Visit www.cla-valpacic.com for more details. Contact the Factory at info@cla-valpacic.com 2
Mounting Instructions
Install the VC12 on the wall
a) Fix the wall-mounting plate with the provided screws
b) Mount the VC12 on the wall-mount fixing plate
c) Secure with the wing nuts provided
IMPORTANT!
For communicating devices, if the antenna is plugged directly
on the device (without extension lead), please ensure that the
VC12 is mounted vertically with the USB and antenna connectors
on the top.
The connection to the VC12 controller is made via circular plug
connectors which are pre-wired, therefore no internal wiring is
necessary. Each connector has a pre-defined function which
only allows the relevant component to be connected (dedicated
connectors).
1
3
4Connect the various elements to the VC12
VC12 controller packaging
delivered with accessories
a)
b)
c) Antenna
USB
Flow: Flowmeter connection
P1: Inlet pressure sensor connection
P2: Outlet pressure sensor connection
e-Power MP : e-Power X-143MP/2MP turbine connection
3
4
15
6
2
1. Wall-mount fixing bracket
2. VC12 controller
3. Magnetic stick
4. Calibration certificate and
USB stick
5. Antenna (optional)
6. Pressure sensor(s)
ratiometric
a) To run the VC12, connect the e-Power-MP connector
or the start key on socket (a)
b) When the connector above is connected,
the VC12 is powered (internal battery is activated)
c) When the connector is removed from socket (a),
the VC12 is disabled (internal battery is de-activated)
d) IMPORTANT!
To access the internal USB port, perform operation in a dry
and clean environment. If not possible, make sure that no
humidity or dust enters the device.
Run the VC12
d)
(a)
