Chord Hugo 2 Bedienungsanleitung

Chord Electronics

Product Communication | English

The Pumphouse, Farleigh Lane, East Farleigh, Kent,

ME16 9NB. Great Britain.

+44 (0) 1622 721 444

info@chordelectronics.co.uk

chordelectronics.co.uk

Hugo 2

Manual

V.2

Chord Electronics

Hugo 2 | User manual

1 Contents

Introduction 2

Registering 3

Description 4

Powering up and charging 5

Connectivity 6

Volume and sample rate 7

Control 8

Remote control 9

Technical speciﬁcations 10

Chord Electronics

Hugo 2 | User manual

2 Introduction

This manual describes all the features of the Hugo 2 DAC/headphone ampliﬁer and contains important

warranty, safety and usage information.

2.1 Safety

•Do not allow the device to come into contact with water or liquids.

•Do not spray cleaning products onto the device. Use a clean microﬁbre cloth to clean the casework.

•A further safety document is included in the box.

•The device does not contain any user-serviceable components. Do not attempt to open, dismantle or

apply internal third-party devices to it. Doing so will void the warranty.

Chord Electronics

Hugo 2 | User manual

3 Registering

The Hugo 2 beneﬁts from a three-

year warranty covering defects in

materials and workmanship through

fair wear and tear. Batteries are

covered for 18 months.

•Register your device online for the best aftersales support.: www.chordelectronics.co.uk/register-

product

In the unlikely event of a claim, contact your supplying dealer.

Chord Electronics

Hugo 2 | User manual

4 Description

The Hugo 2 is an advanced transportable DAC and headphone ampliﬁer. Designed for home or mobile

use, the Hugo 2 transforms sound quality thanks to its cutting-edge proprietary digital audio technology.

4.1 Features

ABD

CEFJK L MG H

AMenu buttons FHeadphone output (3.5 mm) LMicro USB input (charging)

BIR remote window GAnalogue RCA outputs MConnector holes (for 2go)

CViewing window HDual data coaxial input*

DVolume wheel JOptical input

EHeadphone output (6.35 mm) KMicro USB input (source)

* Single coax: tip: signal, sleeve: ground. Dual data coax: tip: signal 1, ring: signal 2 sleeve: ground (for use

with the Hugo M Scaler)

Chord Electronics

Hugo 2 | User manual

5 Powering up and charging

To switch the unit on, press and hold the power button. The device will perform a series of start-up

checks and both the power button and viewing window LEDs will cycle through a range of colours.

Once ﬁnished, the unit will click, indicating it is ready to use.

To charge the device, connect the supplied 2 A Micro USB wall charger to a power source and then to

the Micro USB charging port on the unit. The power button’s colour indicates the unit’s charging status

when on charge, and battery level percentage at other times; use the colour charts below and opposite

as a guide. A full charge is reached in approximately eight hours (approx) with the supplied 2 A charger.

Note, charging times will be elongated considerably with lower current chargers. A minimum 1 A charger

is required.

It is possible to charge the unit and enjoy playback at the same time, plus the unit can be left connected

to its wall charger at all times if desired. In this mode, after 24 hours of charging, the device

automatically enters Intelligent Desktop Mode, which manages power eciently. Use the table below for

charge status colours:

Flashing

Charge the device Charging (2 amp) Charging (1 amp) Charged Intelligent Desktop

Mode activated

TIP After 15 minutes of inactivity, the device will will automatically shutdown, unless in Intelligent Desktop

Mode.

TIP If the batteries are fully depleted, the device will not turn on. Connect to a charger for 30 minutes.

Chord Electronics

Hugo 2 | User manual

To charge/connect to power:

1. Insert the supplied Micro USB cable into the Micro USB charging port L.

2. Connect the wall power adaptor to a suitable power outlet.

3. Once charged and disconnected from a power source, the POWER BUTTON shows one of four

colours to indicate the remaining battery level:

POWER BUTTON

Flashing

0-2 % 2-25 % 25-50 % 50-75 % 75-100 %

NOTE Windows devices will require a driver, downloadable from the Hugo 2 product page:

https://www.youtube.com/watch?v=OOYvSXX5lqg&t=148s

Chord Electronics

Hugo 2 | User manual

6 Connectivity

The Hugo 2 beneﬁts from several digital inputs, including Micro USB, optical, coaxial, and for

convenience, Bluetooth. The coaxial mini-jack input also supports ‘Dual data mode’ (with a dedicated

cable), for use with the Hugo M Scaler (upscaler), enabling 768 kHz ﬁles to be input as two separate (L

and R) 384 kHz data streams.

The device oers RCA analogue outputs, plus two headphone outputs: 3.5 mm and 6.35 mm (1/4-inch).

Chord Electronics

Hugo 2 | User manual

6.35mm

1/4”

Headphone

output

Bluetooth 3.5mm

1/8”

Headphone

output

Right / Left

RCA analogue

3.5mm

Digi coax*

24-BIT/

384kHz x2

Optical

24-BIT/

192kHz

*8Coax 1 conﬁguration = Tip and sleeve, Coax 2 conﬁguration = Ring and sleeve.

TIP To pair a Bluetooth device once the input has been selected, use pairing code: 0000.

Chord Electronics

Hugo 2 | User manual

7 Volume and sample rate

The volume level is controlled using the top-mounted wheel (up/down) and displayed using colour as

indicated below. Before playback, ensure that the volume level is at the lowest possible setting (rotate

downwards) to avoid possible hearing or equipment damage.

MIN MAX

The Hugo 2’s volume can be preset (to a 3 V output) for connection to ampliﬁers etc. Preset volume

mode can be initiated by pressing the X-PHD button when the device is ﬁrst switched on. The volume

wheel colour will then change to purple to indicate the mode is active. The device ‘remembers’ that

present volume mode has been selected until it is deactivated. To deactivate ﬁxed volume mode, lower

the volume manually OR switch the device o. The Hugo2 will refer to the previously user-set volume

when powered on, however, ﬁxed volume mode will have to be manually selected each time the device is

powered on.

NOTE WARNING: Do not activate preset volume mode when using headphones, damage to your

equipment and/or hearing may occur.

7.1 Sample rate

The sample rate of the digital ﬁle being played is indicated using coloured LEDs and can be viewed

through the viewing window on top of the unit. Use the colour chart below as a guide.

Note, both PCM (44.1 kHz-768 kHz/16-bit to 32-bit) and DSD (Native DSD playback up to DSD512), both

with automatic sample rate switching, are supported.

Sample rate in kHz colour guide:

Inhaltsverzeichnis

Andere Chord Verstärker Handbücher

Chord

Chord Etude Bedienungsanleitung

Chord

Chord CPA 2500 Bedienungsanleitung

Chord

Chord 173.012UK Bedienungsanleitung

Chord

Chord SPM 1050 Bedienungsanleitung

Chord

Chord TToby Bedienungsanleitung

Chord

Chord CPA5000 Bedienungsanleitung

Chord

Chord PRIMA Bedienungsanleitung

Chord

Chord Mojo2 Bedienungsanleitung

Chord

Chord SPM 6000 Mk2 Bedienungsanleitung

Chord

Chord PRIMA Gebrauchsanweisung

Chord

Chord Mojo Bedienungsanleitung

Chord

Chord Hugo Bedienungsanleitung

Chord

Chord TToby Bedienungsanleitung

Chord

Chord SPM 1200 MK2 Bedienungsanleitung

Chord

Chord SPM 1400 MK2 Bedienungsanleitung

Chord

Chord ULTIMA PRE 2 Bedienungsanleitung

Chord

Chord ULTIMA PRE Bedienungsanleitung

Chord

Chord DAVE Bedienungsanleitung

Chord

Chord ULTIMA 5 Bedienungsanleitung

Chord

Chord DAVE Bedienungsanleitung

Chord

Chord CPM 2650 Bedienungsanleitung

Chord

Chord ULTIMA 3 Gebrauchsanweisung

Chord

Chord ULTIMA 2 Bedienungsanleitung

Chord

Chord TToby Gebrauchsanweisung

Beliebte Verstärker Handbücher anderer Marken

ASTRO

ASTRO HVO V40 P Bedienungsanleitung

Marantz

Marantz SUPERSCOPE BLA-545 Montageanleitung

NAD

NAD CI980 Bedienungsanleitung

Technics

Technics SE-CH770 Bedienungsanleitung

Harman Kardon

Harman Kardon HK6300 Bedienungsanleitung

NAD

NAD T975 Bedienungsanleitung

McIntosh

McIntosh MA6850 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Bedienungsanleitung

Viatron

Viatron Autrix Bedienungsanleitung

GME

GME GA9800 Bedienungsanleitung

Atlas

Atlas CP700 Bedienungsanleitung

Roland

Roland KC-1000 Bedienungsanleitung

Pyle

Pyle PFMRA350BW Bedienungsanleitung

Advantage

Advantage S-250 Bedienungsanleitung

IRT Electronics

IRT Electronics DVA-3007 Bedienungsanleitung

Dimavery

Dimavery BA-100 Series Bedienungsanleitung

Sony

Sony XM-S400D Bedienungsanleitung

Schertler

Schertler ROY X Bedienungsanleitung