CYP CH-506RXWP Bedienungsanleitung
DRAFT
CH-506TXWP & RXWP
HDMI & IR over Single CAT5e/CAT6
Operation Manual
Operation Manual
DRAFT
DRAFT
DISCLAIMERS
The information in this manual has been carefully checked and
is believed to be accurate. Cypress Technology assumes no
responsibility for any infringements of patents or other rights of third
parties which may result from its use.
Cypress Technology assumes no responsibility for any inaccuracies
that may be contained in this document. Cypress also makes no
commitment to update or to keep current the information contained
in this document.
Cypress Technology reserves the right to make improvements to this
document and/or product at any time and without notice.
COPYRIGHT NOTICE
No part of this document may be reproduced, transmitted,
transcribed, stored in a retrieval system, or any of its part translated
into any language or computer le, in any form or by any means—
electronic, mechanical, magnetic, optical, chemical, manual, or
otherwise—without express written permission and consent from
Cypress Technology.
© Copyright 2012 by Cypress Technology.
All Rights Reserved.
Version 1.1 June 2012
TRADEMARK ACKNOWLEDGMENTS
All products or service names mentioned in this document may be
trademarks of the companies with which they are associated.
DRAFT
SAFETY PRECAUTIONS
Please read all instructions before attempting to unpack, install or
operate this equipment and before connecting the power supply.
Please keep the following in mind as you unpack and install this
equipment:
• Always follow basic safety precautions to reduce the risk of re,
electrical shock and injury to persons.
• To prevent re or shock hazard, do not expose the unit to rain,
moisture or install this product near water.
• Never spill liquid of any kind on or into this product.
• Never push an object of any kind into this product through any
openings or empty slots in the unit, as you may damage parts
inside the unit.
• Do not attach the power supply cabling to building surfaces.
• Use only the supplied power supply unit (PSU). Do not use the PSU
if it is damaged.
• Do not allow anything to rest on the power cabling or allow any
weight to be placed upon it or any person walk on it.
• To protect the unit from overheating, do not block any vents or
openings in the unit housing that provide ventilation and allow for
sufcient space for air to circulate around the unit.
REVISION HISTORY
VERSION NO. DATE DD/MM/YY SUMMARY OF CHANGE
RDV1 14/02/12 Preliminary Release
DRAFT
CONTENTS
1. Introduction............................................ 1
2. Applications........................................... 1
3. Package Contents ................................ 1
4. System Requirements............................ 1
5. Features.................................................. 2
6. Operation Controls and Functions....... 3
6.1 Transmitter.........................................3
6.2 Receiver ............................................4
7. D-Sub 9 Pin Denitions........................... 5
8. Connection Diagram ............................ 6
9. Specications ........................................ 7
10. Acronyms ............................................. 8
DRAFT
1
1. INTRODUCTION
The device that can make your home or ofce more efcient, this unit
of HDMI over Single CAT5e/6 can transmit and receive uncompressed
audio/video, control through the built-in RS-232 and IR ports and
Power on Ethernet(POE) over 100M with all plate design. Hence, if you
want to make your home or ofce more efcient, get the HDMI & IR
over single CAT5e/CAT6 and prepare to be amazed.
2. APPLICATIONS
• Household entertainment sharing and control
• Lecture room display and control
• Showroom display and control
• Meeting room presentation and control
• Classroom display and control
3. PACKAGE CONTENTS
• HDMI & IR over Single CAT5e/CAT6 Transmitter x 1
• HDMI & IR over Single CAT5e/CAT6 Receiver x 1
• IR Blaster x 1
• IR Receiver x 1
• 3.5Ø to RS-232 female cable x 1 for transmitter
• 3.5Ø to RS-232 male cable x 1 for receiver
• 24V/1.25A DC Power Adaptor x 1
• Operation Manual
4. SYSTEM REQUIREMENTS
Input HDMI source equipment such as DVD/Blue-Ray player and
output display with HDMI input jack.
DRAFT
2
5. FEATURES
• HDMI 1.4 with 3D, 4k x 2k support, HDCP & DVI Compliant
• Supports HDCP repeater and CEC bypass
• Simultaneously uncompressed data sending over a single
100M/328ft with CAT6 or CAT5e cable
• Uncompressed video 1080p, 60Hz, 36bits
• Audio support up to 7.1CH & Dolby TrueHD, DTS-HD
• 4Play™ convergence: HDMI, POE & Control (IR & RS232)
• Wall plate design and Installation Friendly
Note: This system was tested with CAT6/23AWG cable, so if using
cables of another type, results may vary.
DRAFT
3
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter
LINK
POWER
DC 24V
RS232
IN
IR 2
IN
IR 1
OUT
HDMI
IN
RearFront
82 31 4
5
6
7
1RS-232 IN: This slot is to connect with 3.5Ø phone jack RS-232 cable
from PC/NB equipment for sending RS-232 commands.
2IR 2 IN: This slot is to connect with the IR receiver cable included in
the package for IR signal receiving.
3IR 1 OUT: This slot is to connect with the IR blaster cableincluded in
the package for IR signal transmitting.
4HDMI IN: This slot is to connect with HDMI source equipment such
as DVD/Blu-ray player.
5POWER LED: This green LED will illuminate when the device is
attached with power supply.
6LINK LED: This yellow LED will illuminate when the both CAT5e/6
input and output signal is connected.
7DC 24V: This slot is where you plug the 24V DC power supply into
the unit and connect the adaptor to an AC outlet.
8CAT5e/6 Out: Connect to the receiver unit with a single CAT5e/6
cable for transmission of all data signals.
DRAFT
4
6.2 Receiver
LINK
POWER
RS232
OUT
IR 1
IN
IR 2
OUT
HDMI
OUT
RearFront
72 31 4
5
6
1RS-232 OUT: This slot is to connect with 3.5Ø phone jack RS-232
cable from device equipment for receiving RS-232 commands.
2IR 1 IN: This slot is to connect with the IR receiver cable included in
the package for IR signal receiving.
3IR 2 OUT: This slot is to connect with the IR blaster cableincluded in
the package for IR signal transmitting.
4HDMI OUT: This slot is to connect with HDMI TV/monitor for display
HDMI input source signal.
5Power LED: This green LED will illuminate when the device is
connected to a power supply.
6LINK LED: This yellow LED will illuminate when the both CAT5e/6
input and output signal is connected.
7CAT5e/6 In: This slot is to be connected with a single CAT5e/6
cable from transmitter side for data transmitting.
DRAFT
5
7. D-SUB 9 PIN DEFINITIONS
Pin Dene TX/RX
1 N/C
2TxD/RxD
3RxD/TxD
4 N/C
5 GND
6 N/C
7 N/C
8 N/C
9 N/C
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere CYP Sender Handbücher
CYP
CYP CHDBT-1H7CE Bedienungsanleitung
CYP
CYP PUV-1605S-TXWP Bedienungsanleitung
CYP
CYP CH-331H-TX Bedienungsanleitung
CYP
CYP PUV-3090TX-UEA Bedienungsanleitung
CYP
CYP PUV-3050TX-UA Bedienungsanleitung
CYP
CYP PRO-SDIOF-KIT Bedienungsanleitung
CYP
CYP CH-2602TXWPUS Bedienungsanleitung
CYP
CYP CH-1527TXPLV Bedienungsanleitung
CYP
CYP IP-A750TX Bedienungsanleitung
CYP
CYP PU-501 Bedienungsanleitung
CYP
CYP CPLUS-12FTX Bedienungsanleitung
CYP
CYP PUV-1510RXWP Bedienungsanleitung
CYP
CYP CH-U331TX Bedienungsanleitung
CYP
CYP PUV-1602TXWP Bedienungsanleitung
CYP
CYP CH-516TXAS Bedienungsanleitung
CYP
CYP PUV-1630TXWP-EU Bedienungsanleitung
CYP
CYP PU-USB2-KIT Bedienungsanleitung
CYP
CYP AVX-101F-TX Bedienungsanleitung
CYP
CYP PU-305BD-TX Bedienungsanleitung
CYP
CYP CH-1529TXPLV Bedienungsanleitung
Beliebte Sender Handbücher anderer Marken
Dejero
Dejero EnGo 3x Bedienungsanleitung
Rosemount
Rosemount 4600 Bedienungsanleitung
Speaka Professional
Speaka Professional 2342740 Bedienungsanleitung
trubomat
trubomat GAB 1000 Bedienungsanleitung
Teledyne Analytical Instruments
Teledyne Analytical Instruments LXT-380 Bedienungsanleitung
Rondish
Rondish UT-11 Bedienungsanleitung
