Clarke Contractor CON305 Bedienungsanleitung

OPERATION & MAINTENANCE

INSTRUCTIONS

ORIGINAL INSTRUCTIONS GC0320 - ISS 1

12” VENTILATOR

MODEL NO: CON305 (110V)

PART NO: 3230480

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INTRODUCTION

Thank you for purchasing this CLARKE Ventilator which is designed for indoor

use in an industrial environment.

Read this manual carefully, in doing so you guarantee the safety of yourself

and that of others around you, and you can look forward to your purchase

giving you long and satisfactory service.

SAFETY WARNINGS

Make sure that you read, understand and comply with the following warnings.

POSITIONING

Be aware that the suction capability is considerable. Do not position the

ventilator where it will blow dust or hazardous fumes at people.

DO NOT place the ventilator close to any wet surface. DO NOT place against

any surface such as a wall, door or furniture etc.

DO NOT place the ventilator on a raised surface or anywhere it could topple

over.

Only use the ventilator in a level position.

Ensure that the intake grille cannot be blocked by curtains or other fabrics. Do

not allow loose clothing, long hair, jewellery etc. to be drawn into the intake

side of the fan.

DO NOT operate the ventilator in explosive atmospheres such as in the

presence of flammable liquids, gases or dust such as in a paint spray booth.

Electric motors create sparks which may ignite dust or fumes.

DO NOT cover the fan or obstruct the air inlet and outlet sections of the

ventilator.

DO NOT get the ventilator wet or use in areas of high condensation.

DO NOT allow the power cable to touch hot surfaces.

DO NOT operate without the safety grills secured in position.

PERSONNEL SAFETY

DO NOT use the ventilator when you are tired or under the influence of

alcohol, drugs or intoxicating medication.

DO NOT stand on the ventilator.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DO NOT use the ventilator with wet hands or when there is water on the power

cable.

Young children must be kept away unless supervised.

ELECTRICAL SAFETY

Inspect the power cable / plug for damage/looseness. Do not use the

ventilator if the power cable is damaged.

Make sure that the voltage on the product label is the same as the voltage of

the power supply. If in doubt, consult a qualified electrician.

DO NOT abuse the electrical cable. Do not use the cable for pulling or

unplugging the ventilator.

Keep the cable away from sources of heat, oil, sharp edges or moving parts.

Damaged or tangled cables increase the risk of electric shock.

DO NOT use extension cables with this ventilator.

SERVICE & REPAIRS

Check that the ventilator is in good working order. Take immediate action to

have it repaired or any damaged parts replaced.

DO NOT attempt to repair the ventilator yourself. Always contact the CLARKE

service department who will use recommended parts only. Unapproved parts

may be dangerous and will invalidate your warranty.

ENVIRONMENTAL RECYCLING POLICY

By purchasing this product, the customer is taking on the obligation

to deal with its safe disposal in accordance with the Waste Electrical

and Electronic Equipment regulations (WEEE).

In effect, this means that this product must not be discarded with

general household waste but according to the laws governing Waste

Electrical and Electronic Equipment (WEEE) at a recognized disposal facility.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12

months from the date of purchase. Please keep your receipt as proof of

purchase. This guarantee is invalid if the product is found to have been

abused, tampered with, or not used for the purpose for which it was intended.

Faulty goods must be returned to their place of purchase, no product can be

returned to us without prior permission.

This guarantee does not effect your statutory rights.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

This product can be connected to one of the following power supplies:

• 110V generator

• 110V isolating transformer

• 110V site supply

• 230V generator via a 110V transformer.

Connecting it to any other power source may cause damage.

This product includes a fitted industrial plug to BS-EN

60309, and a cable for use with a 110 volt supply. On

no account must a 230V, 13amp (BS1363) plug be

used.

If using a portable 110V transformer make sure it has a

rated capacity sufficient to take the load of the fan.

Should the plug need changing at any time, ensure

that a plug of identical specification is used and

proceed as follows:

1. Undo the socket screws & remove the rear section.

2. Rotate the cable clamp clear of the terminals.

3. Feed the cable through the rear gland in the plug.

4. Remove the cable sheath to the required lengths

as shown in the diagram.

5. Terminate the correct wires in the

correct terminal blocks as shown.

6. Remove the cable clamp screws. Clip

the cable clamp back into position and

place the clamp around the outer

sheath of the cable. Replace the screws

and tighten until the cable is securely

held.

7. Replace the rear cover and tighten the cover screws.

If in any doubt, consult a qualified electrician. DO NOT attempt any repairs

yourself.

WARNING! READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO A

POWER SUPPLY.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

BEFORE USE

Before commencing assembly, check for damage and or shortages etc, any

damage or shortage should be reported to your CLARKE dealer where the

ventilator was purchased.

This ventilator can be used with

CLARKE 12” diameter retractable

ducting sold separately in 5 metre

lengths as follows:

Yellow (3230481)

1. Before use, attach the ducting to

the discharge end of the

ventilator as shown, secured with

the tie cord provided.

2. Place the ventilator in a level

position on a flat surface and at a safe distance from flammable materials.

3. The ventilator is operated by the ON/OFF switch.

4. Connect the ventilator to a suitable power outlet.

CARE & MAINTENANCE

Clean the ventilator with a soft damp cloth, Do not use solvents or abrasives.

If used in spaces with high dust content, clean the guards and fan blades by

vacuuming or wiping. Remove the end guard to gain access to the blades.

REPLACE GUARD BEFORE RE-CONNECTING TO POWER SUPPLY.

No other maintenance is required, should you discover any problem with the

ventilator return it to the CLARKE service department for repair.

Should the fan fail to operate, check the power supply and that the fuse in the

plug has not blown. Abnormal noise while the fan is running may occur if the

fan is not standing on a level surface.

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE

PERFORMING ANY CLEANING OR MAINTENANCE TASKS. REPAIRS

SHOULD BE CARRIED OUT BY THE CLARKE SERVICE DEPARTMENT.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SPECIFICATIONS

Model CON305 (110v)

Product dimensions complete (L x W x H) 375 x 386 x 430 mm

Drum diameter 380 mm

Fan diameter 300 mm

Product weight 15.35kg

Power supply 110V/50Hz

Electrical Insulation class II

Ingress protection rating IP54

Operating temperature range -20 to 50oC

Sound power level 69 dB

Rpm @ optimum energy efficiency 2866 rpm

Flow rate @ full speed 3900 m3/h

Rated air flow @ overall efficiency point 2379.7 m3/h

Rated air flow @ optimum energy efficiency 39.7 m3/s

Total pressure 385 Pa

Static pressure 236.1 Pa

Overall efficiency 51.8%

Measurement category C

Efficiency category Static

Efficiency grade 40

Rated motor input power @ optimum energy

efficiency

500W

Specific Ratio (EU no 327/2011) N/A

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DECLARATION OF CONFORMITY

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Clarke Lüfter Handbücher

Clarke

Clarke CAM24R Bedienungsanleitung

Clarke

Clarke Air CBF20 Bedienungsanleitung

Clarke

Clarke CAM6000 Installations- und Betriebshandbuch

Clarke

Clarke Air Series Bedienungsanleitung

Clarke

Clarke CDF20HV-B Installations- und Betriebshandbuch

Clarke

Clarke air CAM200 Installations- und Betriebshandbuch

Clarke

Clarke CAM30B Bedienungsanleitung

Clarke

Clarke CONTRACTOR CON500 Bedienungsanleitung

Clarke

Clarke CFF18B100 Bedienungsanleitung

Clarke

Clarke CAM24B Bedienungsanleitung

Clarke

Clarke CAM400 Bedienungsanleitung

Clarke

Clarke CSF2 Bedienungsanleitung

Clarke

Clarke AIR CAM6000 Bedienungsanleitung

Clarke

Clarke Air CAM900 Installations- und Betriebshandbuch

Clarke

Clarke CAM110 Bedienungsanleitung

Clarke

Clarke Air CAM5002 Bedienungsanleitung

Clarke

Clarke CPF18B Bedienungsanleitung

Clarke

Clarke CAM500 Bedienungsanleitung

Clarke

Clarke CONTRACTOR CON350 Bedienungsanleitung

Clarke

Clarke Air CDF18HV-B Installations- und Betriebshandbuch

Clarke

Clarke CAF304 Bedienungsanleitung

Clarke

Clarke CAM24C Bedienungsanleitung

Clarke

Clarke CAM20R Bedienungsanleitung

Clarke

Clarke CFF18C100 Bedienungsanleitung

Beliebte Lüfter Handbücher anderer Marken

ELTA FANS

ELTA FANS H03VV-F Bedienungsanleitung

Hunter

Hunter 20714 Gebrauchsanweisung

Emerson

Emerson CARRERA VERANDA CF542ORB00 Bedienungsanleitung

Hunter

Hunter Caraway Gebrauchsanweisung

Panasonic

Panasonic FV-15NLFS1 Bedienungsanleitung

Kompernass

Kompernass KH 1150 Bedienungsanleitung

VES

VES FALA100/12V/TR Bedienungsanleitung

Vertiv

Vertiv Liebert DCD Bedienungsanleitung

Westinghouse

Westinghouse GFP Series Bedienungsanleitung

Venmar

Venmar KUBIX HRV PLUS Series Bedienungsanleitung

Maico

Maico ECR 31 Bedienungsanleitung

Sonnenkonig

Sonnenkonig Dinky Bedienungsanleitung

S&P

S&P ECOWATT HXBR Bedienungsanleitung

Wider

Wider IMP03369BH Bedienungsanleitung

Panasonic

Panasonic F-60DHN Bedienungsanleitung

Broan

Broan 766BN Bedienungsanleitung

Premium

Premium PFS16022 Montageanleitung

Litex Industries

Litex Industries E-CGL52CB5C1 Bedienungsanleitung