2. Local System Time Setting
Press when in the standby mode , press to choose the hour , to choose the minute ;
lastly , press to save the setting .
3.To view the lamp's working temperature .
Double press when in the standby mode .
4. Memory Function
The control module automatically saves settings if no signal is received after 45 seconds.
If the power was cut off during the operation , the lamp will return to the original setting next time.
5. Multiple Linking Function
The ID No.of the lamp is , and the remote controller is acquiescently to control all the lights with ID No.
, that is to say the remote controller controls multiple units .
If single unit controlled is required , please operate as following :
To set every fixture with a different ID .
Press t twice , then the temperature shown on the screen , click , the previous ID shown
on the screen press to select a new ID No. , i.e ,
Please notice that the new ID cannot be and not the same as ID which others have . Press to
done the ID setting .
To unlock remote controller .
Click the button , it will turn to (this is your ID ) , then click the again , turn to ,
press the until the shown on the screen , at the end click , the remote controller
will work , but the ID still is
Notice: the remote will be locked out after 1 minute of no operation.
