Danfoss ST-S2 Bedienungsanleitung

Installation Guide

Safety thermostats ST-S2

Danfoss Heating VI.IA.N1.02 DH-SMT/SI

ENGLISH Safety thermostats ST-S2 www.danfoss.com Page 3

①

❶❷

❸➍

ST-S2

①

+−

❺❻

①

②

①

329

49 7

101~18

G⁄" B ISO 228/1

PG 11

Ø8 Cu

100

ST-S2

Installation Guide Safety thermostats ST-S2

DH-SMT/SI VI.IA.N1.02 Danfoss Heating

Installation Guide Safety thermostats ST-S2

Danfoss Heating VI.IA.N1.02 DH-SMT/SI

ENGLISH

Safety Note

To avoid injury and damage to persons

and devices, it is absolutely necessary

these instructions are carefully read

and observed prior to assembly and

commissioning.

Necessary assembly, start-up, and

maintenance work must be performed

only by qualied, trained and authorised

personnel.

Prior to assembly and maintenance work

on the controller, the system must be:

- depressurized

- cooled down

- emptied

- cleaned

Please comply with the instructions of the

system manufacturer or system operator.

This installation procedure describes as

follow must be performed exclusively

by qualied personnel in respect to the

security norms and dispositions of the

current standards.

Disposal instruction

This product should be

dismantled and its

components sorted, if

possible, in various groups

before recycling or disposal.

Always follow the local disposal

regulations.

Installation

Disconnect the mains before performing

any operation!

Verify the thermostat technical data

(power supply, contact rating, etc...) are

suitable to the installation conditions.

❶ Unscrew the three xing screws and the

cap ①, then remove the cover.

❷ Wire the thermostat according to

wiring diagram.

Terminals:

1 Opens the circuit when temperature

increases

2 Closes the circuit when temperature

increases

C Common

Ground

❸ Adjust the temperature set-point

thermostat by rotating the cam ①

❶ Put the cover back in place adjusting

the knob so that it slides on the control

thermostat adjustment pin. Then tighten

the cap ① and the three screws.

➍ Place of installation of immersion

pocket must be chosen in a way that the

temperature of the medium is directly

taken without any delay.

❺ Immerse the temperature sensor into

the immersion pocket in its full length.

When using immersion pockets longer

then 100 mm rst carefully pull enough

capillary tube out of the housing. Capillary

tube may not be twisted or buckled! After

inserting temperature sensors lock the

housing tightening the screw①

❻ In order to reset the thermostat,

unscrew the cap ① and push the reset

button ②.

Note:

Reset allowed for temperature values from 15

to 25 °C below Tsetpoint

Installation Guide Safety thermostats ST-S2

VI.IA.N1.02 Produced by Danfoss A/S © 07/2010

Andere Danfoss Thermostat Handbücher

Danfoss

Danfoss FH-CWP Bedienungsanleitung

Danfoss

Danfoss TP5000 si range Bedienungsanleitung

Danfoss

Danfoss CFZ Bedienungsanleitung

Danfoss

Danfoss CF-RP 088U0211 Bedienungsanleitung

Danfoss

Danfoss FMT230D Betriebsanleitung

Danfoss

Danfoss REPI Series Bedienungsanleitung

Danfoss

Danfoss RET 230 HCW-1 Bedienungsanleitung

Danfoss

Danfoss TP9 Bedienungsanleitung

Danfoss

Danfoss Icon Master Bedienungsanleitung

Danfoss

Danfoss TPONE-RF Bedienungsanleitung

Danfoss

Danfoss TP5000 RF Si Bedienungsanleitung

Danfoss

Danfoss Eco Bedienungsanleitung

Danfoss

Danfoss SET 3E Bedienungsanleitung

Danfoss

Danfoss REP24 Bedienungsanleitung

Danfoss

Danfoss DEVIreg Multi Bedienungsanleitung

Danfoss

Danfoss ECtemp Smart Bedienungsanleitung

Danfoss

Danfoss TRONE-RF Bedienungsanleitung

Danfoss

Danfoss LX205T Bedienungsanleitung

Danfoss

Danfoss HCT-3 Bedienungsanleitung

Danfoss

Danfoss SET3M Montageanleitung

Danfoss

Danfoss CF-RS Bedienungsanleitung

Danfoss

Danfoss ECL Comfort 310 Bedienungsanleitung

Danfoss

Danfoss BasicPlus2 WT-DM Bedienungsanleitung

Danfoss

Danfoss TP7001 series Bedienungsanleitung

Beliebte Thermostat Handbücher anderer Marken

EWELLY

EWELLY EW-181 Bedienungsanleitung

Prolon

Prolon T1100 Montageanleitung

Computherm

Computherm Q20 Bedienungsanleitung

Heatmiser

Heatmiser neoStat Bedienungsanleitung

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Bedienungsanleitung

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung

Saswell

Saswell SAS920XWHB-7-S-RF Leitfaden

Aircalo

Aircalo TFP1-ET85P2 Bedienungsanleitung

Honeywell

Honeywell CM721 Bedienungsanleitung

Carrier

Carrier DEBONAIR 33CS Bedienungsanleitung

Lennox

Lennox iHarmony Zone Thermostat Montageanleitung

Gemtech

Gemtech GT7000 Bedienungsanleitung

Rollei

Rollei Smartes 45000 Bedienungsanleitung

Sinope

Sinope TH1300RF Bedienungsanleitung

Honeywell

Honeywell RLV4305 Bedienungsanleitung

Honeywell

Honeywell Prestige 2.0 THX9421 Bedienungsanleitung

NuTone

NuTone NTBZ48 Original Betriebsanleitung

Stelpro

Stelpro MAESTRO ASMT402AD Bedienungsanleitung