2 3
1,5V x 3
AA (LR6)
BATTERY INSTALLATION AND POWER ASSEMBLY
Protect the environment by not
disposing of this product or any
batteries with household waste.
This symbol indicates that this
product shall not be treated as
household waste. Check your
local authority for recycling
advice and facilities.
•Turn the Power Pad to lower the toy
into flight mode. Locate the battery
compartment door on the back of
the toy.
•Loosen the screw in the battery
compartment door with a Phillips
screwdriver and remove the door.
•Remove the exhausted batteries and
properly dispose.
•Insert three, new AA (LR6)
alkaline batteries.
•Replace the battery compartment
door and tighten the screw. Do not
over-tighten.
•If this toy begins to operate erratically,
you may need to reset the electronics.
Slide the power switch off and then
back on again.
Battery Safety Information
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
•Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable.
•Insert batteries as indicated inside the
battery compartment (+ and -).
•Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
•Use only batteries of the same or
equivalent type, as recommended.
•Do not charge non-rechargeable
batteries.
•Remove rechargeable batteries from
the product before charging.
•If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
For longer life, use alkaline batteries. M3,5 x 15 mm Screw
x4
Tighten or loosen the screws with a Phillips
screwdriver. Do not over-tighten the screws.
1 2
3
the screws.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following
two conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1)
il ne doit pas produire de brouillage et
(2) il doit pouvoir tolérer tout brouillage
radioélectrique reçu, même si ce brouillage
est susceptible de compromettre son
fonctionnement.
Slide the power
switch to ON or
OFF .
