Crystal SJ-3560 Bedienungsanleitung
MAGNETIC
RECUMBENT
BIKE
OWNER’S MANUAL
* This item is for consumer use only and it is not meant for commercial use.
Page 1
General Information
Warranty
Body Flex Sports warrants your product for
a period of 1 year for the frame and 90 days
on all parts if the item is used for the intended
purpose, properly maintained and not used
commercially. Any alterations or incorrect
assembly of the product will void this warranty.
Proof of purchase must be presented for any
warranty validation (no exceptions). This
warranty applies to the original purchaser only
and is not transferable.
This warranty does not cover abuse or defects
caused during use, storage or assembly.
During the warranty period, Body Flex Sports
reserves the right to:
a). provide replacement parts to the
purchaser in an effort to repair the item.
b). repair the product returned to our
warehouse (at the purchaser’s cost).
c). replace the product if neither of the two
previously mentioned actions effect repair.
This warranty does not cover normal wear and
tear on upholstery.
Questions
If you have any questions concerning the
assembly of your item or if any parts are
missing, please DO NOT RETURN THE
ITEM TO THE STORE OR CONTACT THE
RETAILER. Our dedicated customer service
staff can help you with any questions you may
have regarding the assembly of this unit and
can also mail you replacement parts.
Customer Support
Customer Support is open 9:00 a.m. to 5:00
p.m. (Pacific Time) Monday through Friday.
Please contact us by any of the following
means.
Safety
Before you undertake any exercise program,
please be sure to consult with your doctor.
Frequent strenuous exercise should be
approved by your doctor and proper use
of your product is essential. Excessive or incorrect
training may result to health injuries. Please read
this manual carefully before commencing the
assembly of your product or starting to exercise.
• Please keep all children away from this item
when in use. Do not allow children to climb or
play on them when they are not in use.
• Supervise teenagers while they use this unit.
• For your own safety, always ensure that there
is at least 3 feet of free space in all directions
around your product while you are exercising.
• Regularly check to see that all nuts, bolts and
fittings are securely tightened. Periodically
check all moving parts for obvious signs of
wear or damage.
• Clean only with a damp cloth, do not use
solvent cleaners. If you are in any doubt, do
not use your product; contact CUSTOMER
SUPPORT.
• Before use, always ensure that your product
is positioned on a solid, flat surface. If
necessary, use a rubber mat underneath to
reduce the possibility of slipping.
• Always wear appropriate clothing and
footwear such as training shoes when
exercising. Do not wear loose clothing that
could become caught in moving parts during
exercise.
• Do not use this unit if it is not functioning
properly or if it is not fully assembled.
• Do not use this unit for commercial purposes.
This unit is for home use only.
Storage and Use
Your product is intended for use in clean
dry conditions. You should avoid storage in
excessively cold or damp places as this may
lead to corrosion and other related problems.
Weight Limit
Your product is suitable for users weighing:
250 pounds or less.
• Before use, you must read and understand all
instructions & warnings stated in this Owner’s
Manual as well as posted on the equipment.
• It is the facility owner’s responsibility to properly
instruct users on the proper operation of the
equipment and to warn them of the potential
hazards.
• If at any time during exercise you feel faint, dizzy
or experience pain, stop and consult your
physician.
Assembling Tools
- Ruler with both metric and English measurements
- 2 x Adjustable Wrenches
- 1 x Philips (”Crosshead”) Screw Driver
•
Any adjustment devices that could interfere with
the user's movement on this unit should not be
left projecting.
SJ-3560
Hangzhou Crystal Sports Equipment Co., Ltd.
Email: [email protected]
Https://hzcrystal.en.alibaba.com/
Http://www.hzcrystal.com/
Tel:+86-0571-69505088
WhatsApp/skype: +8618094780026
Hardware & Tool List
The following hardware is used to assemble your unit. Please take a moment to familiarize yourself with these
items. Please note, most of these parts are already pre-assembled on your unit. Do not be alarmed if you see
parts on this page that are not included in your hardware packet.
#31. Carriage Bolt (M8x60 mm)
[4 pieces]
#32. Bolt (M8x45 mm)
[2 pieces]
#33. Bolt (M8x20 mm)
[4 pieces]
Pre-assembled (4 pieces)
Washer
Bolt
#43. Arc Washer (M8)
[10 pieces]
#45. Washer (M8)
[18 pieces]
#47. Spring Washer (M8)
[6 pieces]
Nut
#40. Nut (M8)
Tool
#34. Bolt (M8x15 mm)
[12 pieces]
#37. Screw (M5x10 mm)
[4 pieces]
#38. Screw (ST4x15 mm)
[2 pieces]
Pre-assembled Pre-assembled
#41. Nylon Nut (M8)
[4 pieces]
[6 pieces]
Pre-assembled [4 pieces] Pre-assembled [4 pieces]
Tool 1 Tool 2
[1 piece]
[1 piece]
Page 2
SJ-3560
Parts Listing
The following parts list describes all of the parts illustrated on the
exploded diagram on the following page. Please note, most of
these parts are already pre-assembled on your unit.
# Description # Description
01 Main Frame 24 Round End Cap (25 mm)
02 Bottom Frame 25 Front Roller
03 Front Stabilizer 26 Rectangular Cap (53x23 mm)
04 Rear Stabilizer 27 Bottom Frame Sleeve
05 Front Post 28 Spring Loaded Knob (M16x25 mm)
06 Cushion Frame 29 Knob Bolt (M8x20 mm)
07 Rear Handle Bar 30 Knob
08 Backrest Cushion 31 Carriage Bolt (M8x60 mm)
09 Seat Cushion 32 Bolt (M8x45 mm)
10 Monitor 33 Bolt (M8x20 mm)
11 Crank 34 Bolt (M8x15 mm)
12L Left Pedal 35 Hex Bolt (M6x50 mm)
12R Right Pedal 36 Screw (M5x45 mm)
13 Water Bottle Holder 37 Screw (M5x10 mm)
14 Foam Grip for Rear Handle Bar 38 Screw (ST4x15 mm)
15 Foam Grip for Front Handle Bar 39 Screw (ST4x20 mm)
16 Tension Controller 40 Nut (M8)
17 Tension Controller Cable 41 Nylon Nut (M8)
18 Monitor Wire (Lower) 42 Nylon Nut (M6)
19 Monitor Wire (Middle) 43 Arc Washer (M8)
20 Monitor Wire (Upper) 44 Arc Washer (M5)
21 Hand Pulse Sensor 45 Washer (M8)
22 End Cap for Front Stabilizer 46 Washer (M6)
23 End Cap for Rear Stabilizer 47 Spring Washer (M8)
Page 3
SJ-3560
Exploded Diagram
The following diagram is provided to help you familiarize yourself with the parts and
hardware that will be used during the assembly process. Please note that not all of the
parts and hardware you see here will be used while you are assembling the machine
because some of these items are already pre-installed. Please continue to the next
page to begin the assembly process and use this page only as a reference guide for
parts and hardware.
Page 4
SJ-3560
#31. Carriage Bolt (M8x60 mm)
[4 pieces]
Washer
Bolt
#43. Arc Washer (M8)
[4 pieces]
Nut
#40. Nut (M8)
[4 pieces]
A.) Front Stabilizer Assembly
Attach the Front Stabilizer (#03) to the front of Main
Frame (#01) as illustrated below using two Carriage
Bolts (#31), two Arc Washers (#43), and two Nuts
(#40). Please note, the Front Stabilizer (#03) is the
one with transportation wheels attached.
B.) Rear Stabilizer Assembly
Attach the Rear Stabilizer (#04) to the back of Main
Frame (#01) as illustrated below using two Carriage
Bolts (#31), two Arc Washers (#43), and two Nuts
(#40).
A s s e m b l y S t e p 1
Page 5
H a r d w a r e R e q u i r e d
Assembly Instructions
Front Rollers
(After assembly is complete,
see Page 12 for instructions on
“HOW TO MOVE/TRANSPORT THE BIKE
FOR STORAGE”)
A
B
SJ-3560
A s s e m b l y S t e p 2
Page 6
Insert the tip of the Tension
controller (#16) wire into the
Tension Controller Cable (#17)
head at an angle. Tilt the Tension
Controller (#16) wire into the
crevice and then pull upward.
TENSION WIRE ASSEMBLY
Hardware Required
Washer
Bolt
#43. Arc Washer (M8)
[4 pieces]
#47. Spring Washer (M8)
[4 pieces]
#34. Bolt (M8x15 mm)
[4 pieces]
Cable & Front Post Assembly
Remove the pre-assembled parts from Main Frame
(#01) and set them aside nearby: Four Bolts (#34),
four Spring Washers (#47), and four Arc Washers
(#43).
With the help of an assistant, connect Monitor Wire
(Middle) (#19) to Monitor Wire (Lower) (#18) as
show in exploded diagram A, and Tension Controller
(#16) to Tension Controller Cable (#17) as shown in
exploded diagram B.
Then, being careful to tuck the connected wires into
the hollow tubing to avoid pinching/damaging the wires,
slide Front Post (#05) onto the protruding tube of
Main Frame (#01). Secure using a total of four Bolts
(#34), four Spring Washers (#47), and four Arc
Washers (#43) that were set side nearby.
AB
Assembly Instructions
SJ-3560
Assembly Step 3
Page 7
Hardware Required
#33. Bolt (M8x20 mm)
[4 pieces]
Washer
Bolt
#45. Washer (M8)
[8 pieces]
Nut
#41. Nylon Nut (M8)
[4 pieces]
Cushion Frame Assembly
Attach the Cushion Frame (#06) to the Bottom Frame
(#02) as illustrated below by inserting four Bolts (#33)
through four Washers (#45) down into the four holes of
the Bottom Frame (#02). Secure using a total of four
Washers (#45) and four Nylon Nuts (#41).
Assembly Instructions
SJ-3560
Assembly Step 4
Page 8
Hardware Required
#32. Bolt (M8x45 mm)
[2 pieces]
Washer
Bolt
#43. Arc Washer (M8)
[2 pieces]
#45. Washer (M8)
[2 pieces]
#47. Spring Washer (M8)
[2 pieces]
Nut
#40. Nut (M8)
[2 pieces]
Rear Handle Bar Assembly
Insert the Rear Handle Bar (#07) into the groove
at the back of the Cushion Frame (#06) as
illustrated below and attach using two Bolts (#32),
through two Arc Washers (#43). Secure using
two Washers (#45), two Spring Washers (#47),
followed by two Nuts (#40).
Assembly Instructions
SJ-3560
Assembly Instructions
A s s e m b l y S t e p 5 Hardware Required
Washer
Bolt
#45. Washer (M8)
[8 pieces]
#34. Bolt (M8x15 mm)
[8 pieces]
Cushion Assembly
Attach the Backrest Cushion (#08) to the vertical
portion of the Cushion Frame (#06) and secure
using four Bolts (#34) and four Washers (#45).
Then, attach the Seat Cushion (#09) to the
horizontal base of the Cushion Frame (#06) by
inserting upward four Bolts (#34) through four
Washers (#45) to secure.
Page 9
SJ-3560
Inhaltsverzeichnis
Beliebte Heimtrainer Handbücher anderer Marken
Stamina
Stamina 1310 Bedienungsanleitung
American Fitness
American Fitness SPR-BK1072A Bedienungsanleitung
Cateye
Cateye CS-1000 (CYCLO SIMULATOR) Bedienungsanleitung
BH FITNESS
BH FITNESS H9158H Bedienerhandbuch
Body Sculpture
Body Sculpture BC-7220G Bedienungsanleitung
Cateye
Cateye EC-2300 Bedienungsanleitung
