch: LB9020A-R2

As with any electric device, you should place the switch where it will not be subjected to extreme temperatures,

humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements:

-The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

-The relative humidity should be less than 90 percent, non-condensing.

-Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3,

Level 2 (3V/M) fieldstrength.

-Make sure that the switch receives adequate ventilation. Do not block the ventilation holes on each side of the

switch or the fan exhaust port on the rear of the switch.

-The power outlet should be within 1.8 meters of the switch.

Connecting to Power

?? Connect the supplied AC power cord to the receptacle on the back of the switch, and then plug it into

a standard AC outlet with a voltage range from 100 to 260 Vac.

Figure: Rear view of the switch

Connecting to Your Network

Cabling

?? First, ensure the power of the switch and end devices is turned off.

<NOTE> Always ensure that the power is off before any installation.

?? Prepare cable with corresponding connectors for each type of port in use.

?? Consult Table 2 below for cabling requirements based on connectors and speed.

?? Connect one end of the cable to the switch and the other end to a desired PC or workstation.

?? Once the connections between two end devices are made successfully, turn on the power and the

switch is operational.

Receptacle

Cable Length

The maximum distance of a node to a directly connected switch on a 100BASE-TX network is 100 meters with

Category 5 shielded twisted-pair (STP) cable or unshielded twisted-pair (UTP) cable. For a 10BASE-T network, it

may range up to 100 meters with Category 3, 4, or 5 STP/UTP cable.

The maximum segment distance between a node and a directly connected switch port on a 100BASE-FX network is

75 km using 10/125(or 9/125)µm single-mode fiber optic cable. It is capable of spanning at most 2 kilometers when

use of 62.5/125(or 50/125)µmmulti-mode fiber-optic cable.

Table: Cable Specifications Ethernet

Standards Connector Port

Speed

Half/Full

Duplex

Cable Max.

Distance

10BASE-TRJ-45 10/20

Mbps Cat. 3, 4 or 5

UTP/STP 100 m

100BASE-TX

RJ-45 100/200

Mbps Cat. 5

UTP/STP 100 m

CUSTOMER Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

SUPPORT FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

INFORMATION Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web Site: www.blackbox.com ?E-mail: [email protected]

Andere Handbücher für LB9020A-R2

Inhaltsverzeichnis

Andere Black Box Schalten Handbücher

Black Box

Black Box ServSwitch KV9612A Bedienungsanleitung

Black Box

Black Box IC265A Bedienungsanleitung

Black Box

Black Box AVSW-DVI8X1 Bedienungsanleitung

Black Box

Black Box SW111A Bedienungsanleitung

Black Box

Black Box LB005A Bedienungsanleitung

Black Box

Black Box LGB2118A-R2 Benutzerhandbuch

Black Box

Black Box LIG401A Bedienungsanleitung

Black Box

Black Box ME500A Bedienungsanleitung

Black Box

Black Box KV130A Bedienungsanleitung

Black Box

Black Box USB Single-Port Hub IC266A Bedienungsanleitung

Black Box

Black Box LB9002A-SC-R3 Bedienungsanleitung

Black Box

Black Box LGS103AE Bedienungsanleitung

Black Box

Black Box SW214A Bedienungsanleitung

Black Box

Black Box AVS-HDMI2-8X8 Bedienungsanleitung

Black Box

Black Box LEV2525A Sicherheitsleitfaden

Black Box

Black Box AVSW-DVI4X1 Bedienungsanleitung

Black Box

Black Box ServSwitch DT Pro II KV7020A Bedienungsanleitung

Black Box

Black Box LPH3061A Bedienungsanleitung

Black Box

Black Box SS2P-SH-HDMI-U Bedienungsanleitung

Black Box

Black Box KV1044A-R2 Bedienungsanleitung

Black Box

Black Box LB9020A Bedienungsanleitung

Black Box

Black Box ServSwitch SW2007A-USB Bedienungsanleitung

Black Box

Black Box SWI069A Bedienungsanleitung

Black Box

Black Box LGB1152A Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung

Cabletron Systems

Cabletron Systems GIGAswitch GSR-16 Bedienungsanleitung

Cisco

Cisco Catalyst X4448 Handbuch