Cypress CPRO-3D42S Bedienungsanleitung

CPRO-3D42S

4 by 2 HDMI Switcher with HEAC

Operation Manual

DISCLAIMERS

The information in this manual has been carefully checked and

is believed to be accurate. Cypress Technology assumes no

responsibility for any infringements of patents or other rights of third

parties which may result from its use.

Cypress Technology assumes no responsibility for any inaccuracies

that may be contained in this document. Cypress also makes no

commitment to update or to keep current the information contained

in this document.

Cypress Technology reserves the right to make improvements to this

document and/or product at any time and without notice.

No part of this document may be reproduced, transmitted,

transcribed, stored in a retrieval system, or any of its part translated

LQWRDQ\ODQJXDJHRUFRPSXWHUÀOHLQDQ\IRUPRUE\DQ\PHDQV³

electronic, mechanical, magnetic, optical, chemical, manual, or

RWKHUZLVH³ZLWKRXWH[SUHVVZULWWHQSHUPLVVLRQDQGFRQVHQWIURP

Cypress Technology.

Version 1.1 August 2011

TRADEMARK ACKNOWLEDGMENTS

All products or service names mentioned in this document may be

trademarks of the companies with which they are associated.

SAFETY PRECAUTIONS

Please read all instructions before attempting to unpack, install or

operate this equipment and before connecting the power supply.

Please keep the following in mind as you unpack and install this

equipment:

 $OZD\VIROORZEDVLFVDIHW\SUHFDXWLRQVWRUHGXFHWKHULVNRIÀUH

electrical shock and injury to persons.

 7RSUHYHQWÀUHRUVKRFNKD]DUGGRQRWH[SRVHWKHXQLWWRUDLQ

moisture or install this product near water.

 Never spill liquid of any kind on or into this product.

 Never push an object of any kind into this product through any

openings or empty slots in the unit, as you may damage parts

inside the unit.

 Do not attach the power supply cabling to building surfaces.

 Use only the supplied power supply unit (PSU). Do not use the PSU

if it is damaged.

 Do not allow anything to rest on the power cabling or allow any

weight to be placed upon it or any person walk on it.

 To protect the unit from overheating, do not block any vents or

openings in the unit housing that provide ventilation and allow for

VXIÀFLHQWVSDFHIRUDLUWRFLUFXODWHDURXQGWKHXQLW

REVISION HISTORY

VERSION NO. DATE DD/MM/YY SUMMARY OF CHANGE

VS1 09/02/12 First Release

VR2 06/03/12 CEC function on output 1 only

VR3 13/12/12 Testing Model

CONTENTS

1. Introduction............................................ 1

2. Applications........................................... 1

3. Package Contents ................................ 1

4. System Requirements............................ 1

5. Features .................................................. 2

6. Operation Controls and Functions....... 3

6.1 Front Panel ........................................3

6.2 Rear Panel.........................................4

6.3 Remote Control................................5

6.4 RS232 Protocol and Command......6

7. Connection Diagram ............................ 7

6SHFLÀFDWLRQV ........................................ 8

9. Acronyms ............................................... 9

1. INTRODUCTION

This is a high performance HDMI™ Switcher with four HDMI inputs &

two outputs HDMI™ Switcher, the output ports support Audio Return

Channel (ARC) from a compaitble ARC TV and HDMI Ethernet

&KDQQHO+(&IROORZLQJWKH+'0,VSHFLÀFDWLRQ

The HDMI Switcher provides an S/PDIF link from the HDMI signal and

RXWSXWWKURXJKWKH$5&SRUWWRDQ$95DPSOLÀHUWRJHWDXGLRIURP

the sink.

The HEC feature adds a network connection to the HDMI link 100Mbps

Ethernet connection. Using an HDMI with HEAC cable allows for the

convenient integration of internet capable HEAC Televisions into the

end user’s home network system.

2. APPLICATIONS

 Simultaneously display a HDMI source on 2 TVs/displays

 Connect internet capable devices through HEC to network routers/

modems

 Connect network attached media streaming devices to

compatible HEAC TV

 Showroom displays

 Educational demonsrations

 Commercial usage

3. PACKAGE CONTENTS

 4 × 2 HDMI Switcher with HEAC

 5 V/2.6 A DC power supply adaptor

 Operation Manual

4. SYSTEM REQUIREMENTS

 Source equipment with HDMI output connector(s)

 Displays TV with HDMI HEAC input connector(s)

5. FEATURES

 6XSSRUWVPXOWLSOH[HG+'0,LQSXWDQGRXWSXW

 Two output ports supporting Ethernet Channel (HEC) and Audio

5HWXUQ&KDQQHO$5&IROORZLQJWKH+'0,VSHFLÀFDWLRQ

 HDMI supports:

Audio Return Channel (ARC)

3D

 +'0,(WKHUQHW&KDQQHO+(&HQDEOLQJKLJKVSHHGELGLUHFWLRQDO

networking at up to 100 Mb/sec

 'HHS&RORUVXSSRUWELW

 EDID optiions include Standard, TV or Lock EDID feature

 Supports CEC bypass on HDMI OUT 1

 Audio support:

HDMI compatible audio interface

S/PDIF pass through

6. OPERATION CONTROLS AND FUNCTIONS

6.1 Front Panel

INPUT TVSTD LOCK POWEREDID

3D2CH 4321

BITSTREAM

LPCM 5.1/7.1

1 52 3 4

IR Remote Control Sensor

Audio/3D Content Indicator

The system will automatically detect incoming audio/video signal

type and the green LEDs will illuminate accordingly.

Input Selection

Press input button to select input source, the Blue LED will illuminate

accordingly. If none of the LEDs are illuminated then no input

has been selected, this is to allow the device to access the ARC

feature alone.

EDID Selection

The EDID control button selects

between using the EDID from the

display attached to Output 1/TV or

using the onboard EDID/STD (the

Green LED will illuminate accordingly).

When the EDID button is pressed for

longer then 3 seconds, the RED LED will

illuminate to indicate that the EDID is already locked to STD or TV

EDID as you selected accordingly. When EDID is set on STD audio

will support PCM 2CH, video modes supported are listed in the

table above.

Power Button

Press this button to switch on the device or press it again to set it to

standby mode.

8 10 12

RGB 999

Y444 9 8 8

Y422 9

XvYCC 9 8 8

6.2 Rear Panel

DC 5V

HDMI IN

1 2

RS-232

HDMI OUT

1 2 1 2 1 2 3 4

ETHERNET

SPDIF/ARC

OUT

1 2 3 4

RS-232

7KLVVORWLVWRFRQQHFWZLWKD3&RUFRQWUROV\VWHPZLWK'VXESLQ

FDEOHIRU56FRQWURO)RUGHWDLO56FRPPDQGVSOHDVHUHIHU

to Section 6.4.

HDMI OUT 1~2/ARC 1~2/ETHERNET 1~2

HDMI/HEAC equipped TVs or displays will pass the Ethernet and

Audio signals via HDMI cable back to the HDMI Output port, the

splitter will separate the Ethernet and audio, and will output audio

IURPWKH$5&DQGELGLUHFWLRQDOGDWDVWUHDPVWKURXJKWKH(WKHUQHW

SRUWV,IWKHGLVSOD\KDVDEXLOWLQWXQHURUDQDWWDFKHG'9'SOD\HU

audio content can be sent “upstream” from the TV back to the

DXGLRV\VWHPWREHRXWSXWLQPXOWLFKDQQHODXGLR

The HDMI Switcher can use the HDMI Ethernet Channel (HEC) to

consolidate video, audio and data streams into a single HDMI

cable connection to an Ethernet Hub/modem in order to access

the internet and also incorporates a dedicated data channel

LQWRWKH+'0,OLQNHQDEOLQJKLJKVSHHGELGLUHFWLRQDOQHWZRUNLQJ

at up to 100 Mb to control and search from the sink (please see

Section 6 for connection diagram). The HDMI output number is

correspondingto ARC and Ethernet output number.

Note 1: Be sure to connect devices with a suitable HDMI cable

designed to support the Ethernet Channel functionality, either the

standard HDMI cable with Ethernet or High Speed HDMI cable with

Ethernet.

Note 2: When the HDMI output has both Audio and ARC at the

same time the ARC will be the prioritized.

HDMI INPUT 1~4

Connect to HDMI or DVI sources equipment such as DVD player or

VHWWRSER[IRULQSXWYLGHRDQGDXGLRVHQGLQJ

Note A: This system was tested with 24 AWG cables. If using cables

RIDQRWKHUVSHFLÀFDWLRQWKHSHUIRUPDQFHRIWKLVV\VWHPPD\YDU\

Note B:&DEOHGLVWDQFHWHVWHGZLWKD6RQ\36DQGļ6DPVXQJ

UA40B700 12-bit LED TV.

Note C: Figures provided in this manual are for reference only,

DFWXDOÀJXUHVPD\YDU\GHSHQGLQJRQWKHVRXUFHHTXLSPHQW

and display being used along with the type of cables and their

VSHFLÀFDWLRQV

Power

Plug the DC 5 V power supply into the unit and connect the

adaptor to an AC wall outlet.

6.3 Remote Control

1Power button

Press to switch On the device, press it again to

set the device in standby mode.

2INPUT 1~4

Press the desire input button to select the input

source.

Inhaltsverzeichnis

Andere Cypress Schalten Handbücher

Cypress

Cypress CHDMI-42E Bedienungsanleitung

Cypress

Cypress CLUX-C41 Bedienungsanleitung

Cypress

Cypress CLUX-41AT Bedienungsanleitung

Cypress

Cypress CHDMI-38C Bedienungsanleitung

Cypress

Cypress CH-2170 Bedienungsanleitung

Cypress

Cypress CVSD-41AR Bedienungsanleitung

Cypress

Cypress SE-DVI-8-LC Bedienungsanleitung

Cypress

Cypress CSC-5300 Bedienungsanleitung

Cypress

Cypress CLUX-4S2 Bedienungsanleitung

Cypress

Cypress SE-DVI-4-LC Bedienungsanleitung

Cypress

Cypress SIO-7300 Bedienungsanleitung

Cypress

Cypress CLUX-41SY Bedienungsanleitung

Cypress

Cypress DVT-17 Bedienungsanleitung

Cypress

Cypress CHDD-41AR Bedienungsanleitung

Cypress

Cypress CHDMI-41AT Bedienungsanleitung

Cypress

Cypress CLUX-81 Bedienungsanleitung

Cypress

Cypress CLUX-22HC Bedienungsanleitung

Cypress

Cypress CHDMI-81 Bedienungsanleitung

Cypress

Cypress CHDMI-81 Bedienungsanleitung

Cypress

Cypress CLUX-61 Bedienungsanleitung

Cypress

Cypress CDVI-41 Bedienungsanleitung

Cypress

Cypress CLUX-41AT Bedienungsanleitung

Cypress

Cypress CHMX-42 Bedienungsanleitung

Cypress

Cypress CHMX-24 Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung