D-Link DWL-G650 - AirPlus Wireless 802.11b 11Mbps/802.11g 54Mbps PC... Bedienungsanleitung

Xtreme G 2.4GHz Wireless

Cardbus Adapter

DWL-G650

specifications subject to change without notice. DWL-G650 01102003

If any of the above items are missing, please contact your reseller.

CD-ROM (containing Drivers, Manual and Warranty)

This product works with the following operating

system software: Windows XP, Windows

2000, Windows Me, Windows 98se

Before You Begin

DWL-G650 Xtreme G 2.4GHz Wireless Cardbus Adapter

Check Your Package Contents

These are the items included with your DWL-G650 purchase:

Turn on the computer and

Insert the D- Link AirExtreme DWL-G650

Driver CD in the CD-ROM drive.

The step-by-step instructions that follow are shown

in Windows XP. The steps and screens are similar

for the other Windows operating systems

Insert the D-Link CD-ROM Into Your

Computer Do NOT install

the DWL-G650

Cardbus Adapter into

your computer before

installing the driver

software on the D-Link

CD!

You must have at least the following:

•A laptop computer with an available 32-bit Cardbus slot

•At least a 300 MHz processor and 32 MB of memory

•Cardbus Controller properly installed and working in the laptop computer

•An 802.11b Access Point (for Infrastructure Mode) or another 802.11b wireless

adapter (for Ad-Hoc; Peer-to-Peer networking mode.)

The Install Screen will appear.

If the CD Autorun function

does not automatically start

on your computer , type

“D:\Setup.exe.” If it does

start, proceed to the next

screen.

The letter “D”

represents the

letter of the CD-ROM

drive. Your CD-ROM

drive may be a different

drive letter.

Type “D:\Setup.exe.”

Click OK

Click Next

Continued...

Click Next

Click Install Driver/PC Utility

Shut down your computer

Click Next

Click Finish

Installing the DWL-G650 Wireless

Cardbus Adapter in Your Computer

Link/Activity LED

Indicates that the DWL-G650 is

properly installed when the

computer is on and blinks when

data is being transmitted

Antenna

Used to wirelessly

connect to 802.11b

networks.

A. Make sure to turn off the laptop computer.

B. Locate the Cardbus slot on your laptop computer.

32-bit connector

This is the connector that fits

into the Cardbus slot of your

laptop.

C. Gently insert the DWL-G650 into the Cardbus slot in your laptop

computer (as shown.)

Restart Your Computer

When you restart your computer

this Found New Hardware

Wizard (Windows XP) screen

will appear:

Click Next

For Windows XP: This Hardware

Installation alert screen may appear

after the desktop computer restarts.

Select Install the software

automatically (Recommended)

Click Continue Anyway

to finalize the installation

Click Finish to finalize

the installation.

For Windows 2000, this

Digital Signature Not

Found screen may appear

after your computer restarts.

The D-Link driver software for this device is

undergoing Windows Logo testing. Microsoft

certification is pending.

Click Yes to finalize the

installation.

Your Installation is Complete!

Continued...

After you’ve continued in Windows XP, 2000, ME, or 98SE, the D-Link AirExteme

DWL-G650 Configuration Utility will automatically start and the utility icon will

appear in the bottom right hand corner of the desktop screen (systray). If this

icon appears GREEN, then you have successfully installed the DWL-G650,

are connected to a wireless network and are ready to communicate!

Double-click the utility icon to

use the configuration utility.

If the utility icon does not appear,

double-click the shortcut icon that

has appeared on your desktop.

Appendix

Using the Configuration Utility

A. Status: Displays the

MAC Address of the

Access Point that is

associated with the

DWL-G650.

B. SSID:The Service Set

Identifier is the name

assigned to the wireless

network. The factory

SSID setting is set to

default.

C. TxRate: The default setting is

Auto; meaning, TxRate settings

are automatically determined by

the DWL-G650 depending on the

distance from the access point.

E. Link Quality / Signal Strength:

Displays the Link Quality for the DWL-

G650 wireless connection to the access

point. The Signal Strength represents

the wireless signal between the access

point and the DWL-G650. The percent-

age coincides with the graphical bar.

D. Channel: Displays the

channel information. By

default, the channel is

set to 6 and selection is

automatically determined

by the DWL-G650.

F. Data Rate:

Graphically displays

the statistics of data

transmitted and

received.

G. SSID: The Service Set

Identifier is the name as-

signed to the wireless

network. The factory SSID

setting is set to default. Make

changes here to match the

SSID on existing Wireless

Router or Access Point.

H. Wireless Mode:

The factory setting is

set to Infrastructure.

Ad-Hoc mode is used

for peer-to-peer

networking.

I. Channel: By default, the

channel is set to 6. Channel

selection is automatically

determined by the DWL-G650

depending on the channel

setting of the access point

selected for association. To

change the channel settings,

the Wireless Mode must be

set to Ad-hoc.

J. TxRate: You can

adjust the transmis-

sion rate to get the

best signal possible

depending on your

usage and your

environment.

K. Preamble: By default,

D-Link Air Products are set to

Auto Preamble. The Preamble

defines the length of the CRC

block (Cyclic Redundancy

Check is a common technique

for detecting data transmis-

sion errors) for communica-

tion between the Access Point

and wireless network adapt-

ers. High network traffic areas

should use the shorter

preamble type.

Appendix

L. Power Mode: By default,

Power Mode is set to

Continuous Access Mode.

Continuous Access Mode

— this default setting

consumes the most power.

Maximum Power Save —

this setting consumes the

least power. Power Save

— this setting consumes a

moderate amount of power.

The preamble setting of the DWL-G650 must match the preamble setting of the Wireless

Router or Access Point in order to communicate on the network.

IP Address Configuration

To connect to a network, make sure

the proper network settings are

configured for DWL-G650.

For Microsoft Windows XP:

Go to Start > right click on

My Network Places >

select Properties > Double-click on

the Network Connection associated

with the DWL-G650.

Input a static IP address in the same

range as the Wireless Router or

Access Point.

Static IP address setup

Click OK

IP address: 192.168.0.52

Subnet mask: 255.255.255.0

Click OK

Click Internet Protocol (TCP/IP)

Click Properties

Select Obtain an IP address

automatically (if the Wireless

Router or Access Point has DHCP

server enabled)

Select Obtain DNS server

address automatically

Dynamic IP address setup

Used when a DHCP server is available on

the local network. (i.e. Router)

Used when a DHCP server is not available

on the local network.

Select Use the following IP address

For Windows 2000 users:

Go to Start > Settings > Network and

Dial-up Connections > Double-click on

the Local Area Connection associated

with the DWL-G650 > select Properties

Used when a DHCP server is available on

the local network. (i.e. Router)

Static IP address setup

Input a static IP address in the same

range as the Wireless Router or

Access Point.

Click Properties

Click OK

IP address: 192.168.0.52

Subnet mask: 255.255.255.0

Click OK

Click Internet Protocol (TCP/IP)

Select Obtain an IP address

automatically (if the Wireless Router

or Access Point has DHCP server

enabled)

Select Obtain DNS server

address automatically

Select Use the following IP

address

Dynamic IP address setup

Used when a DHCP server is not available

on the local network.

Andere Handbücher für DWL-G650 - AirPlus Wireless 802.11b 11Mbps/802.11g 54Mbps PC...

Inhaltsverzeichnis

Andere D-Link Adapter Handbücher

D-Link

D-Link DWM-156 Bedienungsanleitung

D-Link

D-Link DUB-E130 Bedienungsanleitung

D-Link

D-Link DHP-P500AV Bedienungsanleitung

D-Link

D-Link DUB-V210 Bedienungsanleitung

D-Link

D-Link DHP-P500AV Bedienungsanleitung

D-Link

D-Link DWA-182 Bedienungsanleitung

D-Link

D-Link DW-125 Bedienungsanleitung

D-Link

D-Link DFE-530TX+ Bedienungsanleitung

D-Link

D-Link DWA-131 Bedienungsanleitung

D-Link

D-Link PCMCIA WIRELESS ASAPTER DWL-650 Bedienungsanleitung

D-Link

D-Link DHP-P500AV Bedienungsanleitung

D-Link

D-Link Air DWL-610 Bedienungsanleitung

D-Link

D-Link DGE-560T - Gigabit PCI-Express SNMP VLAN Flow Control Network... Stücklistenhandbuch

D-Link

D-Link WUA-1340 Bedienungsanleitung

D-Link

D-Link DFE-538TX Montageanleitung

D-Link

D-Link DGE-660TD Bedienungsanleitung

D-Link

D-Link DWA-111 Bedienungsanleitung

D-Link

D-Link DFE-570TX Bedienungsanleitung

D-Link

D-Link DGE-510T Bedienungsanleitung

D-Link

D-Link DWA-620 Bedienungsanleitung

D-Link

D-Link DWA-552 Bedienungsanleitung

D-Link

D-Link Xreme N DWA-160 Bedienungsanleitung

D-Link

D-Link DGE-550T Bedienungsanleitung

D-Link

D-Link DUB-1312 Bedienungsanleitung

Beliebte Adapter Handbücher anderer Marken

PCB Piezotronics

PCB Piezotronics 090B274 Bedienungsanleitung

Auvidea

Auvidea J20 Produkthandbuch

Gossen MetraWatt

Gossen MetraWatt AT3-III E Bedienungsanleitung

Akribis

Akribis ITF-21-BISS-MIT Bedienungsanleitung

Tenda

Tenda W54U Bedienungsanleitung

ROHO

ROHO AGILITY Bedienungsanleitung

PROLiNK

PROLiNK WN2001 Bedienungsanleitung

Hawking

Hawking HUF2 Bedienungsanleitung

Airlink101

Airlink101 AWLC4030 Bedienungsanleitung

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Bedienungsanleitung

Philips

Philips SWA4554S/10 Bedienungsanleitung

JVC

JVC TS-C9D2B Gebrauchsanweisung

NETGEAR

NETGEAR A6100 Bedienungsanleitung

Philips

Philips SWA2037 Bedienungsanleitung

Basalte

Basalte 0610-20 Bedienungsanleitung

Yealink

Yealink EHS40 Bedienungsanleitung

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Bedienungsanleitung

RCA

RCA AH57R Bedienungsanleitung