Clarke COB10C/110 Betriebsanleitung

ASSEMBLY & USER

INSTRUCTIONS

ORIGINAL INSTRUCTIONS GC1119 ISS 2

10W LED WORKLIGHT(110V)

MODEL NO: COB10C/110

PART NO: 4003600

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

INTRODUCTION

Thank you for purchasing this CLARKE portable worklight. This portable

worklight with carrying handle/ floor stand is suitable for indoor or outdoor use.

Before attempting to use this product, please read this manual thoroughly and

follow the instructions carefully. In doing so you will ensure the safety of yourself

and that of others around you, and you can look forward to your purchase

giving you long and satisfactory service.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12

months from the date of purchase. Please keep your receipt which will be

required as proof of purchase.

This guarantee is invalid if the product is found to have been abused or

tampered with in any way, or not used for the purpose for which it was

intended.

Faulty goods should be returned to their place of purchase, no product can

be returned to us without prior permission.

This guarantee does not effect your statutory rights.

ENVIRONMENTAL RECYCLING POLICY

Through purchase of this product, the customer is taking on the

obligation to deal with the WEEE in accordance with the WEEE

regulations in relation to the treatment, recycling & recovery and

environmentally sound disposal of the WEEE.

In effect, this means that this product must not be disposed of with general

household waste. It must be disposed of according to the laws governing

Waste Electrical and Electronic Equipment (WEEE) at a recognised disposal

facility.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SAFETY PRECAUTIONS

1. This worklight must not be immersed in water.

2. Do not look directly into the lamp when switched on as this can damage

the eyes.

3. If used with an extension cable always ensure that the extension cable is

fully unwound.

4. Do not use this worklight if it has a broken lens, casing or damaged supply

cable

5. Always unplug the worklight before moving it or performing maintenance.

Do not touch the lamp when your hands are wet.

6. Do not attempt to disassemble or repair the worklight.

7. Do not leave the worklight unattended when switched on. Always unplug

the worklight when it is not in use.

8. Never unplug the worklight by holding the cable. Unplug by holding the

plug.

9. Never use the worklight if the cable or plug are damaged.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

This product can be connected to one of the following power supplies:

• 110V generator

• 110V isolating transformer

• 110V site supply

• 230V generator via a 110V transformer.

Connecting it to any other power source may cause damage.

This product includes a fitted industrial plug to BS-EN

60309, and a cable for use with a 110 volt supply. On

no account must a 230V, 13amp (BS1363) plug be

used.

If using a portable 110V transformer make sure it has a

rated capacity sufficient to take the load of the

worklight.

Should the plug need changing at any time, ensure

that a plug of identical specification is used and

proceed as follows:

1. Undo the socket screws & remove the rear section.

2. Rotate the cable clamp clear of the terminals.

3. Feed the cable through the rear gland in the plug.

4. Remove the cable sheath to the required lengths

as shown in the diagram.

5. Terminate the correct wires in the

correct terminal blocks as shown.

6. Remove the cable clamp screws. Clip

the cable clamp back into position and

place the clamp around the outer

sheath of the cable. Replace the screws

and tighten until the cable is securely

held.

7. Replace the rear cover and tighten the cover screws.

WARNING! READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO A

POWER SUPPLY.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

If in any doubt, consult a qualified electrician. DO NOT attempt any repairs

yourself.

The user should purchase a suitable connecting lead which is compatible with

the worklight socket. The length giving mobility to the worklight but without

becoming a trip hazard.

ASSEMBLY & MOUNTING

The worklight is mounted on a carry

frame which is assembled as follows:

1. Remove the locking knob from

the base of the carry frame, then

insert the tubular base into the

frame attachment, as shown.

2. Line up the holes in the two

sections of the frame then

replace and tighten the fixing

screw.

CARE & STORAGE

1. When not in use, switch off & unplug from the power supply.

2. Store this worklight in a secure, dry place, out of the reach of children. DO

NOT leave it exposed to the elements and avoid direct sunlight, direct

heat, rain/moisture etc.

3. Keep the external surfaces clean. Avoid impact damage & do not allow

this worklight to come into contact with abrasive or corrosive materials.

4. Do not use solvents, thinners or alcohol for cleaning, as these chemicals will

damage the finish. With the worklight unplugged from the power supply,

use a dry cloth to wipe over the components.

5. Only use extension leads that are of an appropriate power rating and

suitable for the work environment. Inspect the extension lead regularly and

replace if damaged.

6. The LED light source cannot be replaced but has a life expectancy of

approximately 20,000 hours.

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

7. Only use parts and accessories recommended in this manual. Never use

unauthorised accessories or attachments which may result in personal

injury or damage to the product.

8. Do not attempt to repair or modify this product or attempt any electrical

repair yourself. Consult the Clarke Service Department on 020 8988 7400.

ERP TECHNICAL INFORMATION

Model COB10C/110

Part No 4003600

Model type L9601P

Dimensions (L x W x H) 180 x 156 x 250 mm

Weight 1.1 kg

Operating Temperature -20oC to +50oC

Input power (consumption) 10W

Light Source COB LED

Light Output (luminous flux) 800 lumen @ 1m

Efficiency 80 Lm/W

Power Supply 110V 60HZ

Insulation Class I

IP Rating IP65

Energy Efficiency Class A+

Colour Temperature 6500 K

Weighted Energy Consumption 10 kWh/1000h

Life expectancy of LED 20,000 hours

Tilt Adjustment -90oto +90o

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

DECLARATION OF CONFORMITY

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Clarke Arbeitsleuchte Handbücher

Clarke

Clarke SMD42T Betriebsanleitung

Clarke

Clarke HLC400/110 Betriebsanleitung

Clarke

Clarke COB10C Betriebsanleitung

Clarke

Clarke LED1000R Bedienungsanleitung

Clarke

Clarke GWL700R Bedienungsanleitung

Clarke

Clarke SMD42C Betriebsanleitung

Clarke

Clarke HLC400T/110 Betriebsanleitung

Clarke

Clarke COB10CR Bedienungsanleitung

Clarke

Clarke SMD84T/110 Betriebsanleitung

Clarke

Clarke RWL36LI Bedienungsanleitung

Clarke

Clarke MFL800R Bedienungsanleitung

Clarke

Clarke CFL20Li Bedienungsanleitung

Clarke

Clarke SMD84T Betriebsanleitung

Clarke

Clarke UBL1600R Bedienungsanleitung

Clarke

Clarke SMD4500 Bedienungsanleitung

Clarke

Clarke CWLCOB3 Bedienungsanleitung

Clarke

Clarke PL5R Bedienungsanleitung

Clarke

Clarke SMD2700L Bedienungsanleitung

Clarke

Clarke RWL30 Bedienungsanleitung

Clarke

Clarke CL6FS Bedienungsanleitung

Clarke

Clarke HLC400T Betriebsanleitung

Clarke

Clarke SMD42T/110 Betriebsanleitung

Clarke

Clarke HLC400 Betriebsanleitung

Clarke

Clarke LED700SR Bedienungsanleitung

Beliebte Arbeitsleuchte Handbücher anderer Marken

ANSMANN

ANSMANN POWERLIGHT 5.1 Bedienungsanleitung

RTRMAX

RTRMAX RTX1868 Bedienungsanleitung

FeinTech

FeinTech LAL00220 Bedienungsanleitung

Bunker Hill Security

Bunker Hill Security 64735 Bedienungsanleitung

Goobay

Goobay 30450 Bedienungsanleitung

REV Ritter

REV Ritter SPOT Bedienungsanleitung

Ignition

Ignition Stagepix Line 100 IP Bedienungsanleitung

SCANGRIP

SCANGRIP DUO CONNECT Bedienungsanleitung

Bosch

Bosch GLI 18 V Bedienungsanleitung

Bayco

Bayco SL-1514 Bedienungsanleitung

EUFAB

EUFAB SMD LED 8+1 Bedienungsanleitung

DeWalt

DeWalt DCL510 Bedienungsanleitung

MaxLite

MaxLite 73683 Bedienungsanleitung

Heitronic

Heitronic Trend 27867 Bedienungsanleitung

EINHELL

EINHELL TE-CL 18/2000 LiAC Bedienungsanleitung

IKEA

IKEA STRÖMLINJE Bedienungsanleitung

Regent

Regent CHSL300 Bedienungsanleitung

Monzana

Monzana Spodaj MZUL277 Bedienungsanleitung