CrimeStopper PlateCam SV-5200.IR Bedienungsanleitung

INSTALLATION INSTRUCTIONS:

The SV-5200.IR and SV-5200.IR.C are bar-type license plate cameras with a super wide 180°

viewing angle and IR night vision. They are easy to install with no drilling required, requiring

minimal installation time. This uniquely designed product can be used for any passenger car,

SUV and Van. It can also be used on many large Semi Trucks, School Buses, and Transit

Buses

FEATURES:

•Revolutionary design integrates a Color rear vision camera with your rear license plate

•Enhance the look of your Car, SUV, Truck or Van.

•The 180°ultra wide-angle CMOS color camera provides rear images in real time and

eliminates the dangerous “blind-spot” directly behind your vehicle when backing.

•Works well in day or night, on most vehicles.

•Normal or Reverse Image (Selectable)

•The plate cam easily connects with other SecurView monitor or aftermarket monitor that

uses an RCA input

•Available in black and chrome color

•The PlateCam™ is designed for vehicles in which the license plate location is centered

and above the level of the rear bumper. The PlateCam™ may not perform well on

vehicles with low or offset license plate positions.

SV-5200.IR

SV-5200.IR.C

License Plate Bar-Type

Camera

with Night

Vision

INSTALLATION

MOUNTING:

1. The SV-5200.IR and SV-5200.IR.C Rear Vision Systems use a super wide-angle lens for best

all around performance. The Camera will display the full width of most parking spaces up to 8

feet or even wider.

2. These cameras are designed to work best on vehicles that have a license plate located at the

center and above the rear bumper. If your vehicle has a plate location that is offset to the left

side, right side, or your plate is located under the bumper then the PlateCam™ may not

provide optimum performance.

3. The SV-5200.IR and SV-5200.IR.C are designed to use the existing License Plate mounting

equipment

SIDE VIEW

License Plate

Camera Lens

Mounting

Surface

Cable

Factory License

Plate Bolt

NOTE

License Plate Should Not

Be Cut Or Trimmed

CAMERA:

1. The Camera has built-in circuitry to reverse the image so objects on the right of vehicle

appear on the right and objects on the left appear on the left when looking at a standard

monitor. (See Reverse Imaging next section for more information.)

2. The color CMOS camera is maintenance-free, waterproof (IP-68) and vibration resistant.

3. This camera has built-in Infra-Red LEDs for night vision. This will provide the driver with the

absolute best illumination when backing up the vehicle at night time.

4. The camera is completely electronic. There are NO manual adjustments for focus, etc.

REVERSE (MIRROR) IMAGING:

The SV-5200.IR and SV-5200.IR.C Cameras have built-in circuitry to “mirror” the image so objects on

the right of vehicle appear on the right and objects on the left appear on the left when looking at a

standard monitor. If your existing monitor or in-dash monitor has a reverse camera input where the

monitor itself performs the mirror image, then your picture will not be correct. If this happens, the SV-

5200.IR cameras have a jumper plug that can be connected to reverse the image back to normal.

(See Wiring Diagram)

WIRING:

1. Carefully choose a hidden out-of-sight location (possibly behind the plate) for drilling the cable

hole. Some vehicles may have an existing hidden rubber grommet or plug available to avoid

having to drill into the body. Be sure to double-check for any wiring or obstructions behind the

surface where you are going to drill the cable hole. Use the rubber grommet to make a watertight

seal for the cable where it passes into the vehicle.

2. Choose a convenient place to run the camera cable up the left, right or center of the vehicle. As

a rule of thumb, try to avoid main factory harness looms that may contain high levels or RF noise

or interference.

3. You can connect the camera power at the rear of the vehicle behind the reverse lights. You may

also connect power inside the vehicle under the dash or in the trunk. The Red power wire goes to

Reverse Light +12V, and the Black wire to Ground. The small white plastic plug is for reverse or

normal image switching. Leave the jumper disconnected for reverse image, connect the jumper

for normal image

4. Run the Yellow RCA video cable to the monitor’s video input or reverse camera input. Leave the

white RCA disconnected.

MONITOR

BLACK

RED

Connect to +12V

Reverse Light

Ground

Connect to RCA

Video Input of

Monitor YELLOW

SV-5200.IR CAMERA

BLACK

POWER PLUG WHITE

No Connection

NORM / REV

IMAGE PLUG

Connect Jumper for

Normal Image

TECH SUPPORT: (800) 998-6880

DISCLAIMER:

Under no circumstances shall the manufacturer or distributor of the PlateCam™ be held liable for

consequential or incidental damages sustained in connection with the use of the PlateCam™ Rear Vision

System. The PlateCam™ is designed as a safety enhancement device and is in no way intended as a

replacement for rear-view mirrors, side-view mirrors or physically checking the surroundings when

backing a vehicle. Always check surroundings for safety when backing! Objects on the monitor are

closer than they appear. For the best fit, modification of the vehicle license may or may not be

necessary. It is the sole responsibility of the vehicle owner to check and verify any and all State or

Federal Motor vehicle codes with regards to modifications of vehicle license plates. The manufacturer of

the PlateCam™ assumes no liability or responsibility whatsoever with regards modifications of the

license plate.

www.crimestopper.com

email@crimestopper.com

Phone (800) 998-6880

FAX (805) 581-9500

7-15-2010

SPECIFICATIONS:

1/4 Inch Color CMOS Sensor Video Output: 1.0 V P-P composite (75 Ohm load)

Dimension (MM): 1"(L) × 7⅞"(W) × 1¼"(D) Supply Voltage: +12VDC

Weight:12 Oz. Power Consumption: 80mA

Pixels: 512 (H) x 492 (V) Electronic Shutter: 1/50 s – 1/100000s

Resolution: > 250,000 pixels White Balance: Automatic

More than 420 TV lines Gamma Correction: 0.45

Minimum Illumination: 0 LUX / F 1.2 S/N Ratio: More than 48dB

Lens Type: Wide Angle Operating Temp: -13 to 185 F (-20 to 75 C)

Horizontal Angle: 180° Gain Control: Automatic

Vertical Angle: 90° Digital Signal Processor w/10 Bit A/D Converter

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere CrimeStopper Autozubehör Handbücher

CrimeStopper

CrimeStopper COOL TIMER RS-400 Handbuch

CrimeStopper

CrimeStopper MIR-ACT Bedienungsanleitung

CrimeStopper

CrimeStopper BSD-200 Bedienungsanleitung

CrimeStopper

CrimeStopper SV-5500 PC-B Bedienungsanleitung

CrimeStopper

CrimeStopper CA-504.BRKT Bedienungsanleitung

CrimeStopper

CrimeStopper SecurView SV-6911.IR Bedienungsanleitung

CrimeStopper

CrimeStopper Electroplate EP-3000 Bedienungsanleitung

CrimeStopper

CrimeStopper CS-9602PI Kurzanleitung

CrimeStopper

CrimeStopper CS-845.RKE.II Bedienungsanleitung

CrimeStopper

CrimeStopper ST-202.2 Bedienungsanleitung

CrimeStopper

CrimeStopper SecurView SV-9045 Bedienungsanleitung

CrimeStopper

CrimeStopper ST-906.6 Bedienungsanleitung

CrimeStopper

CrimeStopper MIR-DVR Bedienungsanleitung

CrimeStopper

CrimeStopper PARK-EMCU Bedienungsanleitung

CrimeStopper

CrimeStopper SV-9145 Bedienungsanleitung

CrimeStopper

CrimeStopper CS-882 OEM Bedienungsanleitung

CrimeStopper

CrimeStopper CS-6604 Bedienungsanleitung

CrimeStopper

CrimeStopper SV-9145 Bedienungsanleitung

CrimeStopper

CrimeStopper CS-5502 Bedienungsanleitung

CrimeStopper

CrimeStopper EP-3000 Electroplate Bedienungsanleitung

CrimeStopper

CrimeStopper CS-9601PI Kurzanleitung

CrimeStopper

CrimeStopper SAFECALL BM-001 Bedienungsanleitung

CrimeStopper

CrimeStopper MIR-045 Bedienungsanleitung

CrimeStopper

CrimeStopper SafetyPlus SV-9153 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung