Bosch NDA-FMT-DOME Bedienungsanleitung

In-ceiling mount

NDA-FMT-DOME

en Installation manual

Table of contents

1Safety 4

1.1 Safety message explanation 4

2Installation Overview 5

3Installing a Recessed Mount 6

3.1 Overview 6

3.2 Installing the Recessed Mount 6

3.3 Installing the Camera to the Recess Mount 10

4Technical data 11

In-ceiling mount Table of Contents | en 3

Bosch Security Systems 2014.08 | v1.0 | AM18-Q0679

Safety

Before installing, please read this manual carefully.

Safety message explanation

Caution!

Indicates a hazardous situation which, if not avoided, could

result in minor or moderate injury.

Notice!

Indicates a situation which, if not avoided, could result in

damage to the equipment or environment, or data loss.

Caution!

Installation should only be performed by qualified service

personnel in accordance with the National Electrical Code

(NEC 800 CEC Section 60) or applicable local codes.

1.1

4en | Safety In-ceiling mount

2014.08 | v1.0 | AM18-Q0679 Bosch Security Systems

Installation Overview

This equipment should be unpacked and handled with care. If an

item appears to have been damaged in shipment, notify the

shipper immediately.

Verify that all parts are included. If any items are missing, notify

your Bosch Security Systems Sales or Customer Service

Representative.

The original packaging is the safest container in which to

transport the unit and can be used if returning the unit for

service.

The following parts are included:

Quantity Part

1 In-ceiling mount: NDA-FMT-DOME

1 White trim ring A (inner diameter: 102 mm) with

two M3 captive screws

1 White trim ring B (inner diameter: 98 mm) with

two M3 captive screws

4 Four M4 x 6 mm screws

4 Four M4 x 15 mm screws

1 Security Torx T-10 L wrench

1 Installation manual (this booklet)

In-ceiling mount Installation Overview | en 5

Bosch Security Systems 2014.08 | v1.0 | AM18-Q0679

Installing a Recessed Mount

Overview

The mount is supplied with two different trim rings and different

tooling hole positions on the sides of the recess mount. Use the

trim ring and hole position best suited for your camera.

Installing the Recessed Mount

Notice!

The recessed mounting bracket is provided with an additional

safety tether point. To prevent injury, attach a safety wire from

a secure anchor point above the ceiling to this tether point.

To mount to a recess mount, do the following:

1. Determine a secure location for the recessed mount.

96 (3.78)

194 (7.64)

55.1 (2.17)

Figure 3.1: Recess Mount Dimensions

2. Drill or cut a 7 in. hole with a tolerance of ±1/8 in. (177.8

±2.2 mm).

3.1

3.2

6en | Installing a Recessed Mount In-ceiling mount

2014.08 | v1.0 | AM18-Q0679 Bosch Security Systems

3. Optional: if installing the camera to a suspended ceiling tile

or any other surface where additional support is required,

the VGA-IC-SP mounting kit (sold separately) is

recommended. See the instruction book supplied with the

mounting bracket for installation instructions.

Figure 3.2: Mounting bracket

4. Ensure that the clamping plates are angled inward by

pushing up and into the two slots.

5. Insert mount through the hole and into the ceiling. Slide

clamps out and down so that the drywall is clamped in

between the clamps and the bracket flange, 41.7 mm (1.64

in.) maximum ceiling thickness and 9.7 mm (0.38 in.)

minimum ceiling thickness).

In-ceiling mount Installing a Recessed Mount | en 7

Bosch Security Systems 2014.08 | v1.0 | AM18-Q0679

Figure 3.3: Attach Recess Mount to Ceiling

Figure 3.4: Clamp Recess Mount

6. Tighten both clamps to the ceiling using supplied screws

and a #2 Phillips screwdriver.

8en | Installing a Recessed Mount In-ceiling mount

2014.08 | v1.0 | AM18-Q0679 Bosch Security Systems

Figure 3.5: Tighten Mounting Clamps

Notice!

Over tightening the ceiling clamps can damage the clamp or

ceiling. Only tighten the clamp until it contacts the ceiling and

you start to feel some resistance. If using a power screwdriver,

set the torque level to the lowest setting.

In-ceiling mount Installing a Recessed Mount | en 9

Bosch Security Systems 2014.08 | v1.0 | AM18-Q0679

Installing the Camera to the Recess Mount

To install the camera to the recess mount, follow these steps:

Caution!

All wires for installation applications must be routed through a

grounded conduit.

1. Route wires through the crescent shaped cut-out on the

side of mounting plate.

2. Connect the cables according to the instructions in the

installation guide.

3. Remove the outer housing from the camera (use the

wrench supplied with the camera).

4. Attach the camera base to the recessed mount using the

M4 x 15 mm mounting screws. Ensure that the cable is

aligned with the cutout in the recess mount.

5. Reattach the camera the outer housing.

6. Align the mounting screws of the trim ring with the

mounting holes in the recess mount.

7. Use the supplied T-10 Torx wrench to secure the trim ring’s

safety locking screws to the mounting bracket.

3.3

10 en | Installing a Recessed Mount In-ceiling mount

2014.08 | v1.0 | AM18-Q0679 Bosch Security Systems

Inhaltsverzeichnis

Andere Bosch Rack & Stand Handbücher

Bosch

Bosch FLEXIDOME NDA-FMT-MICDOME Bedienungsanleitung

Bosch

Bosch PTA 1 Bedienungsanleitung

Bosch

Bosch T10031 Bedienungsanleitung

Bosch

Bosch ISN-GMX-W0 Bedienungsanleitung

Bosch

Bosch Professional GTA 6000 Bedienungsanleitung

Bosch

Bosch GTA 2600 Professional Bedienungsanleitung

Bosch

Bosch S 500 A PROFESSIONAL Bedienungsanleitung

Bosch

Bosch GTA 600 Professional Betriebsanleitung

Bosch

Bosch PTA1000 Bedienungsanleitung

Bosch

Bosch GCR 350 Bedienungsanleitung

Bosch

Bosch GTA 2500 W Professional Bedienungsanleitung

Bosch

Bosch FBH 0000 A Bedienungsanleitung

Bosch

Bosch FPM-5000-KMC Bedienungsanleitung

Bosch

Bosch GTA 2500 W Professional Bedienungsanleitung

Bosch

Bosch GTA 2500 W Professional Bedienungsanleitung

Bosch

Bosch B12 Bedienungsanleitung

Bosch

Bosch B12 Bedienungsanleitung

Bosch

Bosch FMH 0000 A Bedienungsanleitung

Bosch

Bosch GTA500 Montageanleitung

Bosch

Bosch PTA 2400 Bedienungsanleitung

Bosch

Bosch UMM-LW-20B Installationsanleitung

Bosch

Bosch 303-435 Bedienungsanleitung

Bosch

Bosch S 500 A PROFESSIONAL Bedienungsanleitung

Bosch

Bosch TS1017 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung