Bunn AutoPOD Bedienungsanleitung

BUNN-O-MATIC CORPORATION

POST OFFICE BOX 3227

SPRINGFIELD, ILLINOIS 62708-3227

PHONE: (217) 529-6601 FAX: (217) 529-6644

AutoPOD

Instructions for Installing

Retroﬁt Tank Kit #41021.1100

KIT CONTENTS

1 42041.0000 Hot Water Tank

1 41022.0000 Brew Tank

2 28891.0009 Temp probes

2 36629.0003 Braided tubes

2 12422.0000 Clamps, SNP-6 (Lower)

1 12422.0006 Clamp, SNP-8 (HW inlet)

2 12422.0011 Clamps, SNP-4 (Upper)

1 41816.0000 Instructions

INSTRUCTIONS

Refer to illustrations.

1. Follow tank draining procedure in Operating Manual.

2. Remove rear access panel.

3. Remove 3 screws securing board mounting bracket to frame. Pivot board assembly to gain access to plumbing

under brew tank.

4. Disconnect hoses & connectors from both tanks.

5. Remove the screws securing the tank retaining straps & remove tanks.

6. Cut the steel bands from old tanks & remove limit thermostats. Install them under clips of new tanks &

reconnect harnesses. FIG 2A & B

7. Install new tank assemblies & retaining straps.

8. Install level probe in Hot Water tank.

INTRODUCTION

WARNING - The brewer must be disconnected from the power source until installation is completed. Allow

brewer to cool.

This instruction covers the installation of new style tanks into early models.

WARNING: Software must be at version .17 or higher to operate new style temperature probes.

CONTINUED

NEW STYLE TANKS

FIG 1

9. Connect inlet & outlet hoses to both tanks. NOTE: New HW tank has larger inlet barb ﬁtting than old HW tank.

FIG 2. Discard short hose that was used as a reducer on old tank. Use the included SNP-8 clamp when installing

inlet hose on new HW tank.

10. Install new temp probes & braided tubes as shown above. Install SNP-6 clamps at bottom of braided tubes, and

SNP-4 clamps at top of braided tubes.

Hot Water Tank

Brew Tank

Limit thermostat clips

New thermistors

mounted through top

CONTINUED

FIG 2A

Cut band, reuse limit

Reuse level probe

Discard

FIG 2B

CONTINUED

OLD STYLE HOT

WATER TANK

SHOWN

NEW STYLE

BREW TANK

SHOWN

BREW TANK THERMISTOR

HOT WATER TANK THERMISTOR

FIG 3

11. Reinstall control board/bracket assembly. Connect temp probe harness to control board. FIG 3

12. Replace the rear access panel. Place large cup under brew chamber.

13. NOTE A: If using same control board, use the initial tank ﬁll procedure; press & hold “OPEN/CLOSE” & “HOT

WATER” buttons while connecting to power source. FIG 4

NOTE B: If installing new control board, connect to power source & start a brew cycle to ﬁll tanks.

14. Discard the old tank assemblies.

FIG 4

Andere Handbücher für AutoPOD

Inhaltsverzeichnis

Andere Bunn Brausystem Handbücher

Bunn

Bunn Fast Cup Series Betriebsanleitung

Bunn

Bunn AutoPOD Bedienungsanleitung

Bunn

Bunn Sure Immersion 220 Betriebsanleitung

Bunn

Bunn GRX Bedienungsanleitung

Bunn

Bunn McDonald's ITCB Betriebsanleitung

Bunn

Bunn Sure Immersion 312 Betriebsanleitung

Bunn

Bunn ITCB Bedienungsanleitung

Bunn

Bunn Trifecta Betriebsanleitung

Bunn

Bunn Sure Immersion 312 Fehlerbehebungshandbuch

Bunn

Bunn ITCB DV Fehlerbehebungshandbuch

Bunn

Bunn Dual SH BrewWISE Installationsanleitung

Bunn

Bunn ITCB Single Series Installationsanleitung

Bunn

Bunn G9-2T DBC Bedienungsanleitung

Bunn

Bunn ICB Fehlerbehebungshandbuch

Bunn

Bunn Sure Immersion 220 Betriebsanleitung

Bunn

Bunn TITAN SINGLE Betriebsanleitung

Bunn

Bunn TITAN SINGLE Betriebsanleitung

Bunn

Bunn TB3Q Bedienungsanleitung

Bunn

Bunn Fast Cup Fehlerbehebungshandbuch

Bunn

Bunn ITCB Bedienungsanleitung

Beliebte Brausystem Handbücher anderer Marken

CBF-DRINKIT

CBF-DRINKIT Coobra CB25 Bedienungsanleitung

Toddy

Toddy ARTISAN Bedienungsanleitung

Keurig

Keurig Vue Bedienungsanleitung

VKI Technologies

VKI Technologies Zuma Brewer Bedienungsanleitung

Speidel

Speidel Braumeister PLUS 10 litres Bedienungsanleitung

BrewBuilt

BrewBuilt X2 UNI Bedienungsanleitung

Tribest

Tribest RAW TEA KETTLE Bedienungsanleitung

Sprowt Labs

Sprowt Labs Acro Bedienungsanleitung

KegLand

KegLand Robobrew Bedienungsanleitung

BRAVILOR BONAMAT

BRAVILOR BONAMAT Aurora GTBSH-001 Bedienungsanleitung

Fetco

Fetco CBS-1221 Technische Daten

Curtis

Curtis ThermoPro G4 Series Bedienungsanleitung

Animo

Animo ComBi CB5 Bedienungsanleitung

MoreBeer

MoreBeer BrewSculpture Bedienungsanleitung

Keurig Hot

Keurig Hot Commercial Series Bedienungsanleitung

Keg King

Keg King KEGMASTER XL Bedienungsanleitung

Blichmann Engineering

Blichmann Engineering BrewEasy Compact TC Montageanleitung

Blichmann Engineering

Blichmann Engineering 3.5 BBL Hybrid Brewhouse Montageanleitung