CTC Union FRM220-FXO Bedienungsanleitung

Technical Specifications

Installation Guide for

FRM220-FXO/FXS & FRM220-FXO/FXS-S

FXO/FXS POTS Over Fiber Optic

Slide-in-Module Media Converter

Description

CTC Union’s FRM220-FXO/FXS POTS & FRM220-FXO/FXS-S over fiber media

converter connect central-office voice grade signal to distant POTS (Plain Old Telephone

Service) equipment using standard telephone signaling. It can extend, over fiber, the

distance between two voice path communication devices by up to 120km using single

mode fiber.

The FRM220-FXO/FXS & FRM220-FXO/FXS-S provide audio transmission, caller ID,

ringing at the distant end and automatic ring down. Two units are required to implement

an end to end system. The RJ-11 connector provides the electrical interface between the

media converter and the telephone device or PSTN.

The FRM220-FXO/FXS & FRM220-FXO/FXS-S are designed to be installed in FRM220-

CH20 (20 slots Chassis) for CO side or installed in FRM220-CH01(1 slot Chassis) for

CPE stand-alone.

V3.3

Copper Connector

•FXO/FXS: Selectable

•Phone Connector: RJ-11C

FXS Mode

•Impedance: 600 ohm

•Coding: 16 bits linear

•Dial: DTMF and Pulse Dial

•Battery Source: 48VDC 4V

•Ringing Waveform: Sine wave

•Ringing Supply: 60Vrms10%

•Ring Frequency: 20/25/30/35/40/45/50/55 Hz selectable

•Ring Cadence: FXS to FXS : On / 1 second, Off / 2 second

•FXO to FXS : Reproduces the cadence of FXO

•Insertion Loss: 0.01.0 dB at 1000Hz

•REN: 4.0B (Ring Equivalence Number)

FXO Mode

•Impedance: 600 ohm

•Coding: 16 bits linear

•Loop Current: 10 ~ 100mA

•Ring Frequency: Acceptable 20 ~ 55Hz

•Insertion Loss: 0.01.0dB at 1000Hz

Environment

•Operating Temperature: 0 ~ 50°C

•Storage Temperature: -10 ~ 60°C

•Humidity: 5 ~ 90% non condensing

Dimension (Card Only)

•88mm (W) x 137mm (D) x 20.8mm (H)

Weight

•Card Only: 127g

Power

•DC +12V / 800mA input

•Power Consumption: 5 W

General Specifications

Panels

6 1

6 2

FRM220-FXO/FXS

FRM220-FXO/FXS-S

1 Fixed fiber connections

2 SFP slot

3 RJ-11C connections

4 External DIP switches

5 LED indicators

6 DC power jack

1 2

Installation

Connect the RJ-11 cable to the FRM220-FXO/FXS or FRM220-FXO/FXS-S. The

converter should be setup to operate in FXO or FXS mode and the fiber link will be

indicated on the LED. Follow the connection examples below. Install the fiber converter

with the DC power adapter provided (+12VDC, 800mA) and connect the adapter to an

AC outlet.

Connections

The following example illustrates the connection scheme when connecting PBX or

PSTN to telephone through the fiber converter.

The following example illustrates the Automatic Ring-Down connection scheme (Hot

Line) when connecting telephone to telephone through the fiber converter.

LED Indicators

LED Function State Status

PWR Power Indicator Green Converter has power.

Off Converter has no power.

LNK Fiber Link Green The fiber link is ok.

Off No link or the link is faulty.

ACT Phone Status Green Activity.

Off Idle.

Flash Ringing.

TEST Test Status Red When in any loop back mode .

TEST

ACT

LNK

PWR

Fiber Cable FXSFXS

TelephoneTelephone

Fiber Cable FXSFXO

Telephone

PBX

DIP Switch Setting (for firmware version 3.03)

DIP SW State Main Mode

setting DIP SW State

Sub-function

-1 -2 -3 -4

OFF

FXS Mode

20~35Hz

OFF OFF Ring frequency, 20Hz

ON OFF Ring frequency, 25Hz

OFF ON Ring frequency, 30Hz

ON ON Ring frequency, 35Hz

ON ON

FXS Mode

40~55Hz

OFF OFF Ring frequency, 40Hz

ON OFF Ring frequency, 45Hz

OFF ON Ring frequency, 50Hz

ON ON Ring frequency, 55Hz

ON OFF FXO Mode

OFF OFF Ring frequency,

20/25Hz

ON OFF Ring frequency,

30/35Hz

OFF ON Ring frequency,

40/45Hz

ON ON Ring frequency,

50/55Hz

When installing with NMC in CH20, the NMC-R2 version must be 3.26 or above to manage these settings.

As with all FRM220 series products, once installed in the managed chassis, the DIP settings have no

effect. All setting is then performed via the Network Management Controller (NMC) of the chassis.

3 4

For FRM220-FXO/FXS, two connectors are provided for fiber optic cable

connection. One is labeled "TX" for transmission of optical data, the other is

labeled "RX" for reception of optical data.

For FRM220-FXO/FXS-S, a SFP slot is provided on the panel. You need to

prepare a SFP transceiver that comply with specifications of this device so as to

establish fiber connections.

Fiber Connections

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere CTC Union Medienkonverter Handbücher

CTC Union

CTC Union FMC-10/100LF Bedienungsanleitung

CTC Union

CTC Union FIB1-1000ES Bedienungsanleitung

CTC Union

CTC Union FMC-1001S Bedienungsanleitung

CTC Union

CTC Union FIB-232A-ST Bedienungsanleitung

CTC Union

CTC Union IMC-1000C Bedienungsanleitung

CTC Union

CTC Union FTH4-1000MS Bedienungsanleitung

CTC Union

CTC Union IMC-1000M-PH12 Bedienungsanleitung

CTC Union

CTC Union FRM220-1000E-1 Bedienungsanleitung

CTC Union

CTC Union FMC-10/100I series Bedienungsanleitung

CTC Union

CTC Union FRM220 Bedienungsanleitung

CTC Union

CTC Union IMC-100 Bedienungsanleitung

CTC Union

CTC Union IFC-Serial Bedienungsanleitung

CTC Union

CTC Union IMC-100-E Bedienungsanleitung

CTC Union

CTC Union FRM220-10/100iS-2 Bedienungsanleitung

CTC Union

CTC Union FRM220-FXO-4 Bedienungsanleitung

CTC Union

CTC Union FRM220-CCF40 Bedienungsanleitung

CTC Union

CTC Union IMC-100-PH12 Bedienungsanleitung

CTC Union

CTC Union IMC-1000M Bedienungsanleitung

CTC Union

CTC Union FRM220-2000MS Bedienungsanleitung

CTC Union

CTC Union FMC-1000S Bedienungsanleitung

CTC Union

CTC Union IMC-1000M Bedienungsanleitung

CTC Union

CTC Union FMC-2000MS Bedienungsanleitung

CTC Union

CTC Union IMC-1001C-E Bedienungsanleitung

CTC Union

CTC Union FRM220-1000MS Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung