Brunata BrunataNet BoxGPRS Betriebsanleitung

BrunataNet BoxGPRS

with battery

User and installation manual

Indholdsfortegnelse

1. Introduction ........................................................................................................3

1.1 GPRS-box, ID and tel. no......................................................................................3

1.2 Components in at Brunata RS485net...................................................................3

1.3 Tools....................................................................................................................3

1.4 Text message commands .....................................................................................4

1.5 Status diodes and ON/OFF button........................................................................4

1.6 An example of a program ﬂow In the GPRS-box ..................................................6

2. SIM-card ..............................................................................................................7

2.1 Demands to the SIM-card ....................................................................................7

2.2 Installation of SIM-card........................................................................................7

3. Installation of the GPRS-box..............................................................................9

3.1 Placement of the GPRS-box..................................................................................9

3.2 Fitting a GPRS-box to a wall...............................................................................10

4. Battery............................................................................................................... 11

4.1 Battery recharging ............................................................................................. 11

4.2 Battery charger.................................................................................................. 12

4.3 Durability........................................................................................................... 12

5. Control and registration installation .............................................................. 13

5.1 What does the control consist of?...................................................................... 13

5.2 Has the GPRS-box found all the receivers?......................................................... 13

5.3 Can the GPRS-box send data to the Brunata database? ..................................... 13

5.4 Registration of components in the network. ...................................................... 13

6. Technical support.............................................................................................. 14

1. Introduction

1.1 GPRS-box, ID and tel. no

The GPRS-box has the following ID and telephone number:

GPRS-box ID

Telephone no.

1.2 Components in at Brunata RS485net

• GPRS-box With a RM485FM-radio receiver.

• Power-supply

• RM485FM-radio receiver.

• Brunata RS485-net cable.

• Connection box

1.3 Tools

It is recommended to use a KRONE LSA Terminal Tool (Brunata number 06-1040-C) to

install the cables into the LSA-connectors.

1.4 Text message commands

There are several commands to the GPRS-box, which can be sent to the GPRS-box by

text message. The text message must consist of the following 3 parameters divided by

a space:

If you leave out <value> GPRS-box will reply with the value it is programmed with.

More than one command can be sent in the same text message, you only have to write

<password> in the ﬁrst line of commands:

<Password> has the default setting dokfaw.

Text message

command

Description

uploadnow GPRS-box begins to collect new data from the receivers and

thereafter sends data to WebMon via GPRS

reboot Reboots the GPRS-box

uptime Minutes the GPRS-box has run

units A list of receivers which the GPRS-box has found

module_id The GPRS-box serial number.

meters A list of the meters the GPRS-box has found

gprs_apn

Parameters for the installation determine which apn the GPRS-

box uses when it is transmitting data.

gprs_username

gprs_password

The table below shows an example of a SMS-command

SMS-command SMS-answer

Dokfaw module_id 20999

1.5 Status diodes and ON/OFF button

At one end of the GPRS-box there are two status diodes which show the status of the

GPRS-box. To the right of the 2 status diodes there is a little push-button which can be

activated by a pencil.

Status-diodes Button Description

Turned off Short push If the GPRS-box is in sleep-mode the green

diode start to ﬂash

Long push Turns on the GPRS-box

Turned on Long push Turns off the GPRS-box

Green status-diode Description

Flashing

Searching for GSM-net

1 short ﬂash followed by a long pause

Has found GSM-net

2 short ﬂashes followed by a long

pause

Transferring data via GPRS

Turned off

The module is either turned off or in sleep-

mode

Yellow status-diode Description

Turned on

Data is send to WebMon

Flashing

Has not found any receivers or it has not

been possible to send data to WebMon

Turned off

The module is either turned off, in sleep-

mode or waiting for the next program run

After 3 – 5 minutes the GPRS-box will turn off the status diodes partly to save power

and partly to avoid drawing attention to the box if it is installed at a public place. With a

short pressure (under 1 sec.) at the button right to the status diodes you can reactivate

the diodes, and the status of the GPRS-box will be shown again. If the short pressure

does not reactivate on the status diodes, it means that the GPRS-box is turned off or

that there is no power to the box.

The GPRS-box will automatically start up when power is connected.

Diodes Push-button

ON/OFF

1.6 An example of a program ﬂow In the GPRS-box

The GPRS-box has just

been turned on.

Retrieving data from the

radio transmitters.

Sending data to

WebMon.

Waiting until data again

must be retrieved from

the RS485 net.

ERROR

The GPRS-box could not

send data to the Oracle

server.

2. SIM-card

2.1 Demands to the SIM-card

The SIM-card must uphold the following standards: GSM/GPRS/SMS. The PIN-code

must be switched off.

Attention: If using Danish SIM-card abroad, then make sure that the country’s

telephone operator supports GPRS-roaming.

2.2 Installation of SIM-card

The GPRS unit can be order with the SIM-card installed at delivery. Please control that

the card is installed.

Brunata a/s can not be held liable for theft and misuse of the SIM-card.

If the unit is delivered without a SIM-card, the SIM-card must be installed before the

unit is used. The GPRS-box is opened by removing the four screws in the lid. Hereafter

the SIM-card is installed with the “cut-off” corner in the upper right-hand side and the

chip facing down towards the print. Remember to write down the telephone number in

the rubric “Telephone number” (see paragraph 1.1). When the SIM-card is installed and

the GPRS-box is closed the power is turned on (see paragraph 1.3) Check that the green

diode, if it is ﬂashing, the GPRS-box is connected with the GSM-net.

Side 5 af 11

Brunata a/s – Vesterlundvej 14 – 2730 Herlev – tlf. 77 77 70 00 – fax 77 77 70 01 – brunata@brunata.dk

2. SIM-kort

2.1 Krav til SIM-kort

SIM-kortet skal opfylde følgende krav:

GSM/GPRS/SMS. PIN kode skal være slået fra.

Husk: ved brug af dansk SIM-kort i udlandet, skal det pågældende lands telefonoperatør

understøtte GPRS roaming.

2.2 Montering af SIM-kort

Enheden kan bestilles med SIM-kort monteret ved levering. Kontroller, at kortet er sat i.

Brunata A/S kan ikke gøres ansvarlig for tyveri og misbrug af SIM-kort.

Såfremt enheden er leveret uden SIM-kort, skal et sådant sættes i inden enheden tages i

brug. GPRS-boksen åbnes ved at fjerne de fire skruer i låget. Herefter sættes SIM-kortet i

med det “afklippede” hjørne i øverste højre side og chippen vendt ned mod printet. Husk at

notere telefonnummeret i rubrikken ”Telefonnummer” (se afsnit 1.1). Efter at SIM kortet er

korrekt indsat og GPRS-boksen er lukket, tændes der for GPRS-boksen (se afsnit 1.5) Kig

på den grønne lysdiode for at se om GPRS-boksen kommer på GSM-nettet.

SIM kort

behold for fejl og ændringer

- www.brunata.dk

QB 10.1466 fo

Der tages

Når GPRS-boksen er tændt: skal APN, login og password sættes op så det virker sammen

med SIM-kortets operatør. Her er der vist et eksempel fra Holland.

Dette gøres ved at sende nogle SMS-kommandoer til GPRS-boksen:

When the GPRS-box is on, the APN, log-in and pass-word must be installed so it cor-

responds with the operator of the SIM-card.

It is done by sending a text massage to the GPRS-box. Below is shown an example from

the Netherlands.

SMS-Command SMS-answer

dokfaw gprs_apn ofﬁce.vodafone.nl

okgprs_username Vodafone

gprs_password Vodafone

Getting the GPRS-box to send data to the Brunata server by following SMS-com-

mand:

SMS-Command SMS-answer

dokfaw uploadnow ok

When the GPRS-box has send data to the server please control, that the GPRS compo-

nents are received in WebMon.

3. Installation of the GPRS-box

3.1 Placement of the GPRS-box

The GPRS-box must be installed at a place where there is at good connection to the

GSM-net. This is achieved by observing the following rules:

• Theboxoughttobeplacedasfarawayfrom

a corner as possible. Never closer than 30 cm.

There will be a signiﬁcant improvement of re-

ception conditions if the GPRS-box is moved

from 30 cm to 50 cm away from the corner.

If moved further than 50 cm the improvement

in reception conditions will not be essentially

better.

• Alwaysinstallashighaspossible.

• Neverplaceitinanironcabinet.

• TheGPRS-boxshouldneverbeplacednexttoarefrigeratororothercupboardswith

big iron surfaces, which can block the radio telegrams from the meters.

• TheGPRS-boxcanhavedifcultiesinreceivingdatafrommetersinstalledbehind

the GPRS-box. You have to try to turn the GPRS-box so there are no meters behind

it. If it is impossible to avoid meters behind the box, the backend of the GPRS-box

must preferably be turned towards the meters closest to the box.

• AGPRS-boxshouldneverbeplacedcloserthan2m.toanallocator.IftheGPRS-

box is installed closer than 2 m. from the allocators make sure that the GPRS-box is

receiving the signals from the allocators. If the GPRS-box is installed closer than 2

m. from an allocator it must be checked to see if the GPRS-box is receiving signals

from the allocator.

Min. 30 cm

3.2 Fitting a GPRS-box to a wall.

Underneath the cover of the GPRS-box there are 4 ﬁtting holes through which the

GPRS-box can be ﬁtted to a level wall.

Fitting holes

Andere Handbücher für BrunataNet BoxGPRS

Inhaltsverzeichnis

Andere Brunata Empfänger Handbücher

Brunata

Brunata BrunataNet BoxGPRS Betriebsanleitung

Beliebte Empfänger Handbücher anderer Marken

Garmin

Garmin GA 23 Bedienungsanleitung

Aiphone

Aiphone PS-12F Bedienungsanleitung

IMES

IMES TCS-01CA-PMI Bedienungsanleitung

BWI Eagle

BWI Eagle AIR-EAGLE SR Handbuch

AMIMON

AMIMON AMN12310 WHDI Bedienungsanleitung

Dual

Dual DMCPA79BT Betriebsanleitung

Sound Associates

Sound Associates SA652P Bedienungsanleitung

Sherwood

Sherwood NewCastle R-772 Bedienungsanleitung

Audio

Audio A10-RX Series Bedienungsanleitung

AllSee

AllSee PushShare PSRV1.1 Bedienungsanleitung

DEMAG

DEMAG DRC-DR D2 Bedienungsanleitung

Teleco

Teleco TVRCL868A02 Bedienungsanleitung

Bosch

Bosch RF3222E Bedienungsanleitung

Kramer

Kramer 631R Bedienungsanleitung

Xpress

Xpress xmc10 Bedienungsanleitung

JVC

JVC KD-MR1BTS Bedienungsanleitung

Omega Engineering

Omega Engineering UWTC-REC3 Bedienungsanleitung

e-survey

e-survey E300 Pro Bedienungsanleitung