clage Zip CEX9 Bedienungsanleitung
Zip
Instantaneous Hot Water
Electronically controlled instantaneous water heater
CEX9: 27900 - 50 °C model
Installation instructions
For 50°C models, the appliance delivers water not exceeding 50°C in accordance with AS3498
2
Instructions for installer - CEX9 - 801040 - January 2019 v1.10 Art.no: 9120-25687
Contents
1. Safety instructions..............................................................................................3
2. Overview ..................................................................................................... 5
3. Technical data .................................................................................................6
4. Dimensions ................................................................................................... 6
5. Typical installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
6. Installation....................................................................................................8
Installation site ................................................................................................ 8
Mounting the appliance ......................................................................................... 9
Installing the appliance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
7. Electrical connection ...........................................................................................10
Wiring diagram ...............................................................................................10
Structural prerequisites.........................................................................................10
Electrical connection (only by a qualified tradesperson) ..............................................................10
Electrical connection with pre-installed power cable.................................................................10
Electrical installation to a permanent connection ...................................................................11
8. Initial operation...............................................................................................12
Selection of power rating .......................................................................................12
Reinstallation.................................................................................................13
Lock level ....................................................................................................13
9. Service menu .................................................................................................14
10. Environment and recycling.....................................................................................15
The alignment template is located on the pull-out pages in the middle of this manual.
3
Instructions for installer - CEX9 - 801040 - January 2019 v1.10 Art.no: 9120-25687
Please read these instructions carefully before installing or using the appliance!
Keep the instructions handy with the appliance for future use!
Installation, initial operation and maintenance of this appliance must only be con-
ducted by an authorised professional, who will then be responsible for adherence to
applicable standards and installation regulations. We assume no liability for any dam-
ages caused by failure to observe these instructions.
• Do not use the appliance until it has been correctly installed and unless it is
in perfect working order.
• Do not remove the front cover under any circumstances before switching off
the mains electrical supply to the unit.
• Never make technical modifications, either to the appliance itself or the
electrical leads and water pipes.
• The appliance must be earthed at all times.
• Pay attention to the fact that water temperatures in excess of approx. 43 °C
are perceived as hot, especially by children, and may cause a feeling of
burning. Please note that the fittings and taps may be very hot when the
appliance has been in use for some time.
• The appliance is only suitable for domestic use and similar applications
inside closed rooms, and must only be used to heat incoming water from
the mains supply.
• The appliance must never be exposed to frost.
• The values stated on the rating plate must be observed.
• In case of malfunction, disconnect the fuses immediately. In case of leaks,
cut off the mains water supply instantly. Repairs must only be carried out by
the customer service department or an authorised professional.
• This appliance can be used by children aged 3years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or instruction concern-
ing use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance
shall not be performed by children without supervision.
• If the appliance is factory equipped with a power supply cable, it must be
replaced with an original spare cable from the manufacturer in case of dam-
1. Safety instructions
4
Instructions for installer - CEX9 - 801040 - January 2019 v1.10 Art.no: 9120-25687
To observe additionally for pressureless installation:
• The water outlet behind the devices must not be blocked, and the water
flow must not be restricted.
• The water outlet facilities, such as shower head, jet control and other outlet
unit, must be decalcified regularly. Deposits must be removed in regular
intervals.
• Only the fittings recommended by the manufacturer may be used.
• If the appliance is exclusively connected to a single shower, only the shower
heads recommended by the manufacturer may be used. No other fittings or
appliances which decrease the water flow to the shower may be installed.
1. Safety instructions
age by an authorised technician in order to avoid any hazards.
• For appliances with direct connection, an all-pole disconnecting device
with a contact opening width of ≥3mm per phase must be provided at the
installation end, according to Australian wiring rules AS/NZ3000.
• The wall bracket must be secured with the supplied screws and dowels. The
appliance must be secured to the wall bracket. The appliance may only be
operated if it has been properly mounted on the wall bracket.
• The prescribed nominal pressure stated on the rating plate may not be
exceeded at any time.
• The required water resistance may not fall below the value stated on the
rating plate at any time.
5
Instructions for installer - CEX9 - 801040 - January 2019 v1.10 Art.no: 9120-25687
2. Overview
When ordering spare parts, please always specify the appliance model and serial number.
Parts in Bold Type are available as Spare Parts. Other parts are available on request
Pos. Part.-No. Description
1 Grommet
2 Connecting terminal
3 99394 Flow sensor
4 99385 Non-return valve
5 99398 PCB CEX9
6 99418 CEX control panel
7 Inlet pipe
8 CEX cover
Pos. Part.-No. Description
9 Inlet filter
10 Connection piece 1/2“
11 Safety thermal cut-out
12 99400 Thermal sensor set
13 Heating element incl. SDB
14 Bottom part
15 99397 Screws and dowels
12
13
14
15
6
7
8
5
4
3
2
1
10
11
9
6
Instructions for installer - CEX9 - 801040 - January 2019 v1.10 Art.no: 9120-25687
3. Technical data
Model CEX9
Part no. 27900 - 50 °C model
Energy efficiency class A *)
Rated capacity (Rated current) 6.0 / 9.6 kW (27.3 / 40 A)
Chosen capacity (Chosen current) 6.6 kW (28.7 A) 8.8 kW (38.3 A)
Electrical connection 1/N/PE 220..240 V AC
Min. required cable size see note 1)
Hot water (l/min)
max. at ∆t = 25 K 3.8 5.0
Rated volume 0.3 l
Rated pressure 1.0 MPa (10 bar)
Connecting type pressure resistant / pressureless
Heating system Bare wire heating system IES®
Required spec. water
resistance @ 15 °C
Spec. electrical conductivity
≥ 1100 Ωcm
≤ 90.9 mS/m
Inlet temperature ≤ 70 °C
Flow rate to switch on – max. flow rate 2.0 – 5.0 l/min 2)
Pressure loss 0.2 bar at 2.5 l/min 1.3 bar at 9.0 l/min 3)
Temperature choice 20 °C – 50 °C
Water connection G ½"
Weight (when filled w. water) 2.7 kg
VDE class of protection I
Type of protection / safety IP25
*) The declaration complies with the EU regulation No812/2013
1) The cross sectional area of the connection cable must be in accordance with the power rating of the appliance and the specific requirements of AS/NZS 3000
2) Flow rate limited to achieve optimum temperature rise
3) Without flow regulator
4. Dimensions
108
37
312
100
177
108
37
312
100
177
Dimensions in mm
7
Instructions for installer - CEX9 - 801040 - January 2019 v1.10 Art.no: 9120-25687
5. Typical installation
0
MADEIN GERMANY
MADEIN GERMANY
MADEIN GERMANY
177
294
100
Wall mounted mixer: Supply for one sink Direct connection: Supply for one outlet
Direct connection: Supply for multiple outlets
Top edge of shower cabin approx. 1950
Top edge of handwash basin approx. 850
Bottom edge of application approx. 1200
Dimensions in mm (installation example)
8
Instructions for installer - CEX9 - 801040 - January 2019 v1.10 Art.no: 9120-25687
Installation site
• Appliance must only be installed in frost-free rooms. Never expose appliance to
frost.
• The Appliance must be wall mounted and has to be installed with water connectors
downward.
• The appliance complies with protection type IP25.
• To avoid thermal losses and dead legs, the distance between the instantane-
ous water heater and the furthest outlet should be kept as short as possible
(<6meters). In addition all hot water pipe work should be insulated in accordance
with AS/NZS 3500.
• For maintenance work, a shut-off valve should be installed in the supplyline. The
appliance must be accessible for maintenance work.
• The specific resistance of the water must be at least 1100Ωcm at 15 °C. The specific
resistance can be asked for with your water distribution company.
• For 50°C models: The appliance delivers water not exceeding 50 °C in accordance
with AS3498.
6. Installation
The following regulations must be observed:
• Installation must comply with all statutory regulations, as well as those of the
local electricity and water supply companies.
• The rating plate and technical specifications
• Only intact and appropriate tools must be used
• Installation must comply with all statutory regulations, AS/NZS 3000, AS/NZS
3500, as well as those of the local electricity and water supply companies
• These instructions must be read and fully understood before commencing the
installation. If in doubt, or in need of further guidance please ring Zip
on 1800 638 633
Kabeleinführung / Cable entry
4,2 × 38mm
Ø6mm
600mm max
38
27
312 108
37
177
100
Anschlussraum
Connection zone
Cable entry
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere clage Boiler Handbücher
clage
clage MH3-O Bedienungsanleitung
clage
clage DCX Next Bedienungsanleitung
clage
clage Zip DSX ELECTRONIC MPS 27940 Bedienungsanleitung
clage
clage DSX Touch Bedienungsanleitung
clage
clage DEX 12 Bedienungsanleitung
clage
clage Zip DBX18 BASITRONIC Bedienungsanleitung
clage
clage MBX4 Shower Bedienungsanleitung
clage
clage GERMAN POOL DSN Bedienungsanleitung
clage
clage Zip Hydroboil 25 Bedienungsanleitung
clage
clage CEX-U ELECTRONIC MPS Bedienungsanleitung
clage
clage DSX Touch Bedienungsanleitung
clage
clage FUNKTRONIC MPS CFX-U Bedienungsanleitung
clage
clage DEX Bedienungsanleitung
clage
clage DBX 18 Bedienungsanleitung
clage
clage S 10 Bedienungsanleitung
clage
clage CEX 9-U Bedienungsanleitung
clage
clage CEX 9-U ELECTRONIC MPS Bedienungsanleitung
clage
clage MCX 3 Bedienungsanleitung
clage
clage DBX 18 BASITRONIC Bedienungsanleitung
clage
clage CDX 7-U Bedienungsanleitung
Beliebte Boiler Handbücher anderer Marken
Kenmore
Kenmore 153.582400 Bedienungsanleitung
Applimo
Applimo Edel AIR Bedienungsanleitung
STIEBEL ELTRON
STIEBEL ELTRON Eltronom SHU 5 S Bedienungsanleitung
Toyotomi
Toyotomi Oil Miser OM-180 Bedienungsanleitung
Bradford White
Bradford White EF Series Bedienungsanleitung
Eccotemp
Eccotemp 40-H Bedienungsanleitung
