BOMBARDIER 861 7522 00 Bedienungsanleitung

Lithod in Canada (MSI9612PRM)

®*Trademarks of Bombardier Inc.

415 0102 00 PAGE 1 OF 3

Snowmobiles

WARNING : For safety reasons, this kit must be installed by an authorized Bombardier Ski-Doo

snowmobile dealer. Should removal of a locking device be required when undergoing disassem-

bly/assembly, always replace with a new one. This instruction sheet should be given to the purchaser

after modification. This kit is designed for specific applicable models only. It is not recommended for

snowmobiles other than those for which it was sold.

NOTE : Installation time is approximately 1.0 hour.

PARTS TO BE INSTALLED

1. Rail, Right Side

2. Rail, Left Side

3. Sliding Plate (2)

4. Backrest Frame

5. Cushion

6. Adjustable Knob (4)

7. Mounting Hardware (Bag containing Bolts,

Washers, Nuts and Wood Screws)

;

A01H11S

FASTENER

KIT

ADJUSTABLE BACKREST KIT

(P/N 861 7522 00)

PAGE 2 OF 3 415 0102 00

PREPARATION

Tools Required

 Measuring tape

 Drill

 6.5 mm (1/4 in) drill bit

 Robertson screwdriver no. 3 (black, square tip)

 10 mm (3/8 in) and 11 mm (7/16 in) wrenches

or sockets with 30 mm (12 in) extension and

ratchet.

INSTALLATION

Remove seat from vehicle.

Lean rail no. 1 on tunnel so that the back of the

steel angle is flush with edge of tunnel.

1. Slide of rail higher than tunnel

2. Flush with edge of tunnel

Install rail so that the slots align with those that

are on the tunnel.

Hold rail firmly and using a punch, mark the slots

on the tunnel for drilling references.

Using rail as a template, drill holes in frame with a

6.5 mm (1/4 in) drill bit.

CAUTION : When drilling, align the drill

bit in the center of the slot and at the outer

edge to allow proper adjustment.

WARNING : Be careful not to drill heat ex-

changers underneath frame.

Install rail with mounting hardware no. 7. Insert

bolts from top and then washers and nuts from

beneath.

NOTE : Wood screws from the mounting

hardware bag will be used later in the instal-

lation.

Use the ratchet and extension for easy access be-

neath the tunnel. Tighten the nuts loosely for now.

Repeat procedure for the other side using left

hand rail no. 2.

Reinstall seat (do not tighten) to adjust the rail dis-

tance accordingly.

Insert the sliding plates no. 3 into the rails, the

backrest frame no. 4 onto rails and install the ad-

justable knobs no. 6. Tighten knobs loosely.

Slide the backrest frame forward and back to as-

sure the rails are parallel and that the frame move-

ment is unobstructed.

Remove seat and tighten the bolts on each rail.

Slide the backrest frame forward and back again

to assure easy movement.

IMPORTANT: Adjust backrest width prior to in-

stalling cushion.

NOTE : If the luggage rack and the backrest

are to be installed at the same time, proceed

with rack installation before installing cushion.

Position the cushion no. 5 on the backrest frame

so that it is centered both from side to side and

top to bottom.

NOTE : Make sure to keep at least 16 mm(5/

8 in) on top so that if a luggage rack is in-

stalled, the top of the cushion will be flush with

the top of the racks transverse bar.

Secure cushion with wood screws no. 7.

Apply a light coat of grease on sliding surface of

rails.

Adjust backrest to desired position and tighten ad-

justement knobs.

Reinstall seat.

WARNING : Periodically check the adjust-

ment knobs to assure that they are tight.

A01H0XA

;

415 0102 00 PAGE 3 OF 3

LUGGAGE RACK KIT

Parts Included in Kit

1. Luggage Rack

2. Screw 1/4 x 1-3/4 in (2)

3. Washer 1/4 x 3/4 in (10)

4. Nut 1/4 in (8)

5. Carriage Bolt 1/4 x 1-1/2 (2)

6. Screw 1/4 x 1-1/2 in (2)

7. Cap (4)

8. Hooking Channel

Tools Required

 Drill

 6.5 mm (1/4 in) drill bit

 Robertson (square tip) screwdriver no.3 (black)

 11 mm (7/16 in) wrench or socket with ratchet

INSTALLATION PROCEDURE

Drill all holes with a 6.5 mm (1/4 in) drill bit. Use

rack holes as guide.

Remove cushion from backrest.

CAUTION : Cushion must be removed for

drilling operation.

Install luggage rack no. 1 over backrest.

Center rack hooking channel. Use top holes of

cushion retaining screw as a guide.

Drill holes in top of backrest cross bar.

Install 44.5 mm (1-3/4 in) screws no. 2 and nuts

no. 4. Install a washer no. 3 on each end of

screws.

Drill holes in center of backrest crossbar through

flat bar slots of rack.

Secure with carriage bolts no. 5, positioning head

of bolts on cushion side.

Drill holes on side of backrest.

Secure with screws no. 6.

Push caps no. 7 over holes of rack side members.

Reinstall cushion.

A01H0YA

415 0102 00

861 7522 00

1. 415 0100 00 Rail, Right Side Rail (côté droit)

2. 415 0101 00 Rail, Left Side Rail (côté droit)

3. 414 7359 00 Sliding Plate (2) Plaque coulissante (2)

4. 414 7360 00 Backrest Frame Châssis de dossier

5. 414 7361 00 Cushion Coussin

6. 414 7183 00 Adjustable Knob (4) Bouton réglable (4)

7. 414 7362 00 Mounting Hardware (Bag containing

Bolts, Washers, Nuts and Wood

Screws)

Dispositifs de fixation (sac contenant

les boulons, les rondelles, les écrous

et les vis à bois)

Andere BOMBARDIER Schneemobil Handbücher

BOMBARDIER

BOMBARDIER ski-doo Nordic 640ER 1973 Bedienungsanleitung

BOMBARDIER

BOMBARDIER Ski-doo MX ZX 440 Handbuch

BOMBARDIER

BOMBARDIER ski-doo BLIZZARD 298 1981 Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo Elite 1973 Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo T'NT FAN COOL 300 SM 1974 Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo OLYMPIQUE 1975 Bedienungsanleitung

BOMBARDIER

BOMBARDIER Safari 377 1988 Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo Alpine 1972 Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo T'NT F/A 340 1973 Bedienungsanleitung

BOMBARDIER

BOMBARDIER Alpine 1984 Series Bedienungsanleitung

BOMBARDIER

BOMBARDIER Blizzard MX 1981 Bedienungsanleitung

BOMBARDIER

BOMBARDIER Ski-Doo MX Z X 440 2004 Handbuch

BOMBARDIER

BOMBARDIER ski-doo Tundra Scandic 2004 Series Installationsanleitung

BOMBARDIER

BOMBARDIER ski-doo RV 340 L/C 1977 Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo MX Z X 440 2001 Betriebsanleitung

BOMBARDIER

BOMBARDIER ski-doo SAFARI CITATION 1990 Bedienungsanleitung

BOMBARDIER

BOMBARDIER formula Plus 1987 Bedienungsanleitung

BOMBARDIER

BOMBARDIER Skandic R 1987 Bedienungsanleitung

BOMBARDIER

BOMBARDIER Alpine 1987 Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo Elite 1974 Bedienungsanleitung

BOMBARDIER

BOMBARDIER 1983 Elan Installationsanleitung

BOMBARDIER

BOMBARDIER ski-doo elan 250 1980 Bedienungsanleitung

BOMBARDIER

BOMBARDIER ski-doo All Summit Series Referenzhandbuch

BOMBARDIER

BOMBARDIER EVEREST Bedienungsanleitung

Beliebte Schneemobil Handbücher anderer Marken

BRP

BRP Ski-Doo MXZ 120 2023 Bedienungsanleitung

Arctic Cat

Arctic Cat ZR 900 Series 2006 Bedienungsanleitung

Arctic Cat

Arctic Cat Wildcat EFI Mountain Cat 1994 Bedienungsanleitung

Ski-Doo

Ski-Doo Formula Plus 1985 Bedienungsanleitung

Arctic Cat

Arctic Cat Cougar Bedienungsanleitung

Yamaha

Yamaha SnoScoot SXR2NJ Bedienungsanleitung

Yamaha

Yamaha VX500XTB Bedienungsanleitung

Yamaha

Yamaha RS VENTURE 2014 Bedienungsanleitung

Polaris

Polaris RMK Shift Bedienungsanleitung

Yamaha

Yamaha VK540EF Bedienungsanleitung

Ski-Doo

Ski-Doo 1982 Elite Bedienungsanleitung

Yamaha

Yamaha VK540EF Bedienungsanleitung

Yamaha

Yamaha SXV4NP Bedienungsanleitung

Ski-Doo

Ski-Doo MX Bedienungsanleitung

Ohlins

Ohlins PB 616 Bedienungsanleitung

Ski-Doo

Ski-Doo Blizzard 5500 1979 Bedienungsanleitung

Polaris

Polaris 600 RUSH 2013 Leitfaden

Polaris

Polaris 600 INDY VOYAGEUR Bedienungsanleitung