Chamberlain MyQ Garage Bedienungsanleitung

MyQ Garage

Universal Smartphone

Garage Door Controller

USER’S GUIDE

(afﬁx serial number label)

Serial Number

To reduce the risk of SEVERE INJURY to persons:

• DO NOT enable the Chamberlain Universal Smartphone Garage Door Controller if

operating either one-piece or swinging doors. To be enabled ONLY on a sectional

door.

Read instructions thoroughly BEFORE beginning.

If using this product with residential door openers, this product

must be used only with door openers manufactured after 1993 that

utilize photoelectric sensors. The photoelectric sensors are always

located on or near the bottom of the door track.

STOP

WHAT'S IN THE BOX

Wi-Fi Hub

Door Sensor

Power Supply

Hardware for Wi-Fi Hub

(5/32", long screws)

Bracket for Wi-Fi Hub

Hardware for Door Sensor

(5/32", short screws)

Fastening Strips for

Door Sensor User’s Guide Warning Placard

NOTE: The Wi-Fi hub can control up to 2 garage doors, however an additional door

sensor is required. Follow the instructions included with the new door sensor for

programming instructions.

BEFORE STARTING YOU MUST HAVE...

• A mobile device, used during setup

• Router with Wi-Fi®

• Broadband Internet Connection

• Wi-Fi Hub Serial Number (located in this User's Guide and on the Wi-Fi Hub)

• Compatible Garage Door Opener (www.chamberlain.com/MyQGarage)

• Make sure your mobile device is connected to the Wi-Fi network.

• Make sure there is a strong Wi-Fi®signal in the garage where the Wi-Fi Hub will

be mounted. To verify, place your mobile device in the location where the Wi-Fi

Hub will be installed. You mobile device should display two or more bars. If not,

move the router closer to the garage or purchase a Wi-Fi range extender (refer to

the Help section of this User's Guide).

Wi-Fi Hub

Door Sensor

The LEDs are visible

when directly facing

the Wi-Fi Hub.

Light

Blue LED

Green LED

Yellow LED

LED

Test Button

MyQ

Wi-Fi

Home

MyQ

Bluetooth Devices

My Car

Blue LED

Select MyQ

1CONNECT TO NETWORK

Make sure the Wi-Fi signal in the garage is strong and your mobile device is

connected to your home Wi-Fi network.

Connect with mobile device

1. Plug in the Wi-Fi Hub. The blue LED will blink, the Wi-Fi Hub is ready to be

connected to your home Wi-Fi network.

2a. iPhone®or iPod touch®*: Go to Settings > Bluetooth®and turn on Bluetooth.

Select the Bluetooth device with the "MyQ" preﬁx. Click "Allow" to share Wi-Fi

settings then proceed to App store to download MyQ App.

2b. All other mobile devices: Go to settings, select Wi-Fi, then select the network with

the “MyQ” preﬁx and select connect. Once connected, launch the mobile device's

web browser and go to "setup.myqdevice.com". Follow the on-screen instructions

to connect to your home network and download the App.

NOTE: Do not operate the garage door opener until installation has been completed.

3. If the green LED is glowing solid, proceed to step 2 Installation. If the green LED is

not glowing solid, repeat the steps above or proceed to Alternate Method: Connect

with WPS (Wi-Fi Protected Setup).

*Made for:

iPhone 3GS, iPhone 4, iPhone 4S, and iPhone 5

iPod touch (4th and 5th generation)

ALTERNATE METHOD: Connect with WPS (Wi-Fi Protected Setup)

If your router is using WEP security setting, change it to WPA or WPA2.

1. Plug in the Wi-Fi Hub. The blue LED will blink, the Wi-Fi Hub is ready to be

connected.

2. Press and release the BUTTON on the Wi-Fi Hub. The blue LED will turn solid.

3. Press the router’s WPS button to activate WPS mode. It may take a few minutes for

the Wi-Fi Hub to connect to the router. The Wi-Fi Hub’s green LED will turn solid

when the Wi-Fi Hub is connected to your network.

4. Download the Chamberlain MyQ®Home Control App from the App Store or Google

Play. NOTE: Do not operate the garage door opener until installation has been

completed.

5. If the green LED is glowing solid, proceed to step 2 Installation.

Blue LED

WPS Mode

BUTTON

INSTALLATION

1. Choose a location to install the Wi-Fi Hub:

• Wi-Fi Hub light MUST be visible if you're standing in the doorway of the garage

• Wi-Fi Hub MUST be a minimum of two feet away from the garage door opener

2. Place the Wi-Fi Hub in its mounting location, plug it in, and verify the Green LED

turns on solid. NOTE: If the Green LED does not turn on solid, move the router

closer to the garage or install a Wi-Fi range extender.

3. Use the Wi-Fi Hub bracket as a template to drill 5/32" pilot holes. Attach the bracket.

Slide the Wi-Fi Hub onto the bracket.

4. Attach the door sensor vertically on the top panel of the garage door using

fastening strips or screws (provided).

5. Attach the warning placard to the wall next to the door control.

Wi-Fi Hub

(ceiling)

(mounting area)

Door Sensor (with screws)

“TOP” MUST always

face UP

Press

Door Sensor

“TOP” MUST always face UP

Fastening

Strips

Warning

Placard

Door Control

The Wi-Fi Hub will not connect.

• Use your mobile device to verify there is a strong Wi-Fi signal in the garage near the

Wi-Fi Hub. If the Wi-Fi signal strength is weak, the connection may fail. If there is

weak or no signal, move the router closer to the garage or install a Wi-Fi extender.

• iPhone®or iPod touch®: Go to Settings > Bluetooth®and forget the MyQ®device.

Repeat the steps or try connecting using the alternate method (WPS).

• All other mobile devices: If blue LED is not blinking, reset the Wi-Fi Hub to factory

default then repeat the steps or try connecting using the alternate method (WPS).

• Alternate Method (WPS): If the blue LED on the Wi-Fi Hub is ﬂashing, repeat the

alternate method or try connecting with a mobile device. If the blue and green LEDs

are ﬂashing, reset the Wi-Fi Hub, then try connecting with a mobile device.

Reset the Wi-Fi Hub to Factory Default

1. Press and hold the BUTTON on the Wi-Fi Hub until the blue LED blinks.

2. While the blue LED is blinking, press and hold the BUTTON again until the blue

LED pauses then blinks. The Wi-Fi Hub is set to factory default.

What are the buttons on the Wi-Fi Hub for?

The BUTTON is used to reset the Wi-Fi Hub to factory default. Button 1 and 2 are

used to program compatible remote controls and other compatible accessories. For

additional information go to the help section in the App.

What do the LEDs on the Wi-Fi Hub mean?

NEED HELP?

LED COLOR LED STATE WI-FI HUB STATUS

Blue Blinking Wi-Fi needs to be setup

Green and Blue Blinking NO router communication

Blue Solid Wi-Fi setup active

Green Blinking Internet connection failed

Yellow and Green Blinking Programming mode

Green Solid Wi-Fi Connected

Open the App and sign up for an account. Follow the on-screen prompts in the App to

complete your setup. Once setup is complete, use the App to control your garage door.

Apple, iPhone, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries.

The Bluetooth®word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such

marks by The Chamberlain Group, Inc. is under license. Other trademarks and trade names are those of their

respective owners. Wi-Fi®is a registered trademark of Wi-Fi Alliance.

“Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect speciﬁcally

to iPod or iPhone respectively, and has been certiﬁed by the developer to meet Apple performance standards. Apple

is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note

that the use of this accessory with iPod or iPhone may affect wireless performance.

NOTICE: To comply with FCC and/or Industry Canada (IC) rules, adjustment or modiﬁcations of

this transceiver are prohibited. THERE ARE NO USER SERVICEABLE PARTS.

This device complies with Part 15 of the FCC rules and IC RSS-210. Operation is subject to

the following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired

operation. This device must be installed in a way where a minimum 8" (20 cm) distance is

maintained between users/bystanders and device.

ONE YEAR LIMITED WARRANTY

The Chamberlain Group, Inc. warrants to the ﬁrst retail purchaser of this product that is

free from defect in materials and/or workmanship for a period of 1 year from the date of

purchase.

REPLACEMENT PARTS

Description Part Number

Door Sensor 041D7924

Power Supply 041D0270

SOFTWARE AGREEMENT

Use of this product and the software embedded within the product is subject to the

http://www.mychamberlain.com/agreement

Need more help?

Go to the Help section at www.mychamberlain.com,

or call 1-800-528-9131.

114A4656C

The Chamberlain Group, Inc.

845 Larch Avenue

Elmhurst, Illinois 60126-1196

Andere Handbücher für MyQ Garage

Inhaltsverzeichnis

Andere Chamberlain Türöffnungssystem Handbücher

Chamberlain

Chamberlain LiftMaster Premium 8355 Bedienungsanleitung

Chamberlain

Chamberlain T Bedienungsanleitung

Chamberlain

Chamberlain HCTDCU Bedienungsanleitung

Chamberlain

Chamberlain 9747E Series Bedienungsanleitung

Chamberlain

Chamberlain 878MAX Bedienungsanleitung

Chamberlain

Chamberlain K001D8398-1 Bedienungsanleitung

Chamberlain

Chamberlain LiftMaster Professional RDO800 Series Bedienungsanleitung

Chamberlain

Chamberlain T Bedienungsanleitung

Chamberlain

Chamberlain K1A6636 Bedienungsanleitung

Chamberlain

Chamberlain 883LM Bedienungsanleitung

Chamberlain

Chamberlain DKK Series Bedienungsanleitung

Chamberlain

Chamberlain ATS 2113X 1/2 HP Bedienungsanleitung

Chamberlain

Chamberlain LA400DC Bedienungsanleitung

Chamberlain

Chamberlain LMWEKITU Bedienungsanleitung

Chamberlain

Chamberlain ELITE Series Bedienungsanleitung

Chamberlain

Chamberlain 050DCRJWFMC Bedienungsanleitung

Chamberlain

Chamberlain LJ8900W Bedienungsanleitung

Chamberlain

Chamberlain T Bedienungsanleitung

Chamberlain

Chamberlain LiftMaster PROFESSIONAL 76LM Bedienungsanleitung

Chamberlain

Chamberlain Motorlift ML700 Bedienungsanleitung

Chamberlain

Chamberlain Liftmaster MT5011 Bedienungsanleitung

Chamberlain

Chamberlain GSD series Bedienungsanleitung

Chamberlain

Chamberlain CPS-U Bedienungsanleitung

Chamberlain

Chamberlain DDO8900W Bedienungsanleitung

Beliebte Türöffnungssystem Handbücher anderer Marken

Pamex

Pamex KT-INP35 Bedienungsanleitung

Cal-Royal

Cal-Royal N-F77CVR Bedienungsanleitung

Scrigno

Scrigno OPEN1000 Bedienungsanleitung

TriMark

TriMark UM 34 Bedienungsanleitung

BFT

BFT WIND RMB 130B 200 Bedienungsanleitung

Alecto

Alecto ADI-250 Bedienungsanleitung

Besam

Besam Swingmaster MP Leitfaden

CRL

CRL SENIOR PRIMA Bedienungsanleitung

Assa Abloy

Assa Abloy SARGENT 1431 Series Bedienungsanleitung

GAL

GAL MOVFR Technisches Datenblatt

Normstahl

Normstahl IDO7 Bedienungsanleitung

Häfele

Häfele Finetta T 70 VF Bedienungsanleitung

AGS

AGS D-PL Handbuch

Stanley

Stanley MA900ñ Montageanleitung

WITTUR

WITTUR Hydra Plus UD300 Handbuch

Alutech

Alutech TR-3019-230E-ICU Montage- und Bedienungsanleitung

MPC

MPC ATD ACTUATOR 50 ATD-313186 Operating and Technisches Datenblatt

GEZE

GEZE ECturn Bedienungsanleitung