Caple RIR178 Bedienungsanleitung

Contact Caple on 0844 800 3830 or for spare parts www.4caple.co.uk

Instruction manual for integrated fridge

Model code:RIR178

Contents

Cautions---------------------------------------------------------------------------------------1~2

Diagram----------------------------------------------------------------------------------------3

Preparation------------------------------------------------------------------------------------4~5

Operation--------------------------------------------------------------------------------------6

Instruction-------------------------------------------------------------------------------------7~10

Defrosting,cleaning and de-commissioning------------------------------------------11~12

Trouble shooting----------------------------------------------------------------------------13

1. Compression-type appliances which use flammable refrigerants shall be marked

with the symbol “Caution: risk of fire”.

The height of the triangle in the symbol “Caution: risk of fire” shall be at least 15 mm.

– WARNING: Keep ventilation openings, in the appliance enclosure or in the built-in

structure, clear of obstruction.

– WARNING: Do not use mechanical devices or other means to accelerate the defrosting

process, other than those recommended by the manufacturer.

– WARNING: Do not damage the refrigerant circuit.

– WARNING: Do not use electrical appliances inside the food storage compartments of the

appliance, unless they are of the type recommended by the manufacturer.

Do not store explosive substances such as aerosol cans with a flammable propellant in

this appliance.

If the supply cord is damaged, it must be replaced by a special cord or assembly available

from the manufacturer or its service agent.

This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance by a person responsible for

their safety.

Children should be supervised to ensure that they do not play with the appliance.

Caution：risk of fire

Cautions

Disposal of the old appliance

Before disposing an old appliance, please make sure it’s inoperative and safe. Unplug

the appliance and remove or destroy all of the springs, latches, or bolt-locks in order to

avoid the risk of child entrapment.

It must be noted that the refrigeration system contains insulating gases and refrigerants,

which require specialized waste disposal. The valuable materials contained in a refrig-

erator can be recycled. Contact your local waste disposal center for proper disposal of

an old appliance and contact your local authority or your dealer if you have any ques-

tion. Please ensure that the pipe work of your refrigerator dose not get damaged prior to

being picked up by the relevant waste disposal center．

Disposal of the packaging of your new appliance

All the packaging materials employed in the package of your new appliance may be

disposed without any danger to the environment.

The cardboard box may be broken or cut into smaller pieces and given to a waste paper

disposal service. The wrapping foil is made of polyethylene and the polyethylene pads

and stuffing contain no fluorochloric hydrocarbon.

All these valuable materials may be taken to a waste collecting center and used again

after adequate recycling.

Consult your local authorities for the name and address of the waste materials collect-

ing centers and waste paper disposal services nearest to your house.

Safety Instructions and Warnings

Before starting the appliance, read the information given in the User’s Guide carefully.

The User’s Guide contains very important observations relating to the assembly,

operation and maintenance of the appliance.

Keep the User’s Guide in a safe place and remember to hand it over to the subsequent

owner, if you ever sell the appliance.

The manufacturer does not accept responsibility for any damages that may arise due to

non-observation of the following instruction.

*Damaged appliances are not to be put into operation. In case of doubt ,consult your

supplier.

is to be carried out in strict compliance

Refrigerator Diagram

1.Freezing compartment 2.Temperature Controller

3.Shelves 4.Vegetable and fruit tray

5.Egg tray 6.Bottle racks

This diagram may vary slightly with the layout of the refrigerator you

have

just purchased due to technical improvements.

Preparation

Unpacking

Remove all packing materials.

Check attachments and materials

Checking should be conducted with reference to the Packing List. Contact the local

distributor if discrepancies are found.

Ensure proper location of the refrigerator.

Clean the refrigerator before use.

(See the following section “Cleaning”)

Idle time

After the refrigerator has been sited and cleaned, let it stand for more than 12 hours

before connecting the power source.

Ventilation（Figure 1）

*Level the kitchen cabinet unit with a spirit level and a

try square. Level the unit by placing packing material

underneath if required.

*A minimum gap of 38mm must be maintained at

the back of the appliance for ventilation.

*Air inlet A must be at least 200 cm square and

air must flow through the panel in the cabinet

plinth.

*Check that the position of the power socket (1)

is correct. AC voltage in the location at which

the appliance is to be used must comply with

that as shown on the data plate located on the

left inside wall of the appliance next to the

vegetable bins. The power supply must be

suitably earthed. （Fi

ure 1）

Preparation

Installation（Figure 2）

1.Check that the kitchen unit door is in the correct operating position.

2.Run the mains cable through the unit such that it can be connected to the power supply

after installing the appliance. Remove the cover (6) only if space is restricted.

3.Place the refrigerator into the kitchen unit. Fix the mountings (1) with screws (2) onto the

upper frame when two third of the refrigerator has been pushed in. Then push the

refrigerator in completely, ensuring that the gib clamp of the mountings stuck on the

horizontal frame of the kitchen unit. Adjust the position of the refrigerator making a 6mm

space between inside wall of the kitchen unit and external sides of the refrigerators. Fix

the mountings to the horizontal frame of the kitchen unit with screws.

4.Insert the seal in the aperture (approx. 10mm) between the lower front frame and bottom

board of the kitchen. Fix lower mountings (3) to the lower front frame with screws (2). Fix

the lower mountings to the bottom board of the kitchen unit with screws (2).

5.Properly insert seals in the apertures on the left, upper and right sides of the refrigerator.

6.Fix the door to the holders (4) (each upper and lower position has one) with screws (2).

Press close the doors of the refrigerator and of the kitchen unit, and then completely

open the doors, and then place the connecting plate (5)to the corresponding holder and

fix it to the door of the kitchen unit (space between the connecting plate and the edge of

the kitchen unit "t" equals to the thickness of the external board of the kitchen unit, about

20mm).Adjust the connecting element so that the handle side of the kitchen unit door

does not make contact with the unit body when closed. (Approximately 1mm gap for

large appliances), mount the second door connecting element where appropriate.

7.Plug the open hole in the appliance door.

（Fi

ure 2）

Caution: Some time will be required for the refrigerator to reach the set level when

temperature adjustments are made. The length of this period is determined by

difference in the existing and set temperatures, the ambient temperature, the

frequency with which the door is opened and closed and the amount of food in

storage.

Caution: If ambient temperature is below 16

℃

, please turn on the “Low-temp

Controller”.

Temperature Controllor

Loading the refrigerator with food

When the refrigerator is switched on, do not load

food until 1～2 hours have passed. Usually, food

for cold storage or deep freezing can be loaded

when the temperature inside the compartment

reaches the set point.

Instructions

Cold storage is for short-term food

Storage or for daily consumption.

Although the temperature in most parts of the cold

storage compartment can be regulated between 0

and 10 degrees Centigrade, extended periods of

food storage is not recommended. Cold storage

should only be used for short-term storage.

Cold storage compartment

1. Eggs and butter

2. Pickled food and seasonings

3. Beverages and bottled food

4. Food to be frozen

5. Cookies, cooked food and milk

6. Meat and sausages

7. Fruits, vegetables and salads

Inhaltsverzeichnis

Andere Caple Kühlschrank Handbücher

Caple

Caple RBR1A Technisches Datenblatt

Caple

Caple RBL6 Bedienungsanleitung

Caple

Caple RI7306 Bedienungsanleitung

Caple

Caple C175L Bedienungsanleitung

Caple

Caple C155L Bedienungsanleitung

Caple

Caple RBL5 Bedienungsanleitung

Caple

Caple RIL88 Bedienungsanleitung

Caple

Caple CAFF19BK Handbuch

Caple

Caple RiL871 Bedienungsanleitung

Caple

Caple QFF158/91F Bedienungsanleitung

Caple

Caple RIL123 Bedienungsanleitung

Caple

Caple CAFF22 Bedienungsanleitung

Caple

Caple RIR177 Bedienungsanleitung

Caple

Caple Ri553FF Bedienungsanleitung

Caple

Caple CAFF205SS Bedienungsanleitung

Caple

Caple CAFF41 Bedienungsanleitung

Caple

Caple C126F Bedienungsanleitung

Caple

Caple CAFF207SS Bedienungsanleitung

Caple

Caple RIL1800 Bedienungsanleitung

Caple

Caple RFL70 Bedienungsanleitung

Caple

Caple RIR179 Bedienungsanleitung

Caple

Caple RBF1A Bedienungsanleitung

Caple

Caple RI736 Bedienungsanleitung

Caple

Caple C159/95 Bedienungsanleitung

Beliebte Kühlschrank Handbücher anderer Marken

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Bedienungsanleitung

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Bedienungsanleitung

Sharp

Sharp SJ-BA31IEXW2-EU Bedienungsanleitung

CORBERO

CORBERO CC2300MCW Bedienungsanleitung

KitchenAid

KitchenAid 2205264 Bedienungsanleitung

Stengel

Stengel KU 1101 A++ Bedienungsanleitung

NEFF

NEFF KI181 Series Bedienungsanleitung

Hoshizaki

Hoshizaki Reach-In Bedienungsanleitung

Amana

Amana ASD2524VES00 Bedienungsanleitung

BOMANN

BOMANN KGC 213 Bedienungsanleitung

Danby

Danby DAR044A1SLDD Montageanleitung

Samsung

Samsung RF323TE Bedienungsanleitung

Beko

Beko CSA31022 Bedienungsanleitung

IKEA

IKEA FROSTIG C 185 E Bedienungsanleitung

Electrolux

Electrolux ER 6821 D Bedienungsanleitung

True

True TS-28 Bedienungsanleitung

Frigidaire

Frigidaire FSC23R5DW9 Bedienungsanleitung

Beko

Beko LSP4579W Bedienungsanleitung