Cellar Cool RTN400 Bedienungsanleitung
24VTCK.FD.Ultimate 090618
24V Thermostat Conversion Kit to be used in
conjunction with Fully Ducted Ultimate Series
*CONFIDENTIAL*
Fully Ducted Ultimate Series
24V THERMOSTAT
CONVERSION KIT
Installation Manual
(RTN400 & XW260K)
24VTCK.FD.Ultimate 090618
Copyright © 2018. CellarCool. All rights reserved.
CellarCool copyrights this manual, the product design, and the design concepts, with all rights reserved. Your rights with
regard to the hardware and manual are subject to the restrictions and limitations imposed by the copyright laws of the USA.
Under copyright laws, this manual may not be copied, reproduced, translated, transmitted, or reduced to any printed or
electronic medium or to any machine-readable form, for any purpose, in whole or in part, without the written consent of
CellarCool.
Every effort has been made to ensure that the information in this manual is accurate. CellarCool is not responsible for
printing or clerical errors.
CellarCool reserves the right to make corrections or improvements to the information provided and to the related hardware
at any time, without notice.
Vinothèque and CellarCool are registered trademarks, and ECE is a trademark of CellarCool. All rights reserved.
Mention of third-party products is for informational purposes only and constitutes neither an endorsement nor a
recommendation. CellarCool assumes no liability with regard to the performance or use of these products.
We manufacture, test and certify 100% of our wine cooling units in
the USA. By sourcing the best components and closely controlling our
manufacturing processes, we can assure the highest-quality,
lowest defect manufacturing rates in the industry.
Conforms to ANSI/UL Std 427
Certied to CAN/CSA Std C22.2 No. 120
www.cellarcool.com | Page 1
TABLE OF CONTENTS
Receiving & Inspecting the Kit ................................ 3
Before You Start .............................................. 4
24V Thermostat Conversion Kit
Installation Instructions ...................................... 5
Page 2 | 1-855-235-5271 24VTCK.FD.Ultimate 090618
INTRODUCTION
Customer Service
Thank you for purchasing a CellarCool 24V Thermostat Conversion Kit. We strive to provide the highest-quality
products and the best possible customer service. If you have any questions about your system, please call us at
1-800-343-9463 or visit CellarCool.com.
Using the Manual
This installation manual is intended to provide detailed instructions for the installation of the 24V Thermostat
Conversion Kit on the Fully Ducted Ultimate Series cooling system. In order to ensure the proper longevity of your
cooling unit, the equipment should be installed as outlined in this manual. Please read and review this manual
carefully and keep it for future reference.
What is a 24V Thermostat Conversion Kit?
The 24V Thermostat Conversion Kit is a CellarCool product that allows the customer to switch from the provided
standard 120V controller to a 24V thermostat of their choosing (i.e. Nest, Ecobee, Honeywell etc.)
*Note: 24V Thermostat not provided by CellarCool
How Does the 24V Thermostat Conversion Kit Work?
The 24V Thermostat Conversion Kit allows the customer the ability to utilize a 24V smart thermostat to control the
operation of their CellarCool unit. Note: 24V Thermostat must be placed inside the wine cellar in a central location,
away from direct airow.
RTN400 Controller XW260K Controller
Note: CellarCool does not provide technical/customer support for any 24V thermostat.
Please contact the manufacturer of your chosen 24V thermostat for troubleshooting.
www.cellarcool.com | Page 3
After verifying that you have received all of the correct components for your specic system, please keep the 24V
Conversion Kit in its original box until you are ready for installation. This will allow you to move the product safely
without damaging it. When you are ready to remove the product from the box, refer to the installation instructions.
TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
Evaporator unit components provided:
• 24V conversion kit enclosure
• Installation instructions
• Accessory kit
• Molex adapter
Accessory kit items:
• Cable tie (x8)
• Cable tie holder (x3)
• Wire nut (x4)
• 7/16 plug
• 7/16 strain relief
• 5/8 strain relief
• 3m tape (8 in.)
Tools needed:
• Wire cutters
• Wire strippers
• Phillips #1 screw driver
• Phillips # screw driver
• Flat head screw driver
• Needle nose pliers
Components needed (not included):
• 24V thermostat
• 18-5 thermostat wire
Upon receiving your 24V Thermostat Conversion Kit:
• Inspect the packaging for any obvious signs of damage or mishandling before opening the container.
• Note any discrepancies or visual damage on the bill of lading before signing.
• Review the packing slip to verify contents.
• Check the model number to ensure it is correct.
If any items listed on the packing slip do not match your order information,
contact CellarCool Customer Service immediately.
REMEMBER:
1. Inspect the kit before installation. If damage is found, please contact your distributor or CellarCool Customer
Service at 1-800-343-9463.
2. Verify that you have received all of the items on the component list below and that the kit corresponds with your
specific CellarCool cooling system.
3. The system is intended for use in properly designed and constructed wine cellars. Hire a professional wine
storage consultant with a valid contractor’s license to build your wine cellar.
4. CellarCool recommends that all 24V Thermostat Conversion Kits be installed by a certified HVAC-R technician only.
STEP : RECEIVING & INSPECTING THE KIT
1
Page 4 | 1-855-235-5271 24VTCK.FD.Ultimate 090618
STEP : BEFORE YOU START
- DISCLAIMER -
Disconnect both the evaporator unit (air handler) and the
condensing unit from their power source(s).
Shut o power to the evaporator and condensing unit.
WARNING: Failure to disconnect the power may cause
electrical shock, which can result in injury or death.
Note: If the unit is hard-wired to a dedicated power source,
shut o the designated breaker.
These instructions are universal for both the RTN400 & XW260K
controllers.
If your controller model is RTN400,
skip the steps labeled XW260K ONLY.
If your controller model is XW260K,
skip the steps labeled RTN400 ONLY.
2
www.cellarcool.com | Page 5
24V THERMOSTAT CONVERSION KIT INSTALLATION INSTRUCTIONS
Using a #2 Phillips screw driver, loosen the screws
securing the faceplate to the unit.
Remove faceplate from unit and allow to hang as
shown.
The controller enclosure is secured in the
electrical compartment using double-coated
tape. Use a athead screw driver to remove the
enclosure from unit.
Slide enclosure forward and remove lid using #1
Phillips screw driver.
3
4
5
6
Page 6 | 1-855-235-5271 24VTCK.FD.Ultimate 090618
Remove the BOTTLE PROBE and DISPLAY circular
connector from the faceplate by loosening the
plastic nut counter-clockwise.
RTN400 ONLY
Pop the rubber grommet out of the hole of the
enclosure.
RTN400 ONLY
Use wire cutters to remove the section of the
enclosure highlighted in the photo.
RTN400 ONLY
Unplug Molex connectors and separate the wires.
7
8
9
10
www.cellarcool.com | Page 7
RTN400 ONLY
Locate Pb1, Pb2, DI and Display wires.
RTN400 ONLY
Disconnect Pb2, DI, Display, and Pb1 wires from the
circuit board.
RTN400 ONLY
Remove the disconnected wires from the enclosure.
XW260K ONLY
Disconnect wires circled in photo from circuit
board using needle-nose pliers (terminals 3, 4,
14, 15, 16 and 21).
11
12
13
14
Page 8 | 1-855-235-5271 24VTCK.FD.Ultimate 090618
XW260K ONLY
Remove the disconnected wires from the
enclosure.
Separate controller assembly from the unit.
Controller assembly is no longer needed.
XW260K ONLY
Cut connectors o previously removed wires
shown (blue 14, black 15, white 16, brown 21).
Strip wires.
XW260K ONLY
Splice provided connector to wires by color (blue
to blue, black to black, white to white, brown to
brown).
15
16
17
18
Andere Handbücher für RTN400
1
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Cellar Cool Thermostat Handbücher
Beliebte Thermostat Handbücher anderer Marken
EWELLY
EWELLY EW-181 Bedienungsanleitung
Prolon
Prolon T1100 Montageanleitung
Computherm
Computherm Q20 Bedienungsanleitung
Heatmiser
Heatmiser neoStat Bedienungsanleitung
Aube Technologies
Aube Technologies TH111GFCI-NP 240 VCA Bedienungsanleitung
Mars
Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung
