CompuLab Fitlet2 FC-USB Bedienungsanleitung

Revision 1.1

Dec-2017

Owner’s Manual

Hayetsira St. 17, Yokneam, Israel

Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com

www.fit-iot.com

Page 2of 17

fitlet2 owner’s manual

Safety instructions

Use the following safety guidelines to help protect your computer from potential damage and

to help to ensure your personal safety. Unless otherwise noted, each procedure included in this

document assumes that you have read the safety information that shipped with your

computer.

WARNING: Disconnect all power sources before opening the computer cover or

panels. After you finish working inside the computer, replace all covers, panels, and

screws before connecting to the power source.

CAUTION: Some repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your

product documentation, or as directed by the online or telephone service and support

team. Damage due to servicing that is not authorized by Compulab is not covered by your

warranty. Read and follow the safety instructions that came with the product.

CAUTION: To avoid electrostatic discharge and prevent internal components damage

from electrostatic discharge when touching computer or its parts, ground yourself by

using a wrist grounding strap or by periodically touching an unpainted metal surface, such

as a connector on the back of the computer.

CAUTION: Handle components and cards with care. Do not touch the components or

contacts on a card. Hold a card by its edges or by its metal mounting bracket. Hold a

component such as a processor by its edges, not by its pins.

CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, not

on the cable itself. Some cables have connectors with locking tabs; if you are

disconnecting this type of cable, press in on the locking tabs before you disconnect the

cable. As you pull connectors apart, keep them evenly aligned to avoid bending any

connector pins. Also, before you connect a cable, ensure that both connectors are

correctly oriented and aligned.

Hayetsira St. 17, Yokneam, Israel

Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com

www.fit-iot.com

Page 3of 17

fitlet2 owner’s manual

Table of contents

Safety instructions .........................................................................2

Introduction ........................................................................................4

fitlet2 features ................................................................................................ 4

Package contents........................................................................................ 4

Hardware specifications......................................................................... 5

Connectors layout.......................................................................................6

Quick start guide.............................................................................7

Minimum requirements .......................................................................... 7

Identifying fitlet2 configuration......................................................... 7

Opening fitlet2 ............................................................................................... 7

Installing RAM ................................................................................................9

M.2 cooling plate and SSD..................................................................10

RTC battery .................................................................................................... 12

Re-assembling fitlet2 .............................................................................13

Connecting fitlet2......................................................................................14

Entering BIOS Setup................................................................................15

Installing and booting operating system ................................15

Service ................................................................................................ 16

Support..............................................................................................................16

Warranty...........................................................................................................16

RMA......................................................................................................................16

For more information and to obtain the latest revision of this document,

please visit: www.fit-iot.com

For technical support and product related questions,

please email: support@fit-iot.com

Hayetsira St. 17, Yokneam, Israel

Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com

www.fit-iot.com

Page 4of 17

fitlet2 owner’s manual

Introduction

Thank you for purchasing fitlet2. It is a miniature PC designed to be tough, capable, versatile

and user-friendly. With proper installation we expect fitlet2 to serve you for many years. The

unique fanless design of fitlet2 eliminates the need for any maintenance after installation.

Please consult this owner’s manual for getting started with fitlet2. You are welcome to contact

fitlet2 manufacturer – Compulab at www.fit-iot.com or support@fit-iot.com should you have

any technical questions.

fitlet2 features

•Intel Apollo Lake CPU

•Up to 16 GB RAM

•eMMC | M.2 SATA | 2.5” storage*

•Dual head 4K display

•Up to 4 Gbit Ethernet ports*| WiFi*| cellular communication*

•USB 3.0, audio, serial port, SD card, indicator LEDs

•Supports Windows 10 and Linux

•Can be extended with Function And Connectivity Extention T-Cards (FACET Cards)

•All-metal fanless housing 112 mm X 84 mm X 34 mm

•Operating temperature range up to -40°C to 85°C (depending on ordered configuration)

*Feature may require an extension FACET card

Package contents

1. fitlet2 computer

2. Power supply: input 100-240VAC 50/60Hz, output 12VDC 3A with universal AC plugs

3. M.2 cooling plate with spacers and screws

4. RTC battery with cord

5. Owner’s manual

Notes

•additional accessories can be purchased separately

•Some fitlet2 configurations come pre-installed with additional devices and accessories

Hayetsira St. 17, Yokneam, Israel

Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com

www.fit-iot.com

Page 5of 17

fitlet2 owner’s manual

Hardware specifications

Processor / SoC

Type

Intel Apollo Lake (Atom | Celeron | Pentium)

Dual-core or quad-core

Memory

Supported

1x SO-DIMM 204-pin DDR3L SDRAM

Up to 16GB Non-ECC DDR3L-1866 (1.35V)

Storage

Supported

1x M.2 M-key 2242 | 2260

Optional eMMC

Optional 2.5” HDD | SSD

Graphics

Display Interface 1

HDMI 1.4b up to 3840 x 2160 @ 30Hz

Display Interface 2

DisplayPort 1.2 up to 4096 x 2160 @ 60 Hz (via Mini DP connector)

Audio

Codec

Realtek ALC1150 HD audio codec

Audio Output

Analog stereo output | Digital 7.1 channels S/PDIF output (3.5mm jack)

Audio Input

Analog stereo Microphone input (3.5mm jack)

Networking

LAN

LAN1: Intel I211 GbE controller (RJ-45)

LAN2: Intel I211 GbE controller (RJ-45)

Wireless

1x M.2 E-key 2230 slot

WiFi adapter sold separately

Connectivity

USB

2x USB 3.0

2x USB 2.0

Serial

1x Serial communication ports

COM1: RS232 via mini serial connector

Expansion

FACET rev 2 slot (PCIe x2, USB2.0, eDP1.3, I2S, I2C, UART)

Operating System

Supported

Windows 10 | Linux

Operating Conditions

Input Voltage

Unregulated 7 - 20VDC input

Power Consumption

5W to 15W

depending on configuration and system load

Operating Temperature

Commercial: 0°C to 45°C

Extended: -20°C to 70°C

Industrial: -40°C to 85°C

Relative Humidity

5% to 95% (non-condensing)

Enclosure

Material

Die Cast Aluminum

Cooling

Passive Cooling (fanless)

Dimensions

112 mm X 84 mm X 34 mm

Weight

350g

Warranty

5 years

Warranty notes

Storage device warranty in accordance with device manufacturer’s warranty.

Excludes battery.

For the latest specifications please visit:

www.fit-iot.com/web/products/fitlet2/fitlet2-specifications/

Hayetsira St. 17, Yokneam, Israel

Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com

www.fit-iot.com

Page 6of 17

fitlet2 owner’s manual

Connectors layout

Hayetsira St. 17, Yokneam, Israel

Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com

www.fit-iot.com

Page 7of 17

fitlet2 owner’s manual

Quick start guide

Minimum requirements

To use fitlet2 you will need:

•RAM and storage device (if not pre-installed)

•A display with HDMI or DisplayPort input + HDMI or mini-DisplayPort cable

•USB keyboard and mouse

Identifying fitlet2 configuration

fitlet2 configuration is detailed on the label attached to the bottom side of the computer.

Note

Pay attention to RAM and storage. If not installed fitlet2 will not boot. You will have to first

install these devices.

Opening fitlet2

You will need to open fitlet2 in order to install RAM, storage and RTC battery.

Required tool: Phillips screwdriver.

Hayetsira St. 17, Yokneam, Israel

Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com

www.fit-iot.com

Page 8of 17

fitlet2 owner’s manual

To open fitlet2 please follow these steps:

1. Place fitlet2 on a flat surface bottom-up.

2. Open the four screws using the Phillips screwdriver (counter clock-wise).

3. Lift the bottom cover to remove it. Side panels should fall-off.

4. Lift fitlet2 from the top cover.

Hayetsira St. 17, Yokneam, Israel

Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com

www.fit-iot.com

Page 9of 17

fitlet2 owner’s manual

Installing RAM

RAM socket is positioned on the top side of the motherboard.

fitlet2 accepts a single SODIMM DDR3L (1.35V).

Insert DDR3L SODIMM module and press it down until it is latched firmly on both sides.

Hayetsira St. 17, Yokneam, Israel

Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com

www.fit-iot.com

Page 10 of 17

fitlet2 owner’s manual

M.2 cooling plate and SSD

The M.2 cooling plate has several purposes:

•Allow installation of multiple form factor M.2 devices and FACET Cards

•Provide cooling to M.2 devices

•Assist in battery placement

•Provide proper cable management inside fitlet2

fitlet2 accepts M.2 M-key 2242 | 2260 SATA SSD.

The SSD has to be fastened to the M.2 cooling plate. Then the M.2 cooling plate is placed at the

underside of the motherboard and fastened to the front and back panel.

To install SSD onto M.2 cooling plate

1. Screw the 3 alignment screws into the marked holes. These screws are used to position the

M.2 devices

2. Peel-off protective film from the two thermal pads.

3. Place the red M.2 spacer according to the length of the M.2 SSD as depicted below.

Note orientation of the spacer: The recessed side should face the alignment screws.

Insert M.2 fastening screw but do not tighten.

Andere Handbücher für fitlet2 FC-USB

Inhaltsverzeichnis

Andere CompuLab Desktop Handbücher

CompuLab

CompuLab FIT-PC4 Bedienungsanleitung

CompuLab

CompuLab Airtop-C0 Bedienungsanleitung

CompuLab

CompuLab fit-PC2i Bedienungsanleitung

CompuLab

CompuLab fitlet2 FC-USB Bedienungsanleitung

CompuLab

CompuLab SBC-FITPC3 Bedienungsanleitung

CompuLab

CompuLab fitlet2 FC-USB Bedienungsanleitung

CompuLab

CompuLab Trim-Slice Bedienungsanleitung

CompuLab

CompuLab fitlet Bedienungsanleitung

CompuLab

CompuLab Airtop2 Bedienungsanleitung

CompuLab

CompuLab Airtop3 Bedienungsanleitung

CompuLab

CompuLab Airtop Bedienungsanleitung

CompuLab

CompuLab fitlet3 Bedienungsanleitung

CompuLab

CompuLab IPC3 Bedienungsanleitung

CompuLab

CompuLab UTILITE2 Bedienungsanleitung

CompuLab

CompuLab Fitlet-H Bedienungsanleitung

CompuLab

CompuLab Fitlet2 FC-POED Bedienungsanleitung

CompuLab

CompuLab IPC2 Bedienungsanleitung

CompuLab

CompuLab Tensor-I22 Bedienungsanleitung

CompuLab

CompuLab fit-PC2 Bedienungsanleitung

CompuLab

CompuLab Fitlet FC-OPLN Bedienungsanleitung

Beliebte Desktop Handbücher anderer Marken

HP m9060n - Pavilion - Elite Technisches Datenblatt

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

HP Presario SV7000 - Desktop PC Bedienungsanleitung

HP ProDesk 400 G5 Handbuch

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Lenovo

Lenovo ThinkCentre Edge 72 Handbuch

Lenovo

Lenovo ThinkStation D20 Handbuch

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung