c) Calories Mode
Tap on the display as many times as necessary until the top line of the display shows
the word ‘KCAL’. This shows the total calories burned.
d) Activity Time
Tap on the display as many times as necessary until
the top line of the display shows the stopwatch icon.
This records the total time in hours and minutes walked.
e) Clearing the pedometer data and resetting to ‘0’
-Tap on the display as many times as necessary until the top line of the display
shows STEP mode
-Press and hold the SET button for 2 seconds until the word ‘CLR’ on the
display blinks
-Press SET button to confirm
-All pedometer data will be cleared and reset to ‘0’. Otherwise, if left idle for
10 seconds, it will go back to step mode and keep the data
Note: Pedometer data can only be cleared in step mode.
AUTO SHUT OFF / AUTO RESUME
To conserve battery power, the display will turn off automatically when no motion is
detected for 30 seconds. Once motion is detected, the display will automatically turn
on and resume counting steps.
CHANGING THE BATTERIES
The pedometer uses 2 ‘AG-10’(or equivalent size) button cell batteries.
Replace the batteries when the display becomes dim or when the pedometer
function is not working properly.
-Remove the 4 screws from the back cover with a screwdriver
-Take out the old batteries
-Replace with fresh batteries. Make sure they are inserted in their correct
polarity position
-Make sure the battery contact area on the inside of the case is aligned and
touching the battery before screwing it back into place
