Canon EF 16-35mm f/2.8L II USM Bedienungsanleitung

EF16-35mm f/2.8L III USM

Instructions

ENG

ENG-1

Thank you for purchasing a Canon product.

Canon’s EF16-35mm f/2.8L III USM is a

super-wide-angle zoom lens for use with

EOS cameras.

 “USM” stands for Ultrasonic Motor.

Camera Firmware

 When using this lens, please check the Canon website

for the latest camera rmware. If the camera’s rmware

is not the latest version, be sure to update to the latest

rmware.

 For details on updating rmware, please check the

Canon website.

Conventions used in this instruction

Warning to prevent lens or camera malfunction

or damage.

Supplementary notes on using the lens and

taking pictures.

ENG-2

Precautions to ensure that the camera is used

safely. Read these precautions thoroughly. Make

sure all details are observed in order to prevent

risks and injury to the user and other people.

Warning Details pertaining to risks that may

result in death or serious injury.

 Do not look at the sun or a bright light source

through the lens or single-lens reflex camera.

Doing so could result in loss of vision. Looking at the

sun directly through the lens is especially hazardous.

 Whether it is attached to the camera or not, do

not leave the lens under the sun without the

lens cap attached. This is to prevent the lens from

concentrating the sun’s rays, which could cause a re.

Caution Details pertaining to risks that may

result in injury.

 Do not leave the camera in locations subject to

high or low temperatures. This may result in the

camera becoming excessively hot or cold, which may

cause burns or other injuries when touched.

 Do not insert your fingers inside the camera.

Failure to observe this may result in injury.

Caution Details pertaining to risks that may

result in damage to property.

 Do not leave the lens in excessive heat such as in a

car in direct sunlight. High temperatures can cause the

lens to malfunction.

Safety Precautions

ENG-3

Handling Precautions

 If the lens is taken from a cold environment into a

warm one, condensation may develop on the lens

surface and internal parts. To prevent condensation in

this case, rst put the lens into an airtight plastic bag

before taking it from a cold to warm environment. Then

take out the lens after it has warmed gradually. Do the

same when taking the lens from a warm environment

into a cold one.

 Please also read any lens related handling precautions

listed in your camera’s instruction manual.

General Precautions

ENG-4

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

Do not make any changes or modications to the equipment

unless otherwise specied in the instructions. If such

changes or modications should be made, you could be

required to stop operation of the equipment.

This equipment has been tested and found to comply with

the limits for a class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

CAN ICES-3 (B) / NMB-3 (B)

ENG-5

Hood mount (→ 9)

Filter mounting thread

(→ 10)

Focusing ring (→ 7) Lens mount index (→ 6)

Focus mode switch (→ 7)

Distance scale (→ 8)

Zoom ring (→ 7)

Zoom position index (→ 7)

Contacts (→ 6)

Rubber ring (→ 6)

 For detailed information, reference page numbers are provided in parentheses (→ **).

Nomenclature

ENG-6

See your camera’s instructions for details on

mounting and detaching the lens.

 After detaching the lens, place the lens with

the rear end up to prevent the lens surface and

contacts from getting scratched.

 If the contacts get soiled, scratched, or have

ngerprints on them, corrosion or faulty

connections can result. The camera and lens

may not operate properly.

 If the contacts get soiled or have ngerprints on

them, clean them with a soft cloth.

 Attach the lens cap and dust cap when

disconnecting the lens. When attaching the

dust cap, align the lens mount index with the 

index of the dust cap and rotate in a clockwise

direction as shown in the illustration. Follow the

reverse procedure to detach it.

The lens mount has a rubber ring for enhanced

dust- and water-resistance. The rubber ring may

cause slight abrasions around the camera’s lens

mount, but this will not cause any problems. If the

rubber ring becomes worn, it is replaceable by a

Canon Service Center at a cost.

1. Mounting and Detaching the Lens

ENG-7

To zoom, turn the lens’ zoom ring.

Be sure to nish zooming before focusing. Zooming

after focusing can affect the focus.

To shoot in autofocus (AF) mode, set the focus

mode switch to AF.

To use only manual focusing (MF), set the focus

mode switch to MF, and focus by turning the

focusing ring.

The focusing ring always works, regardless of

the focus mode.

After autofocusing in the AF mode or AF operation

in the ONE SHOT AF mode, focus manually by

pressing the shutter button halfway and turning the

focusing ring (Full-time manual focus).

3. Zooming2.

Setting the Focus Mode

ENG-8

Innity compensation markDistance index

To compensate for shifting of the innity focus

point that results from changes in temperature,

there is a margin at the innity (∞) position.

The innity position at normal temperature is the

point at which the vertical line of the distance

scale L mark is aligned with the distance index.

For accurate manual focusing of subjects at innity,

look through the viewnder or look at the magnied

image* on the LCD screen while rotating the

focusing ring.

* For cameras with Live View shooting capability.

Infrared Index

The infrared index corrects the focus setting when

using monochrome infrared lm. Focus on the subject

manually, then adjust the distance scale indicated by

the distance index by moving the focusing ring to the

corresponding infrared index mark before shooting.

Some EOS cameras cannot use infrared lm. See

the instructions for your EOS camera.

 The infrared index position is based on a

wavelength of 800 nm.

 The compensation amount differs depending on

the focal length (large at the wide end, small at

the telephoto end). Use the 16 (mm) infrared

index position as a guide when setting the

compensation amount manually.

 Be sure to observe the manufacturer’s

instructions when using infrared lm.

 Use a red lter when you take the picture.

Innity Compensation Mark

5. Infrared Index

ENG-9

6. Hood

The EW-88D hood cuts out unwanted light and protects the front of the lens from rain, snow, and dust.

Attachment position mark

Stop position mark

Red dot

● Attaching

Align the red attachment position mark on the

hood with the red dot on the front of the lens,

and then rotate the hood in the direction of the

arrow until it is rmly attached with the red dot

and stop position mark on the hood aligned.

Button

● Removing

Keep your nger pressed down on the button

located on the side of the hood, and then rotate

the hood in the direction of the arrow until the

attachment position mark on the hood is aligned

with the red dot on the front of the lens to detach

it. The hood can be reverse-mounted on the lens

for storage.

 If the hood is not attached properly, vignetting (darkening of the perimeter of the picture) may occur.

 Grasp and rotate the base of the hood when attaching and detaching it. There are cases in which it may

become deformed if the hood is rotated with it grasped near to the rim.

Andere Handbücher für EF 16-35mm f/2.8L II USM

Inhaltsverzeichnis

Andere Canon Kameraobjektiv Handbücher

Canon

Canon EF 50mm1:1.8 Bedienungsanleitung

Canon

Canon EF-S18-55mm f/3.5-5.6 IS STM Bedienungsanleitung

Canon

Canon C-8 Bedienungsanleitung

Canon

Canon EF 28-80mm 1:2.8-4.0L USM Bedienungsanleitung

Canon

Canon digi super 100 XS Bedienungsanleitung

Canon

Canon RF 10-20mm F4 L IS STM Bedienungsanleitung

Canon

Canon EF 75-300 mm F4-5 Bedienungsanleitung

Canon

Canon CN-E30-300mm T2.95-3.7 LS Bedienungsanleitung

Canon

Canon KH16ex5.7 IRSE Bedienungsanleitung

Canon

Canon EOS 5D Mark IV + 70-200mm Bedienungsanleitung

Canon

Canon EF 600mm 1:4.0L IS (ULTRASONIC Bedienungsanleitung

Canon

Canon EF135MM F/2L USM Bedienungsanleitung

Canon

Canon EF40mm f/2.8 STM Bedienungsanleitung

Canon

Canon EF11-24mm f/4L USM Bedienungsanleitung

Canon

Canon EF-M 18-55mm f3.5-5.6 IS STM Bedienungsanleitung

Canon

Canon EF35mm f/2 IS USM Bedienungsanleitung

Canon

Canon EF 20mm 1:2.8 USM Bedienungsanleitung

Canon

Canon EF600mm f/4L IS II USM Bedienungsanleitung

Canon

Canon EF28 Bedienungsanleitung

Canon

Canon EF200 mm Bedienungsanleitung

Canon

Canon CN-E24mm T1.5 L F Bedienungsanleitung

Canon

Canon FD Lens Handbuch

Canon

Canon CN-E15.5-47mm T2.8 L S Bedienungsanleitung

Canon

Canon EF35mm f/1.4L II USM Bedienungsanleitung

Beliebte Kameraobjektiv Handbücher anderer Marken

THORLABS

THORLABS ELL15 Bedienungsanleitung

FUJICA

FUJICA ZC1000 Bedienungsanleitung

Tamron

Tamron A09 Handbuch

Sony

Sony SEL-55210 Bedienungsanleitung

Sony

Sony VCL-HG2037 Bedienungsanleitung

Honeywell

Honeywell HLM25V6F12 Bedienungsanleitung

Sony

Sony VCL-ST30 Bedienungsanleitung

Sony

Sony SAL-85F14Z - 85mm f1.4 Carl Zeiss Planar T Coated Telephoto... Bedienungsanleitung

ARRI

ARRI Lenses Bedienungsanleitung

Olympus

Olympus M.Zuiko Digital ES 300mm f4.0 IS PRO Bedienungsanleitung

Sony

Sony VCL-DE07T Bedienungsanleitung

Tamron

Tamron A036 Bedienungsanleitung

Samsung

Samsung 20-50mm F3.5-5.6 ED II Bedienungsanleitung

Tamron

Tamron 272E Bedienungsanleitung

Sinar

Sinar Rolleiflex 6008 AF Bedienungsanleitung

Rokinon

Rokinon SP 85mm F1.2 Bedienungsanleitung

Nikon

Nikon AF-S Zoom-Nikkor 17-35mm f/2.8D IF-ED Bedienungsanleitung

Samsung

Samsung Samsung 18-55mm Bedienungsanleitung