(iii) FCC ID of all transmitters, maximum average conducted output power in each
transmission mode and frequency band, operating configurations and exposure
conditions approved for the individual transmitters.
(iv) The type and physical dimensions of antennas incorporated in the intended host
configurations
(v) Antenna gain specified by the antenna manufacturer for antennas qualified for mobile
exposure conditions
(vi) other relevant information and restrictions required by the equipment certifications of
individual transmitters, including antenna changes
For each simultaneous transmission configuration identified in 5.I, if the conditions in a) or b) below
are satisfied and fully documented in the SAR report or Class I permissive change documentation,
simultaneous transmission SAR evaluation is not required for that configuration
a) When the [(Σof the highest measured 1-g SAR for each portable transmitter/antenna included
in the simultaneous transmission configuration) / 1.6 W/kg] + Σof [(the highest MPE for each
mobile transmitter/antenna included in the simultaneous transmission configuration) / (the
corresponding MPE limit)] < 1; or
b) For antennas included in the simultaneous transmission configuration that require SAR
evaluation, when the separation distance between each antenna pair is greater than 5 · [(SAR1 +
SAR2) / 1.6]1.5 cm, rounded to the nearest cm, and the Σof [(the highest MPE for each mobile
transmitter/antenna included in the simultaneous transmission configuration) / (the
corresponding MPE limit)] < 1
Where: Σin a) excludes antennas that do not require SAR evaluation, and MPE does not apply to
displays < 10” diagonal for both a) and b)
(Above simultaneous assessment guideline can be found at FCC web site under KDB 616217.
https://apps.fcc.gov/oetcf/kdb/forms/FTSSearchResultPage.cfm?switch=P&id=33240
6. If simultaneous transmission condition does not meet requirements described above, please contact
Broadcom who is responsible for product compliance to determine the applicable simultaneous
transmission SAR evaluation procedures and applicable equipment authorization procedure. Module
must be installed and used in strict accordance with the manufacturer’s instructions as described in
the user documentation that comes with the product.
B. RegulatoryComplianceStatementintheUserManual
A user’s manual or instruction manual must be included with the customer product that contains the
text as required by applicable law. Without limitation of the foregoing, an example (for illustration
purposes only) of possible text to include is set forth below:
a. FCC COMPLIANCE STATEMENT: This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy. If not installed and used in accordance with the
instructions, it may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by tuning
the equipment off and on, the user is encouraged to try and correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna
-Increase the distance between the equipment and the receiver.
-Connect the equipment to outlet on a circuit different from that to which the receiver
is connected. -Consult the dealer or an experienced radio/TV technician for help.
