Crestron TSW-560 Betriebsanleitung

TSW-560/TSW-760/TSW-1060

5", 7", and 10.1" Touch Screens

Supplemental Guide

Crestron Electronics, Inc.

Crestron product development software is licensed to Crestron dealers and Crestron Service Providers (CSPs) under a limited non-exclusive,

non-transferable Software Development Tools License Agreement. Crestron product operating system software is licensed to Crestron

dealers, CSPs, and end-users under a separate End-User License Agreement. Both of these Agreements can be found on the Crestron

website at www.crestron.com/legal/software_license_agreement.

The product warranty can be found at www.crestron.com/warranty.

The specific patents that cover Crestron products are listed at patents.crestron.com.

Certain Crestron products contain open source software. For specific information, please visit www.crestron.com/opensource.

Crestron, the Crestron logo, and Rava are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or

other countries. Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities

claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is

not responsible for errors in typography or photography.

This document was written by the Technical Publications department at Crestron.

Supplemental Guide – DOC. 7927A Contents •i

Contents

Access the Setup Screens 1

Configure the Touch Screen 3

Ethernet Setup........................................................................................................ 3

IP Table Setup ........................................................................................................ 5

Audio Setup ............................................................................................................ 7

Display Setup.......................................................................................................... 8

Standby Timeout................................................................................................... 10

Diagnostics ........................................................................................................... 11

Test Patterns............................................................................................ 12

Touch Test............................................................................................... 12

Mic Test................................................................................................... 13

LAN Test.................................................................................................. 14

Keypad Test............................................................................................. 15

Rava Test................................................................................................. 15

RTSP Test................................................................................................ 16

About.................................................................................................................... 17

Supplemental Guide – DOC. 7927A TSW-560/TSW-760/TSW-1060: 5", 7", and 10.1" Touch Screens •1

TSW-560/TSW-760/TSW-1060:

5", 7", and 10.1" Touch Screens

Access the Setup Screens

The setup screens enable basic configuration prior to regular operation of the Crestron®

TSW-560, TSW-760, and TSW-1060 touch screens. To display the main setup screen,

touch the display while applying power to the touch screen.

The Crestron TSW-560, TSW-760, and TSW-1060 are functionally similar. For simplicity

within this guide, the term “touch screen” is used except where noted.

NOTE: If no project has been loaded or if an invalid project has been loaded, the touch

screen defaults to the main setup screen.

During regular operation of the touch screen, there are three ways to access the setup

functions:

1. Place a button on the project main page, and assign the reserved join number

(17242) that activates setup.

2. Tap the hard keys labeled below as 1, 2, 3, and 4 in sequence twice

(tap 1, 2, 3, 4, 1, 2, 3, 4) with a 5-second period.

3. Place five fingers on the display and hold for 15 seconds.

Touch Screen Hard Key Assignment

2•TSW-560/TSW-760/TSW-1060: 5", 7", and 10.1" Touch Screens Supplemental Guide – DOC. 7927A

The TSW-560/760/1060 Setup screen is displayed.

TSW 760 Setup Screen

The TSW-560/760/1060 Setup screen provides buttons for Ethernet setup, IP table setup,

audio setup, display setup, standby timeout, and diagnostics. There is also a button to

toggle system messages on or off, and an About button provides information about the

touch screen. Additionally, the screen displays the IP address, the hostname, and the MAC

address of the touch screen. The functions of each button are detailed in the following

pages of this guide.

NOTE: The bottom toolbar is present on all of the setup screens. The toolbar provides a

gear button ( ) that can be tapped to return to the TSW-560/760/1060 Setup screen

and a Save & Exit button that can be tapped to save all settings, to exit the setup screens,

and to return to the main project.

Supplemental Guide – DOC. 7927A TSW-560/TSW-760/TSW-1060: 5", 7", and 10.1" Touch Screens •3

Configure the Touch Screen

Ethernet Setup

On the TSW-560/760/1060 Setup screen, tap Ethernet Setup to display the Ethernet

Setup screen.

Ethernet Setup Screen

Use the Ethernet Setup screen to view the touch screen’s MAC and IP addresses, subnet

mask, default router, primary and secondary DNS, hostname, and domain. This screen also

contains a Link indicator to show the status of the Ethernet connection. (Green indicates

that the Ethernet connection is active.)

DHCP can be enabled or disabled by tapping On or Off under DHCP Enable. When DHCP

is off, a Set Static IP Address Settings button provides access to controls that allow these

settings to be edited.

To change to a static IP address, tap Off under DHCP Enabled, and then tap Set Static IP

Address Settings to display the Ethernet Setup - Static IPs screen.

NOTE: DHCP is enabled by default.

4•TSW-560/TSW-760/TSW-1060: 5", 7", and 10.1" Touch Screens Supplemental Guide – DOC. 7927A

Ethernet Setup - Static IPs Screen

To edit the static IP address, the static subnet mask, the static default router, the preferred

DNS, or the alternate preferred DNS, tap the text field underneath the setting name. The

on-screen numeric keypad (not shown) opens.

•Use the keypad to make the new entry.

•Tap the clear button ( ) in the text field to clear any previous entry.

•Tap the delete button ( ) to delete the last digit.

•Tap SAVE to save a new entry or tap < CANCEL to discard any changes. The

display returns to the Ethernet Setup - Static IPs screen.

After new settings have been saved, tap Apply Changes on the Ethernet Setup - Static

IPs screen to apply the new settings and to stay in setup mode. Tap Reboot to exit setup

mode and to reboot the touch screen.

•If no changes are made, tap < BACK to return to the Ethernet Setup screen.

•Tap < BACK again to return to the TSW-560/760/1060 Setup screen.

Supplemental Guide – DOC. 7927A TSW-560/TSW-760/TSW-1060: 5", 7", and 10.1" Touch Screens •5

IP Table Setup

On the TSW-560/760/1060 Setup screen, tap IP Table Setup to display the

Ethernet Setup - IP Table screen.

Ethernet Setup - IP Table Screen

Use the Ethernet Setup - IP Table screen to view and edit up to four IP table settings,

each of which has an Online indicator. (Green indicates that the IP address is online.)

To add or edit an entry, tap the Add/Edit button to its left. The Ethernet Setup - Edit IP

Table screen is displayed.

Ethernet Setup - Edit IP Table Entry Screen

6•TSW-560/TSW-760/TSW-1060: 5", 7", and 10.1" Touch Screens Supplemental Guide – DOC. 7927A

Tap the text field below CIP ID to display the on-screen hex keypad.

On-Screen Hex Keypad

•Use the keypad to make the new entry.

•Tap the clear button ( ) in the text field to clear any previous entry.

•Tap the delete button ( ) to delete the last digit.

•Tap SAVE to save a new entry or tap < CANCEL to discard any changes. The

display returns to the Ethernet Setup - IP Table screen.

Tap the text field below IP Address / Hostname to display the on-screen keyboard.

On-Screen Keyboard

Andere Handbücher für TSW-560

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Crestron Touchscreen Handbücher

Crestron

Crestron TPMC-4SMD-FD Original Betriebsanleitung

Crestron

Crestron TSW-560 Betriebsanleitung

Crestron

Crestron Isys i/O TPMC-15-CH Bedienungsanleitung

Crestron

Crestron TSW-550-TTK Maßzeichnung

Crestron

Crestron TPMC-V12-WALL Bedienungsanleitung

Crestron

Crestron ST-1550 Bedienungsanleitung

Crestron

Crestron TPS-4500IMPC Bedienungsanleitung

Crestron

Crestron QM-FTCC Anleitung zur Verwendung

Crestron

Crestron TSW-70 Series Bedienungsanleitung

Crestron

Crestron Isys TPS-3000L Bedienungsanleitung

Crestron

Crestron TS-1542 Betriebsanleitung

Crestron

Crestron TPS-4500IMW Bedienungsanleitung

Crestron

Crestron Isys TPMC-12L Bedienungsanleitung

Crestron

Crestron TSD-2220 Maßzeichnung

Crestron

Crestron TS-70 Series Bedienungsanleitung

Crestron

Crestron TPS-FPAR5000L Bedienungsanleitung

Crestron

Crestron TPMC-3X Series Bedienungsanleitung

Crestron

Crestron TSS-470E Bedienungsanleitung

Crestron

Crestron TPS-FPAR4000L Bedienungsanleitung

Crestron

Crestron Isys TPS-6L Anleitung zur Verwendung

Crestron

Crestron Isys TPMC-4SM Original Betriebsanleitung

Crestron

Crestron Isys TPS-4L Anleitung zur Verwendung

Crestron

Crestron TSW-560 Maßzeichnung

Crestron

Crestron Isys TPS-4000 Bedienungsanleitung

Beliebte Touchscreen Handbücher anderer Marken

FlowLine

FlowLine Data loop Bedienungsanleitung

ALPEX

ALPEX AEx-8 P Series Bedienungsanleitung

Ltech

Ltech E5S Bedienungsanleitung

Harman

Harman AMX MODERO S MSD-701-L2 Bedienungsanleitung

Acnodes

Acnodes PC 1150 Bedienungsanleitung

AIS

AIS IP10IA99 series Bedienungsanleitung

IBASE Technology

IBASE Technology ASTUT-152-RE1S Bedienungsanleitung

YASKAWA

YASKAWA TP 610C Bedienungsanleitung

B&R

B&R Power Panel C Series Bedienungsanleitung

Beijer Electronics

Beijer Electronics X2 control Bedienungsanleitung

AXIOMTEK

AXIOMTEK GOT321W-521 Bedienungsanleitung

TRIDONIC.ATCO

TRIDONIC.ATCO x-touchBOX Bedienungsanleitung

Qomo

Qomo QIT1386 Bedienungsanleitung

DFI

DFI KS104-CD Bedienungsanleitung

AMX

AMX AXP-PPC Leitfaden

Sartorius

Sartorius X3 PR 5410 Bedienungsanleitung

AMX

AMX Modero X Series Bedienungsanleitung

Advantech

Advantech TPC-30 Series Bedienungsanleitung