Chord ULTIMA 5 Bedienungsanleitung

Chord Electronics

Product Communication | English

The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB. Great Britain.

+44 (0) 1622 721 444

info@chordelectronics.co.uk

chordelectronics.co.uk

ULTIMA 5

Manual

V.1.0

Chord Electronics

ULTIMA 5 | Manual

2 // 24

Contents 0.0

1.0 Safety instructions 03

1.1 Introduction 04

1.2 Protection against liquids & heat 05

1.3 Dismantling & Radio 06

frequency interference

1.4 Connecting your equipment 07

2.0 Warranty 08

2.1 Warranty period & registering 09

your purchase

2.2 Making a claim & warranty exclusions 10

0.0 Contents

3.0 Getting to know ULTIMA 5 11

3.1 Getting to know ULTIMA 5 12

3.2 The front panel 13

3.3 The top panel 14

3.4 The rear panel 15

4.0 Setting up ULTIMA 5 16

4.1 Placement 17

4.2 Connecting ULTIMA 5 to 18

ancillary equipment

4.3 Audio inputs 19

4.4 Audio outputs 20

4.5 Power-on sequence and 12V trigger 21

4.6 Earthing issues in Europe 22

4.7 Adjusting the brightness of the LED‘s 23

Chord Electronics

ULTIMA 5 | Manual

1.1 Introduction

1.2 Protection against liquids & heat

1.3 Dismantling & Radio Frequency interference

1.4 Connecting your equipment

1.0 Safety

instructions

Safety instructions 1.0

3 // 24

Chord Electronics

ULTIMA 5 | Manual

4 // 24

Introduction 1.1

ULTIMA 5 is an

incredibly reliable

and technologically

advanced stereo power ampliﬁer.

It is our most powerful stereo

ampliﬁcation oering within the

Full Size range.

Before operation, we strongly

advise that you read this user

manual thoroughly, storing it

in a safe place along with your

original receipt of purchase,

in case you should require

assistance in the future.

1.1 Introduction

1.2 Protection against

liquids & heat

1.3 Dismantling & radio frequency

interference

1.4 Connecting your equipment

Chord Electronics

ULTIMA 5 | Manual

Protection against

liquids & heat

1.2

The ULTIMA 5 is not

protected against liquids

of any kind. Never place

containers of liquid on ULTIMA

5. Never allow ULTIMA 5 to come

into contact with moisture or

liquids; doing so could result in

electrocution or damage to the

ULTIMA 5 internal circuitry.

Be aware that liquids, including

water that has dried, can leave

minerals that can aect the

PCB and other components,

which could eventually lead to

oxidisation and short-circuiting.

If the ULTIMA 5 comes into

contact with moisture or liquids,

immediately disconnect from

the mains power supply, and

connected equipment, and

contact Chord Electronics for

further advice.

The ULTIMA 5 has

internal thermal

protection that will cut

the power supply if reached.

Never operate the ULTIMA 5 near

sources of heat or naked ﬂames

as this will decrease the lifespan

of the internal components. It is

advised that you do not operate

the ULTIMA 5 in an area of direct

sunlight or on top of signiﬁcant

heat- producing devices.

Please be aware that it is

entirely normal for the ULTIMA

5 to become warm during

use, particularly within a

stacked conﬁguration. If you

are concerned about the

temperatures, please switch

the device o and consider a

dierent placement.

1.1 Introduction

1.2 Protection against

liquids & heat

1.3 Dismantling & radio frequency

interference

1.4 Connecting your equipment

5 // 24

Chord Electronics

ULTIMA 5 | Manual

6 // 24

There are no user-

serviceable components

within the ULTIMA 5

or its power supply. Dangerous

voltages/currents exist within

the ULTIMA 5 and its power

supply, posing a severe risk of

electrocution and/or ﬁre.

Never attempt to

open, dismantle or

apply internal third-

party devices to it or insert

anything other than the listed

interconnects or speaker cables

within this user manual.

If the ULTIMA 5 develops a

fault or the casework becomes

damaged, immediately

disconnect from the mains power

supply and connected equipment

and contact Chord Electronics

for further advice.

1.1 Introduction

1.2 Protection against

liquids & heat

1.3 Dismantling & radio frequency

interference

1.4 Connecting your equipment

Dismantling & radio

frequency interference

1.3

With a thick, solid aluminium

chassis, the ULTIMA 5’s casework

largely protects the sensitive

internal circuitry from radio

frequency interference. However,

for optimal performance, it is

recommended that the following

points are observed:

1.Consider placing the

ULTIMA 5 away from

wireless routers.

2.Separate the

ULTIMA 5 from

ampliﬁers using

toroidal transformers.

3.Operate mobile

phones at a distance

to avoid interference.

Although the ULTIMA

5is largely shielded,

it can generate radio

frequency interference that

may have an eect on radio

and television reception. If this

occurs, please reconsider your

placement.

Chord Electronics

ULTIMA 5 | Manual

Before connecting the ULTIMA

5 to any equipment, consult the

manufacturer’s user guide to

conﬁrm compatibility.

When connecting the ULTIMA

5 to any equipment, make sure

that all devices are o, including

the ULTIMA 5. Once connected,

switch all equipment on starting

with the source and ending with

the ampliﬁer. Initially, operate

the ULTIMA 5 with your preamp/

and any connected sources on

their lowest gain settings and

lowest volume settings, gently

increasing to a comfortable

listening level. Never operate

the ULTIMA 5 at excessive

sound levels; permanent hearing

damage and loss can occur.

ULTIMA 5 is supplied with its

own grounded 16A-rated mains

IEC cable and it is important

that the ampliﬁer is earthed at

all times via this cable, or an

appropriate alternative. Failure to

do this could be hazardous in the

unlikely event of a fault.

The supplied region-speciﬁc

16A mains IEC cable can be

substituted for an alternative

power cable, however, please

make sure that it has an earth. If

any cable becomes damaged you

must immediately discontinue

use and replace it to avoid the

risk of electrocution.

ULTIMA 5 must be permanently

connected to a source of power.

The included mains lead simply

plugs into the ULTIMA 5 IEC

mains socket. If the mains lead

is prematurely disconnected.

ULTIMA 5 may still hold charge

for up to 15 minutes.

1.1 Introduction

1.2 Protection against

liquids & heat

1.3 Dismantling & radio frequency

interference

1.4 Connecting your equipment

Connecting your equipment 1.4

WARNING: Never

disconnect the

power cable during

operation. Only disconnect

when ULTIMA 5 is o. If the

power cable is disconnected

during operation there is a

risk of damage to connected

equipment.

7 // 24

Chord Electronics

ULTIMA 5 | Manual

2.1 Warranty period & registering your purchase

2.2 Making a claim & warranty exclusions

2.0 Warranty

Warranty 2.0

8 // 24

Chord Electronics

ULTIMA 5 | Manual

9 // 24

2.1 Warranty period & registering

your purchase

2.2 Making a claim & warranty

exclusions

Warranty period & registering

your purchase

2.1

At point of sale, Chord

Electronics Ltd. provides the

ULTIMA 5 with a comprehensive

ﬁve-year warranty* which

covers defects in materials and

workmanship through fair wear

and tear.

*The warranty is transferable

with proof of purchase,

however is not available on ex-

demonstration products.

Please use the form

below to record the

details of your purchase

in the event that these are

required at a later date, we

further advise that all purchases

are registered with Chord

Electronics at: chordelectronics.

co.uk/register-product/

RETAILER:

PURCHASE PRICE:

UNIT COLOUR:

DATE OF PURCHASE:

TRANSACTION ID:

Chord Electronics

ULTIMA 5 | Manual

In the unlikely event of a

claim, you must provide Chord

Electronics with the details of

the claim, including your original

proof of purchase and serial

number in order to validate the

nature of the repair.

Upon receipt, Chord Electronics

will make an assessment within

30 days and provide a reasonable

solution.

All warranty repairs must be

carried out by Chord Electronics

or an approved service centre to

guarantee the quality and safety

of the repair.

WARRANTY EXCLUSIONS: The

warranty does not cover connected

equipment, personal injury or

development natural patina of the

metalwork and will be null and void

if the following is applied: wilful

neglect; modiﬁcation or tampering

of the product; improper use of the

product; acts of God; damage caused

by a connected device; mechanical

shock; ﬁre or application of excessive

heat or repair/modiﬁcation by a non-

authorised third-party vendor.

2.1 Warranty period & registering

your purchase

2.2 Making a claim & warranty

exclusions

Making a claim

& warranty exclusions

2.2

10 // 24

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Chord Verstärker Handbücher

Chord

Chord Etude Bedienungsanleitung

Chord

Chord Hugo2 Bedienungsanleitung

Chord

Chord Hugo Bedienungsanleitung

Chord

Chord BerTTi Bedienungsanleitung

Chord

Chord CVH-40 Bedienungsanleitung

Chord

Chord ULTIMA PRE Bedienungsanleitung

Chord

Chord Indigo Digital Preamplifier Bedienungsanleitung

Chord

Chord HugoTT Bedienungsanleitung

Chord

Chord Mojo Bedienungsanleitung

Chord

Chord Hugo2 Bedienungsanleitung

Chord

Chord Hugo TT 2 Bedienungsanleitung

Chord

Chord TToby Bedienungsanleitung

Chord

Chord CPM 2650 Bedienungsanleitung

Chord

Chord CB-25 Bedienungsanleitung

Chord

Chord CB-SERIES Bedienungsanleitung

Chord

Chord Etude Bedienungsanleitung

Chord

Chord 173.442 Bedienungsanleitung

Chord

Chord ULTIMA PRE Gebrauchsanweisung

Chord

Chord PRIMA Bedienungsanleitung

Chord

Chord CPA 3200E Bedienungsanleitung

Chord

Chord 173.012UK Bedienungsanleitung

Chord

Chord SPM 1050 Bedienungsanleitung

Chord

Chord SYMPHONIC Bedienungsanleitung

Chord

Chord SPM 650 Bedienungsanleitung

Beliebte Verstärker Handbücher anderer Marken

ASTRO

ASTRO HVO V40 P Bedienungsanleitung

Marantz

Marantz SUPERSCOPE BLA-545 Montageanleitung

NAD

NAD CI980 Bedienungsanleitung

Technics

Technics SE-CH770 Bedienungsanleitung

Harman Kardon

Harman Kardon HK6300 Bedienungsanleitung

NAD

NAD T975 Bedienungsanleitung

McIntosh

McIntosh MA6850 Bedienungsanleitung

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Bedienungsanleitung

Viatron

Viatron Autrix Bedienungsanleitung

GME

GME GA9800 Bedienungsanleitung

Atlas

Atlas CP700 Bedienungsanleitung

Roland

Roland KC-1000 Bedienungsanleitung

Pyle

Pyle PFMRA350BW Bedienungsanleitung

Advantage

Advantage S-250 Bedienungsanleitung

IRT Electronics

IRT Electronics DVA-3007 Bedienungsanleitung

Dimavery

Dimavery BA-100 Series Bedienungsanleitung

Sony

Sony XM-S400D Bedienungsanleitung

Schertler

Schertler ROY X Bedienungsanleitung