4 of 6 LPN00644X0007A0_A
SECTION 2: SURFACE MOUNTING CONTINUOUS ROW MOUNTING
CAUTION: Ceiling contractor must provide
appropriate anchors to support weight of ceiling
mount linear luminaires.
CAUTION: Do not attempt to assemble
luminaire rows on the ground and then lift
into position. This may create stress at the
connection points and may result in damage
and/or mechanical failure.
CAUTION: Do not connect power in a run until
all of run is installed, wire harnesses connected,
and luminaire joints completed.
STEP 1:
From center line of lengthwise mounted switch
box(es), snap a lengthwise chalk line on ceiling
to the right of Junction box approximately the
full length of the row to be installed.
STEP 2:
Remove lens and upper LED/reflector tray
and set aside in order of run placement for
reinstalling later. To remove lens, carefully slide
a plastic card or putty knife between the lens
and extrusion towards the end of the luminaire.
Using the plastic card or putty knife, push the
lens inward until the lens come free. After
removing the lens, remove the Philips head
reflector screws, remove the LED Reflector Tray,
and disconnect the LED harness. Set lens and
LED Reflector tray aside. See Figure 1 and 2.
STEP 3:
Locate and install End Cap Kits. In order to install
the end cap on the male end of the luminaire,
replace the male joiner bracket with the female
joiner bracket and remove the alignment pins.
See Figure 4 and 6.
STEP 4:
Attach the first luminaire Right-Hand End of
the Row onto the ceiling per Figure 6. Tighten
mounting screws on luminaire snug as not to
allow luminaire to move when being aligned
with the next luminaire in the row.
STEP 5:
Position second luminaire in row such that it aligns
with joint end (male end) of first luminaire. Attach
using customer supplied hardware to structure
above. Connect the second luminaire to the first
luminaire as shown in Figure 5 and 6. Plug wire
harness together and push excess wire into
luminaire wiring chamber, ensure that wires are
not pinched.
STEP 6:
Push luminaires tightly together while making
sure the alignment pins slide into the interior
tracks of each luminaire and span the luminaire
joint. Secure joint by tightening supplied keps
locknuts on threaded studs of male joiner
bracket. Figure 5 and 6.
STEP 7:
Continue to install and assemble row following
steps 1-6 above. Locate and install Junction box
to be centered on the End unit (Left-Hand End of
Run) luminaire, make electrical connections per
Section 5 “Electrical Connections”.
STEP 7:
Replace LED trays and lens that was removed in
Step 1 above, ensure that no wires are pinched.
4 5
6
Alignment Pins
Male End
Female End
End Plate Cap (With
Alignment Pins)
End-Plate
Lock Nuts
5/8" Mounting Hole
Slide Screw w/
Lock Nuts
Female Joiner Bracket
First Luminaire
Chalk Line
Male End
Female End
Second Luminaire
