Clarke CAM400 Bedienungsanleitung

OPERATION & MAINTENANCE

INSTRUCTIONS

ORIGINAL INSTRUCTIONS GC0120 - ISS 1

16” VENTILATION FAN

MODEL NO: CAM400 (230V)

PART NO: 3230240

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INTRODUCTION

Thank you for purchasing this CLARKE Ventilation Fan which is designed for

indoor use in an industrial environment.

Read this manual carefully, in doing so you guarantee the safety of yourself

and that of others around you, and you can look forward to your purchase

giving you long and satisfactory service.

SAFETY RULES

Make sure that you read, understand and comply with the following rules.

POSITIONING

This fan is designed for indoor use only.

Be aware that the suction capability is considerable. Do not position the fan

where it will blow dust, chips or hazardous fumes at people.

DO NOT place the fan close to any wet surface. DO NOT place against any

surface such as a wall, door or furniture etc.

DO NOT place the fan on a raised surface or anywhere it could topple over.

Only use the fan in a level position.

Take care to ensure that the intake grille cannot be blocked by curtains or

other fabrics. Do not allow loose clothing, long hair, jewellery etc. to be drawn

into the intake side of the fan.

DO NOT operate the fan in explosive atmospheres such as in the presence of

flammable liquids, gases or dust such as in a paint spray booth. Electric motors

create sparks which may ignite dust or fumes.

DO NOT cover the fan or obstruct the air inlet and outlet sections of the

ventilator.

DO NOT get the fan wet or use in areas of high condensation.

DO NOT allow the power cable to touch hot surfaces.

ALWAYS make sure the brakes are engaged before operating.

DO NOT operate without the safety grills secured in position.

PERSONNEL SAFETY

DO NOT use the fan when you are tired or under the influence of alcohol,

drugs or intoxicating medication.

DO NOT stand on the fan.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DO NOT use with wet hands or when there is water on the power cable.

Young children must be kept away unless continuously supervised.

ELECTRICAL SAFETY

Inspect the power cable/plug for damage/looseness. Do not use the fan if the

power cable is damaged.

Make sure that the voltage on the product label is the same as the voltage of

the power supply. If in doubt, consult a qualified electrician.

DO NOT abuse the electrical cable. Do not use the cable for pulling or

unplugging the fan.

Keep the cable away from sources of heat, oil, sharp edges or moving parts.

Damaged or tangled cables increase the risk of electric shock.

DO NOT use extension cables with this fan.

SERVICE & REPAIRS

Check that the fan is in good working order. Take immediate action to have it

repaired or any damaged parts replaced.

DO NOT attempt to repair the fan yourself. Always contact the Clarke service

department who will use recommended parts only. Unapproved parts may be

dangerous and will invalidate your warranty.

ENVIRONMENTAL RECYCLING POLICY

By purchasing this product, the customer is taking on the obligation

to deal with its safe disposal in accordance with the Waste Electrical

and Electronic Equipment regulations (WEEE).

In effect, this means that this product must not be discarded with

general household waste but according to the laws governing Waste

Electrical and Electronic Equipment (WEEE) at a recognized disposal facility.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12

months from the date of purchase. Please keep your receipt as proof of

purchase. This guarantee is invalid if the product is found to have been

abused, tampered with, or not used for the purpose for which it was intended.

Faulty goods must be returned to their place of purchase, no product can be

returned to us without prior permission.

This guarantee does not effect your statutory rights.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply

through an approved BS 1363 plug or a suitably fused isolator switch.

If the plug has to be changed because it is not suitable for your socket, or

because of damage, it must be removed and a replacement fitted, following

the wiring instructions shown below. The old plug must be discarded safely, as

insertion into a power socket could cause an electrical hazard.

If the colours of the wires in the power cable do not agree with the markings

on the plug.

• Connect the BLUE wire

to the terminal

marked N.

• Connect the BROWN

wire to the terminal

marked L.

•ConnecttheYELLOW

AND GREEN wire to

the terminal marked E

or .

AN APPROVED RESIDUAL

CURRENT DEVICE (RCD) WHICH HAS A TRIPPING CURRENT OF LESS THAN 30 mA

MUST BE USED.

If you are not sure, consult a qualified electrician. DO NOT try to do any repairs

yourself.

BEFORE USE

Before commencing assembly, check for damage and or shortages etc, any

damage or shortage should be reported to your Clarke dealer where the fan

was purchased.

WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS

SUPPLY.

WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE

COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:

BLUE = NEUTRAL BROWN = LIVE YELLOW AND GREEN = EARTH

Plug must be BS1363/A approved.

Always fit

Ensure that the outer sheath of

Neutral

(Blue)

Live

(Brown)

Earth

(Green and

a 13 Amp

the cable is firmly held by the clamp

fuse.

Yellow)

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

Your ventilation fan should be

supplied with the following parts:

• 4 x castors (2 with brakes)

• 16 bolts, 16 nuts, 16 spring

washers and 32 flat washers.

Bolt the castor assemblies to the

frame as shown using the fastenings

supplied. Install the castors with

brakes at one end of the frame.

This ventilator can be used with

CLARKE 16” diameter retractable

ducting available in 5 metre lengths

as follows:

Orange (3230241) or Yellow (3230484)

1. Before use, attach the ducting to

the discharge end of the

ventilator as shown, secured with

the tie cord provided.

2. Place the ventilator in a level

position on a flat surface and at a safe distance from flammable materials.

3. Connect the ventilator to a suitable power outlet. The ventilator is

operated by the ON/OFF switch.

4. Set the angle of tilt as required using the hand knob shown.

5. Always apply the brakes before operating the ventilator.

CARE & MAINTENANCE

Clean the with a soft damp cloth, Do not use solvents or abrasives.

If used in spaces with high dust content, clean the guards and fan blades by

vacuuming or wiping. Remove the end guard to gain access to the blades by

removing the four securing screws.

REPLACE GUARDS BEFORE RE-CONNECTING TO MAINS SUPPLY.

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE

PERFORMING ANY CLEANING OR MAINTENANCE TASKS. REPAIRS

SHOULD BE CARRIED OUT BY THE CLARKE SERVICE DEPARTMENT.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

No other maintenance is required, should you discover any problem with the

ventilation fan return it to the CLARKE service department for repair.

Should the fan fail to operate, check the power supply and that the fuse in the

plug has not blown. Abnormal noise while the fan is running may occur if the

fan is not standing on a level surface.

SPECIFICATIONS

Model CAM400

Product dimensions 575 x 435 x 770 mm

Air Inlet Size 16 inch

Drum diameter 480 mm

Fan diameter 395 mm

Swivel/tilt range 360o

Product Weight 37 kg

Operating temperature 10 - 40oC

Power supply 230V/50Hz

Duty Cycle Classification: S1 (continuous)

Ingress protection class IP55

Electrical insulation class II

Fan speed@optimum efficiency 2800 rpm

Rated airflow: (m3/h) 63 m3/m (3796 m3/h)

Total Pressure 700 Pa

Static pressure 436 Pa

Rated motor input power 1200 W

Overall efficiency 59.52%

Measurement catagory C

Efficiency catagory (static/total) Static

Efficiency Grade (at optimum energy point) 40

Guaranteed Sound Power Level 79 dB

Specific Ratio (EU no 327/2011) N/A

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DECLARATION OF CONFORMITY

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Clarke Lüfter Handbücher

Clarke

Clarke CAM30110V Bedienungsanleitung

Clarke

Clarke Air CDF18HV-B Installations- und Betriebshandbuch

Clarke

Clarke CPF18B100 Bedienungsanleitung

Clarke

Clarke Air CAM900 Installations- und Betriebshandbuch

Clarke

Clarke CBF18 Bedienungsanleitung

Clarke

Clarke CAM30B Bedienungsanleitung

Clarke

Clarke Air CAM5002 Bedienungsanleitung

Clarke

Clarke CAM200B Bedienungsanleitung

Clarke

Clarke Air CBF20 Bedienungsanleitung

Clarke

Clarke Contractor CON305 Bedienungsanleitung

Clarke

Clarke AIR CAM6000 Bedienungsanleitung

Clarke

Clarke CAM20R Bedienungsanleitung

Clarke

Clarke CFF18C100 Bedienungsanleitung

Clarke

Clarke CONTRACTOR CON500 Bedienungsanleitung

Clarke

Clarke air movers Handbuch

Clarke

Clarke CONTRACTOR CON350 Bedienungsanleitung

Clarke

Clarke CAM24R Bedienungsanleitung

Clarke

Clarke CSF2 Bedienungsanleitung

Clarke

Clarke CAM6000 Installations- und Betriebshandbuch

Clarke

Clarke CDF20HV-B Installations- und Betriebshandbuch

Clarke

Clarke Air Series Bedienungsanleitung

Clarke

Clarke CONTRACTOR CON400 Bedienungsanleitung

Clarke

Clarke CFF18B100 Bedienungsanleitung

Clarke

Clarke CAM14HV Bedienungsanleitung

Beliebte Lüfter Handbücher anderer Marken

ELTA FANS

ELTA FANS H03VV-F Bedienungsanleitung

Hunter

Hunter 20714 Gebrauchsanweisung

Emerson

Emerson CARRERA VERANDA CF542ORB00 Bedienungsanleitung

Hunter

Hunter Caraway Gebrauchsanweisung

Panasonic

Panasonic FV-15NLFS1 Bedienungsanleitung

Kompernass

Kompernass KH 1150 Bedienungsanleitung

VES

VES FALA100/12V/TR Bedienungsanleitung

Vertiv

Vertiv Liebert DCD Bedienungsanleitung

Westinghouse

Westinghouse GFP Series Bedienungsanleitung

Venmar

Venmar KUBIX HRV PLUS Series Bedienungsanleitung

Maico

Maico ECR 31 Bedienungsanleitung

Sonnenkonig

Sonnenkonig Dinky Bedienungsanleitung

S&P

S&P ECOWATT HXBR Bedienungsanleitung

Wider

Wider IMP03369BH Bedienungsanleitung

Panasonic

Panasonic F-60DHN Bedienungsanleitung

Broan

Broan 766BN Bedienungsanleitung

Premium

Premium PFS16022 Montageanleitung

Litex Industries

Litex Industries E-CGL52CB5C1 Bedienungsanleitung