Culligan WH-HD200-C Bedienungsanleitung

Whole House Water

Filtration

Installation and operating instructions

Model WH-HD200-C

Sistema de ﬁltración

de agua completo para

el hogar

Instrucciones de instalación y uso

Modelo WH-HD200-C

Système de ﬁltration de

l'eau pour toute la maison

Guide d'installation et d'utilisation

Modèle WH-HD200-C

WHOLE HOUSE | RESIDENCIA COMPLETA | TOUTE LA MAISON

PRECAUTIONS

WARNING: Do not use with water that is microbiologically unsafe or of unknown source/quality without

adequate disinfection before or after the system.

CAUTION: Filter housing must be protected against freezing temperatures, frost, snow, sleet, and ice.

Exposure to these elements can produce cracks and product failures.

CAUTION: The rubber O-Ring provides the water-tight seal between the ﬁlter head and the housing.

It is important that the O-Ring be properly seated in the O-Ring groove or a water leak will occur.

CAUTION: This product has a limited service life. We recommend that a record be kept regarding the

date of install and any other performed maintenance. In addition, the entire ﬁlter housing should be

routinely inspected for signs of stress marks, cracking, chipping, warping, and discoloration. If this

ﬁltration system shows any of these signs of wear, the entire unit should be replaced immediately.

CAUTION: Clear housings may crack or warp over time causing failure and leakage if exposed to

organic solvents, such as those found in aerosol sprays for cleaning products and insecticides.

• For cold water use only. Do not use on hot water line or in areas where the temperature surrounding

the unit exceeds 100°F.

• Keep out of direct sunlight. UV rays can weaken the integrity of the ﬁlter housing, and also promotes

biological growth within the unit.

• Make certain that installation complies with all state and local laws and regulations.

• The contaminants or other substances removed or reduced by the selected cartridge are not

necessarily in your water. Ask your local water municipality for a copy of their water analysis,

or have your water tested by a reputable water testing lab.

• After prolonged periods of non-use (such as during a vacation) it is recommended that the system

be ﬂushed thoroughly. Let water run for 5–6 minutes before using.

• All ﬁlter cartridges recommended for use with this system carry a limited service life. Changes in

taste, odor, color, and/or ﬂow of the water being ﬁltered indicate that the cartridge should be replaced.

• Some harmless bacteria may attack cellulose media cartridges. If your cartridge seems to disintegrate

or develops a musty or moldy odor, switch to a synthetic media cartridge or consult the manufacturer.

SPECIFICATIONS

Pressure Range: 30 –100 psi (2.1– 6.9 bar)

Temperature Range: 40 –100°F (4.4 – 37.7°C)

OPTIONAL MATERIALS

SOLD SEPARATELY:

• OR-250 Replacement O-Ring

TOOLS REQUIRED

• Pipe Cutter or Hacksaw

• 2 Adjustable Wrenches

• File

• Pencil

PARTS

INCLUDED:

• Filter Housing

• WR-HD Housing Wrench

• BR-C Mounting Bracket

• Filter Life Monitor

• Timer Battery (Pre-Installed)

NOT INCLUDED:

• Installation Fittings

• Teﬂon® Tape

NOTE: Galvanized ﬁttings must be used for

installation on galvanized pipe.

1-800-721-7360 MONDAY–FRIDAY 8:00AM–4:30PM (CST)

English

PARTS INCLUDED:

Filter Head

Filter Life Indicator Holder

Filter Life Indicator

Bypass Valve

OR-250 O-Ring

Housing

WR-HD Housing Wrench

BR-C Mounting Bracket

Mounting Screws

INSTALLATION

• Install ﬁlter after water meter or pressure tank.

• Only Teﬂon® tape is recommended for ﬁtting connections.

• Instructions are for installing 1˝ compression ﬁttings

(separate ﬁttings required for other sizes and non-copper pipe).

Turn off water supply (A) and open nearest

faucet to drain pipes before installation.

Apply about 6˝ of Teﬂon® tape (B) in clockwise

direction to pipe threads of each adapter.

IMPORTANT: When choosing location allow

1-1/2˝– 2˝ clearance below housing to allow

for ﬁlter changes.

If using optional BR-C mounting bracket, start by

making sure the arrows facing you on the system

are consistent with the direction of your water

ﬂow. If necessary, remove ﬁlter life indicator

holder if on the back side of the unit, and move

it to the front. Align the holes of the bracket with

the holes on the back of the ﬁlter head. Insert four

mounting screws through the bracket and into the

ﬁlter head until tight. Otherwise skip to step 3.

Assemble all ﬁttings. Start adapters (not

included) into ﬁlter head by hand. Use a wrench

to tighten ﬁrmly.

DO NOT OVER-TIGHTEN.

Slip brass compression nut and ferrule onto each

end of 1˝ pipe.

Using a pipe cutter or hacksaw, cut and remove

marked section of pipe. File or sand sharp edges

on remaining pipe.

Measure overall length of conﬁgured system

with adapters attached.

Reduce this measurement enough to allow for

full engagement of the pipe into the adapters and

determine how much pipe to remove (X).

Mark section of pipe to be removed

Align ﬁlter assembly with ends of pipe, making

certain your water ﬂow is in the same direction as

the arrows on your ﬁlter head. It will be necessary

to spread ends of pipe apart to install ﬁlter

assembly. Using two adjustable wrenches, hold

incoming ﬁtting securely with one wrench and

tighten nut with second wrench. Repeat process

for outgoing ﬁtting.

BRASS COMPRESSION NUT

FERRULE

6 7

CAUTION: If water pipes are used to ground

electrical systems, appliances or phones, be

certain to install a jumper wire.

If using optional mounting bracket attach

it to the wall using four mounting screws

(not included).

8 9

Ensure the ﬁlter housing has been properly

tightened using the housing wrench provided.

Turn bypass valve to “Filter” mode using wrench,

then slowly turn on main water supply.

Slowly press red pressure-relief button on top

of ﬁlter to release trapped air. Check for leaks.

Open nearest faucet and ﬂush ﬁlter cartridge

for 10 minutes.

Reset ﬁlter life indicator (hold reset button

for 2 seconds).

FILTER CARTRIDGE REPLACEMENT

Lubricate O-Ring with a coating of clean

food-grade silicone grease. Insert O-Ring back

into groove and smooth into place with ﬁnger.

NOTE: This step is important to ensure proper

housing seal. Make certain O-Ring is seated

level in the groove.

Insert new cartridge into housing.

Make certain it slips over the standpipe

at the bottom of the housing.

Turn water off by rotating bypass valve to

“Off” or “Bypass.”

NOTE: Turning bypass to “Off” will shut off all

water ﬂow within the household.

Press red pressure-relief button to relieve

pressure. Unscrew bottom of housing. Remove

O-Ring from groove in housing and wipe clean

and set aside. Discard used cartridge.

Rinse out housing and ﬁll 1/3 with water.

Add 2 tablespoons of bleach and scrub with

nonabrasive brush or sponge. Rinse thoroughly.

OPEN

TIMER APPLICATION INSTRUCTIONS

AND BATTERY REPLACEMENT

APPLICATION AND RESET

After new battery is installed or ﬁlter is changed, push and hold the ﬁlter life reset button for

approximately 2 seconds until green light ﬂashes. The light will ﬂash red in 90 days to remind you that it

is time to change the ﬁlter.

BATTERY REPLACEMENT

1. Insert small screwdriver on the base of the indicator holder to remove it from the housing.

2. Insert small screwdriver on the bottom ﬂat side of the ﬁlter life indicator. Gently pry open and separate

timer base from cap.

3. Carefully remove the circuit board and slide old battery out of holder. Change battery (#2032).

4. Carefully line up and place circuit board back into housing.

5. Line up the base and cap and snap back together. Place indicator back into housing.

6. Reset ﬁlter life indicator to start timer (hold reset button for 2 seconds). It is recommended that you

change the battery every year to ensure your indicator works properly.

Screw the bottom of housing onto the cap until

tight. DO NOT OVER-TIGHTEN. Make certain

standpipe in ﬁlter head slips into cartridge.

Slowly turn bypass valve to “Filter” to allow

system to ﬁll with water. Slowly press red

pressure-relief button to release trapped air.

Check for leaks.

Reset ﬁlter life indicator (hold reset button for

2 seconds).

NOTE: Flush ﬁlter cartridge for 10 minutes

before use.

FILTER CARTRIDGE SELECTION GUIDE

TROUBLESHOOTING

LEAKS BETWEEN FILTER HEAD AND HOUSING:

1. Turn off water supply and press the red pressure-relief button. Remove bottom of housing.

2. Clean O-Ring and O-Ring groove (located directly beneath threads of housing). Lubricate O-Ring

with clean silicone grease and replace securely into groove. Screw housing into ﬁlter head and

hand-tighten. DO NOT OVER-TIGHTEN.

LEAKS FROM INLET/OUTLET CONNECTIONS:

1. Turn off water supply. For brass ﬁttings, tighten nut snugly about 1/2-turn with a wrench.

2. Turn on water supply. If leaks persist, or if there are other leaks on system, turn off water supply.

Call Technical Support at 1-800-721-7360.

* Cartridge life varies depending on ﬁlter type, usage and water

conditions (one month = approximately 4000 gallons).

** The smaller the micron rating, the smaller the size particle the

cartridge will ﬁlter. For comparison purposes, the human hair

has a diameter of approximately 70 microns. Particles smaller

than 40 microns are not visible to the human eye.

R50-BBSA, CW25-BBS, CP5-BBS, CW5-BBS and RFC-BBSA are

not certiﬁed by WQA.

† Not Performance Tested or Certiﬁed by WQA.

R50-BBSA1CW25-BBS1CP5-BBS1RFC-BBS1A

PROBLEMS

Sediment

†

Rust

†

Scale

†

Dirt

†

Coarse Sand

†

Sand

†

Fine Sand

†

Silt

†

Bad Taste & Odor

†

Aesthetic Chlorine Taste & Odor

†

Cartridge Life *

†

Micron Rating **

†

Cartridge Material

Recommended for Well Water

6 months

24,000 gallons 5 months

20,000 gallons 3 months

12,000 gallons 6 months

10,000 gallons

Pleated

Polyester Wound

Polypropylene Pleated

Cellulose Granular-Activated

Carbon

50 25 525

CW5-BBS1

4 months

16,000 gallons

Wound

Polypropylene

Select the right cartridge

for your water

FILTER SELECTION GUIDE

Inhaltsverzeichnis

Sprachen:

Andere Culligan Wasserfiltersystem Handbücher

Culligan

Culligan Aqua-Cleer Bedienungsanleitung

Culligan

Culligan GoodWater Machine DrinkingWater System Bedienungsanleitung

Culligan

Culligan ClearLink Pro Bedienungsanleitung

Culligan

Culligan RVF-10 Bedienungsanleitung

Culligan

Culligan G1 Series Handbuch

Culligan

Culligan SILVER SERIES Bedienungsanleitung

Culligan

Culligan Gold Arsenic Series Bedienungsanleitung

Culligan

Culligan HF-360 Bedienungsanleitung

Culligan

Culligan AQUA-CLEER BXL Series Bedienungsanleitung

Culligan

Culligan CSM Series Service-Handbuch

Culligan

Culligan RAINDISC RDSH-C115 Bedienungsanleitung

Culligan

Culligan WH-S100-O Bedienungsanleitung

Culligan

Culligan RVF-10 Bedienungsanleitung

Culligan

Culligan US-2 Bedienungsanleitung

Culligan

Culligan Aquasential 2021 Bedienungsanleitung

Culligan

Culligan HF-160 Bedienungsanleitung

Culligan

Culligan Iron-Cleer Datenblatt

Culligan

Culligan Aqua-Cleer H-82 WT Bedienungsanleitung

Culligan

Culligan US-DC1 Bedienungsanleitung

Culligan

Culligan Mark 59 Bedienungsanleitung

Culligan

Culligan 01036140 Bedienungsanleitung

Culligan

Culligan Medallist Plus Sulfur-OX3 Bedienungsanleitung

Culligan

Culligan Sulfur-Cleer Bedienungsanleitung

Culligan

Culligan US-EZ Bedienungsanleitung

Beliebte Wasserfiltersystem Handbücher anderer Marken

Wisy

Wisy LineAir 100 Bedienungsanleitung

Schaffner

Schaffner Ecosine FN3446 Series Betriebsanleitung

Pentair

Pentair FLECK 4600 SXT Benutzerhandbuch

H2O International

H2O International H20-500 Bedienungsanleitung

Renkforce

Renkforce 2306241 Bedienungsanleitung

Neo-Pure

Neo-Pure TL3-A502 Bedienungsanleitung

FLTR

FLTR OBF Bedienungsanleitung

STA-RITE

STA-RITE VERTICAL GRID DE FILTERS S7D75 Bedienungsanleitung

Applied Membranes

Applied Membranes W-G844EM Bedienungsanleitung

BEGA

BEGA 116 Bedienungsanleitung

WATA

WATA Standard Bedienungsanleitung

Price

Price FFU series Handbuch

Gaggenau

Gaggenau BRITA INTENZA 467873 Bedienungsanleitung

Brita

Brita SAFF-100 Bedienungsanleitung

HEISSNER

HEISSNER FPU24000-00 Bedienungsanleitung

BGS technic

BGS technic 1518 Bedienungsanleitung

Reverse Osmosis

Reverse Osmosis RF Series Bedienungsanleitung

ubbink

ubbink Filtramax Series Bedienungsanleitung