Bosch EX14 Series Bedienungsanleitung

EX14/14N

All Environment Camera

INSTALLATION INSTRUCTION

MAN-14-04

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep this instruction.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in

accordance with manufacturer instructions.

8. Do not install near any heat sources such as

radiators, heat registers, stoves or other apparatus

(including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or

grounding-type plug. A polarized plug has two

blades with one wider than the other. A grounding

type plug has two blades and a third grounding

prong. The wide blade or the third prong is

provided for your safety. If the provided plug does

not fit into your outlet, consult an electrician for

replacement of the obsolete outlet.

10. Protect the power cord from being walked on or

pinched particularly at plugs, convenience

receptacles, and the power where they exit from the

apparatus.

11. Only use attachments/accessories specified by the

manufacturer.

12. Use only with the cart, stand, tripod, bracket, or

table specified by the manufacturer, or sold with the

apparatus. When a cart is used, use caution when

moving the cart/apparatus combination to avoid

injury from tip-over.

13. Unplug this apparatus during lightning storms or

when unused for long periods of time.

14. Refer all servicing to qualified service personnel.

Servicing is required when the apparatus has been

damaged in a way, such as power-supply cord or

plug is damaged, liquid has been spilled or objects

have fallen into the apparatus, the apparatus has

been exposed to rain or moisture, does not operate

normally, or has been dropped.

IMPORTANT

For best results, please read this Instruction Booklet prior to

installing the EX14 camera.

WARNING!

CSA Certified / UL Listed CLASS 2 power adaptors must be

used in order to comply with electrical safety standards.

Only qualified personnel shall install any

surveillance product.

Bosch Security Systems, Inc. will not be responsible for

injuries or damages resulting from the

improper installation or use of any product

sold by Bosch Security Systems, Inc their agents,

distributors or dealers.

EU Directives covered by this declaration:

72/9/EC Low Voltage Directives

89/336/EEC Electromagnetic Compatibility Directive

NOTE: This equipment has been tested and found to comply

with the limits for a digital device, pursuant to part 15 of the

FCC rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. As part of its’ normal operation this device can

generate radio frequency energy and if not installed and

used in accordance with the installation manual may cause

interference to radio communications. However, there is no

guarantee that interference will not occur on a particular

installation. If the device does cause interference to radio or

television reception the user is encouraged to try to correct

the interference by one or more of the following measures:

1) Fit Ferrite beads on all cable to and from the power

supply box, within the box walls.

2) Route the composite cable between the camera and the

power supply in steel conduit piping over the entire run of the

cable up to and including connection to a deep conduit base

fitted under the camera and a conduit fitting adaptor in the

wall of the PSU box.

3) Contact BOSCH Service Center for further advice.

INDEX – EX14/14N

Page

Description...................................................1

Unpacking....................................................2

Parts List......................................................2

Items Required for Installation.....................2

Initial Preparations.......................................3

Guidelines....................................................3

Section 1. Camera Mounting.......................4

Section 2. Camera I/O Connections............9

Section 3. Input Power Connections………10

Section 4. Camera/LED Adjustments........12

Section 5. Troubleshooting Guide.............15

Section 6. General Specifications..............18

DESCRIPTION

The EX14 All Environment Camera consists of a two-

piece injection molded watertight housing with a tough

polycarbonate viewing window. This compact camera

meets IP66 ratings for applications wherever

environmentally sealed CCD cameras are required. The

camera is especially suited for wash down applications

in food processing and industrial clean-room

installations.

The EX14 can be ordered in monochrome or color

versions, featuring varifocal and auto-iris IR-optimized

lenses. A rigid nylon mounting bracket is also included

with the camera.

A voltage regulator circuit allows for 12V dc or 24V ac

operation and a range in between. It also provides

protection from voltage surge, transient spikes, and

reverse voltage.

The EX14N comes with integrated Infra-Red illumination

to permit imaging in 0 Lux conditions

The EX14 is available in several models to meet

individual requirements or specific needs.

See the Light. Get the Picture.™

UNPACKING

Care should be taken when unpacking the shipped unit.

Check the parts list and confirm all items have been located.

Inspect the equipment thoroughly to ensure nothing was

damaged in transit.

Contact BOSCH Service Center if a problem is noted,

see the rear page of this booklet for contact numbers.

PARTS LIST (items supplied with unit)

•EX14 Camera or EX14N integrated infraRed

•Two Allen Keys

•One Mounting Bolt

•Nylon Mounting Bracket(supplied with camera)

•Installation Instructions booklet

ITEMS REQUIRED FOR INSTALLATION

(not supplied with unit)

•mounting hardware & tools

INITIAL PREPARATIONS

•The camera’s voltage regulator board

(VRB) accepts an input voltage of either

12Vdc or 24Vac, and a range in-between,

from a regulated power supply.

•The VRB automatically switches between

ac or dc inputs, therefore no internal wiring

changes are necessary to accommodate

these input voltages.

•Determine the optimum location for the

camera.

Section 1: Camera Mounting

•All cameras have been tested prior to

shipment.

GUIDELINES

The installation of the EX14 Camera is shown in

Sections 1 to 4 listed below.

It is important that these steps are followed in

sequence:

1. Camera Mounting

2. Camera I/O Connections

3. Input Power Connections

4. Camera/LED Array Adjustments

1. CAMERA MOUNTING

Caution: Install the mounting bracket with the

appropriate screws or drywall anchors to suit the

mounting surface. Select a suitable location that is

protected from accidental damage or tampering, and

environmental conditions that could exceed the

camera’s general specifications.

See page 18.

Caution: Ensure the selected location is protected from

falling objects, accidental contact with moving objects,

and unintentional interference from personnel. Follow

all applicable building codes.

The following installation guidelines

must be followed:

•Locate the camera such that it cannot be easily

interfered with, either intentionally or accidentally.

•Select a mounting surface capable of supporting

the combined weight of the camera and its

mounting hardware under all expected conditions of

vibration and temperature.

•Secure all cabling.

Andere Handbücher für EX14 Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Bosch Sicherheitskamera Handbücher

Bosch

Bosch Autodome Inteox 7000i-2MP Bedienungsanleitung

Bosch

Bosch EX7 Bedienungsanleitung

Bosch

Bosch EX70MX404-N Bedienungsanleitung

Bosch

Bosch VDC-275 Bedienungsanleitung

Bosch

Bosch FlexiDome NDC-455V03-21P Bedienungsanleitung

Bosch

Bosch DINION IP thermal 8000 Bedienungsanleitung

Bosch

Bosch EX36 Bedienungsanleitung

Bosch

Bosch FLEXIDOME IP indoor 5000 Bedienungsanleitung

Bosch

Bosch VTC-206 Series Bedienungsanleitung

Bosch

Bosch DINION IP starlight 7000 HD Bedienungsanleitung

Bosch

Bosch SVI-1609-5 Bedienungsanleitung

Bosch

Bosch MIC Series 400 Bedienungsanleitung

Bosch

Bosch VEN-650V05-2A3 Bedienungsanleitung

Bosch

Bosch NBN-733 Bedienungsanleitung

Bosch

Bosch NBN-498 Bedienungsanleitung

Bosch

Bosch EX49 Bedienungsanleitung

Bosch

Bosch VDI-240V03-2 Bedienungsanleitung

Bosch

Bosch VBC?265 Series Bedienungsanleitung

Bosch

Bosch DinionHD NBN-832-38W Bedienungsanleitung

Bosch

Bosch LTC 0x35 Series Bedienungsanleitung

Bosch

Bosch DINION IP imager 9000 HD Bedienungsanleitung

Bosch

Bosch WZ14 Bedienungsanleitung

Bosch

Bosch VG5 800 SERIES Bedienungsanleitung

Bosch

Bosch AutoDome Bedienungsanleitung

Beliebte Sicherheitskamera Handbücher anderer Marken

Okina USA

Okina USA SIR36-870VF650LP Bedienungsanleitung

Divio

Divio NDR155PA Bedienungsanleitung

Canon

Canon VB-C500D Bedienungsanleitung

Easy Access

Easy Access EasyGuard Bedienungsanleitung

Vivotek

Vivotek FD9389-EHV-v2 Bedienungsanleitung

TUYA

TUYA COSMO W2 Bedienungsanleitung

Eusso

Eusso UNC7500-IR Einrichtungshandbuch

urmet domus

urmet domus 1096/204 Bedienungsanleitung

VC VC20 series Bedienungsanleitung

Axis

Axis Q1614 Bedienungsanleitung

ieGeek

ieGeek DD201 Bedienungsanleitung

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Bedienungsanleitung

Vicon

Vicon V662-D-1 Betriebsanleitung

Grundig

Grundig GCH-K0274P Bedienungsanleitung

Lorex

Lorex VANTAGE LBC7032 Bedienungsanleitung

4xem

4xem WPT Bedienungsanleitung

Samsung

Samsung SCV-3082 Bedienungsanleitung

Vitek

Vitek VTC-C544 Bedienungsanleitung