Maximum Air Pressure
Air Consumption
Air Inlet
Maximum RPM
90PSI Recommended
90PSI
¼”
22000 RPM
Please make sure that you read these instructions carefully in order to avoid injury when
using the BlueSpot 15 PCE Air Die Grinder Set. Follow all health and safety rules and
regulations. If in doubt and available please contact a more knowledgeable source.
DO NOT use if damaged.
• ALWAYS ensure you have read through all of the instructions and fully understand how
to operate the tool before beginning.
• ALWAYS check the air die grinder set for any damage before use. Any damage found
needs to be repaired or replaced before use to prevent damage to property or personal
injury.
• ALWAYS check the air hose for any damage before use. Any damage found needs to be
repaired or replaced before use to prevent damage to property or personal injury.
• ALWAYS dress appropriately – clothing should be close fitted and long hair tied back.
Jewellery should be removed and shoes should be worn with a non-slip sole.
• ALWAYS wear the correct PPE equipment. Approved eye protection should always
be worn.
• ALWAYS ensure you work in a well ventilated room.
• ALWAYS check for missing or damaged parts before use.
• Maintain tool in good and clean condition for best and safest performance.
• Keep the work area clean, uncluttered and ensure there is adequate lighting.
• Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip
shoes.
• Keep children and unauthorised persons away from the work area.
• ALWAYS ensure the trigger is off before connecting the tool to the air supply.
• ALWAYS ensure any adjusting keys or wrenches have been removed before turning the
tool on.
• ALWAYS ensure your workpiece is secure before operation.
02
The BlueSpot 15 PCE Air Die Grinder Set is ideal for grinding and polishing a range of
materials. The set comprises: 1x mini air die grinder, 2 x hand wrenches, 1 x 3mm (1/8")
collet, 5 x 1/4"(6mm) shank grinding stones, 5 x 3/8"(3mm) shank grinding stones, 1 x
nipple.The set is supplied in a useful, blow molded, plastic carry case.
Safe use (continued)
• ALWAYS ensure the air hose has been disconnected from the tool correctly before
making any adjustments, changing accessories or storing the tool. Squeeze the lever to
release all the compressed air in the tool.
• ALWAYS ensure that clean, dry, regulated, compressed air is used at 90PSI. Do not
exceed 90PSI as this can be very dangerous.
• BE AWARE that before connecting the tool to the air supply air tool oil should be added
into the air inlet fitting of the die grinder before each use.
• ALWAYS store the air die grinder set away correctly when not in use.
• DO NOT allow untrained persons to use the kit.
• DO NOT operate the tool if you are tired as this could be dangerous.
• NEVER operate the tool if you are under the influence of drugs or alcohol as this
is dangerous.
• DO NOT make modifications to the air die grinder set.
• NEVER use the air die grinder set to perform a task it was not designed to do.
• NEVER use oxygen, carbon dioxide, combustible gases or other bottled gas with the
tool.
• ALWAYS stop using the tool straight away if you start to experience discomfort or pain.
Consult with a qualified health professional if needed.
• If the Air Die Grinder Set is damaged do not use.
Introduction
Specification
