1.562.949.8625
|
www.stronghandtools.com
|
[email protected] |
8750
Pioneer
Blvd.,
Santa
Fe
Springs,
CA
90670
U.S.A.
Applicable P/N: TM, TMQ series.
MODULAR WELDING TABLE SETUP INSTRUCTIONS
BUILDPRO
®
Welding Tables
TABLE SETUP
(a)
(b)
Packaging Supporting Legs
(c)
Screw Driver
Round bar
(d)
Leveling
Pad
M20
Nut
Thank you for choosing BuildPro®Modular Welding Tables. Please read all
setup instructions before beginning the setup of your BuildPro® Welding Table.
1. First remove the wooden table cover,
bubble film and anti-rust paper, then use
the forklift to lift the whole table. (or use
other lifting equipment) Remove the
supporting (shipping) legs (4 or 6) based
on the size of the table. (Figures a & b).
2. Place the yellow table legs into the same
screw holes originally used to secure the
shipping legs, then tighten clockwise with
a screwdriver or a round bar smaller than
12 mm (Figure c) by inserting into the
small through-hole in the middle of the
yellow legs.
3. After the table legs are securely installed,
lower the table onto your shop floor.
4. Adjust the Leveling Nuts on each Leveling
Pad until the entire table is level. Tighten
the lock nuts using a wrench. (Figure d)
