Bosch Plena PLE-1CS Referenzhandbuch

Plena Call Station

Quick Reference Card

PLE-1CS

Guide de Référence Rapide

PLE-1CSfr

Kurzanleitung

PLE-1CS

Beknopte Handleiding

PLE-1CS

Guía de Referencia Rápida

PLE-1CS

Guida Rapida

PLE-1CS

Quick Reference Card

PLE-1CS

Bosch Security Systems | 2007-10 | PLE-2MA120-EU, PLE-2MA240-EU en

Plena Mixer Amplifier | Installation and User Instructions | Connections and settings en | 16

4.1.2 Priority microphone (input 1)

The priority microphone (or a generic call station) that

can be used with push to talk (PTT) should be

connected to “microphone/line 1 input”. The PTT

mode can be activated by setting the DIP switch (4) at

the rear of the unit. Microphone/line 1 input has

priority over all other microphone/line inputs.

If, however, the “Tel. emergency/100V input” receives a

signal, all inputs including microphone/line 1 input will

be overruled.

The microphone/line 1 input has two connectors wired

in parallel:

• an XLR connector (for a 3 pole microphone), and

• a Euro style pluggable screw terminal connector.

The Euro style pluggable screw terminal connector has

a trigger input, which can be used in combination with

the Euro and XLR connector.

The priority microphone can be connected to the

microphone/line 1 input as follows:

• XLR connector only. See figure 4.2.

• XLR connector with trigger. See figure 4.3.

• Euro connector with trigger. See figure 4.4.

• Euro connector only (without trigger).

Set the DIP switch settings next to the XLR connector

for microphone/line 1, as required. See section 4.3.

Note

If a microphone is connected to both the

XLR connector and the Euro connector for the

microphone/line 1 input, the input signals will be

added together.

Note

When connecting an unbalanced line level

(200 mV) signal to the microphone/line input,

connect it as follows: Signal to pin 2, pin 1 and

pin 3 to ground.

figure 4.2: XLR connector only

figure 4.3: XLR connector with trigger

figure 4.4: Euro connector with trigger

Installation/configuration notes

S2S3

1 2 3 4 5

Circuit diagram

Parts included

Quantit

Component

1PLE-1CS PLENA All Call Call Station

Technical specifications

Electrical

Phantom power supply

Voltage range 12 to 48 V

Current consumption <8 mA

Performance

Sensitivity 0.7 mV @ 85 dB SPL (2 mV/Pa)

Maximum input sound level 110 dB SPL

Distortion <0.6% (maximum input)

Input noise level (equiv.) 28 dB SPLA (S/N 66 dBA ref. 1 Pa)

Frequency response 100 Hz to 16 kHz

Output impedance 200 ohm

Mechanical

Base dimensions (H x W x D) 40 x 100 x 235 mm

(1.57 x 3.97 x 9.25 in)

Weight Approx. 1 kg (2.2 lb)

Color Charcoal with silver

Stem length with mic. 390 mm (15.35 in)

Cable length 2 m (6.56 ft)

Environmental

Operating temperature -10 ºC to +45 ºC (14 ºF to +113 ºF)

Storage temperature -40 ºC to +70 ºC (-40 ºF to

+158 ºF)

Relative humidity <95%

Ordering information

PLE‑1CS Plena All‑Call Call Station

All-zone call station with 2 m cable and lockable Euro

style connector.

Order number PLE-1CS

2 | PLE‑1CS Plena All‑Call Call Station

Inhaltsverzeichnis

Andere Bosch Sicherheitssystem Handbücher

Bosch

Bosch AMAX 2100 Gebrauchsanweisung

Bosch

Bosch ISN-SM-30 Benutzerhandbuch

Bosch

Bosch AMAX panel 2100 Bedienungsanleitung

Bosch

Bosch D420 Bedienungsanleitung

Bosch

Bosch ICP-AMAX4-P2-EN Bedienungsanleitung

Bosch

Bosch Solution 16i Bedienungsanleitung

Bosch

Bosch Carephone 61 Bedienungsanleitung

Bosch

Bosch Security System Bedienungsanleitung

Bosch

Bosch AMAX 2100 Bedienungsanleitung

Bosch

Bosch AMAX 2100 Gebrauchsanweisung

Bosch

Bosch SM120RW Bedienungsanleitung

Bosch

Bosch HSG9483 Series Bedienungsanleitung

Bosch

Bosch DIVAR IP all-in-one 7000 3U Bedienungsanleitung

Bosch

Bosch AMAX panel 4000 Bedienungsanleitung

Bosch

Bosch SE 320 LSNi Bedienungsanleitung

Bosch

Bosch Plena Power Amplifier Bedienungsanleitung

Bosch

Bosch CC880/LP880, SC8016 Handbuch

Bosch

Bosch Solution 6000-IP CC615GWF Bedienungsanleitung

Bosch

Bosch Plena Power Amplifier Montageanleitung

Bosch

Bosch CM705B Anleitung zur Verwendung

Bosch

Bosch Solution 16plus Bedienungsanleitung

Bosch

Bosch TC2073 Bedienungsanleitung

Bosch

Bosch IUI-MAP0001 Bedienungsanleitung

Bosch

Bosch AMC UL1 Bedienungsanleitung

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

CADDX

CADDX NX-6 Bedienungsanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

Blaupunkt

Blaupunkt SA 2700 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Highway Safety Group

Highway Safety Group EA401 Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung