Dell PowerEdge 7150 Bedienungsanleitung

www.dell.com

support.dell.com

Dell™ Systems

RACK INSTALLATION GUIDE

Notes, Notices, Cautions, and

Warnings

NOTE: A NOTE indicates important information that helps you make better

use of your computer.

NOTICE: A NOTICE indicates either potential damage to hardware or loss of

data and tells you how to avoid the problem.

CAUTION: A CAUTION indicates a potentially hazardous situation

which, if not avoided, may result in minor or moderate injury.

WARNING: A WARNING indicates a potentially hazardous

situation which, if not avoided, may result in severe injury.

____________________

Information in this document is subject to change without notice.

Reproduction in any manner whatsoever without the written permission of

Dell Computer Corporation is strictly forbidden.

Trademarks used in this text:

Dell

, the

DELL

logo, and

PowerEdge

are trademarks of

Dell Computer Corporation.

Other trademarks and trade names may be used in this document to refer to either the entities

claiming the marks and names or their products. Dell Computer Corporation disclaims any

proprietary interest in trademarks and trade names other than its own.

April 2001 P/N 54UMJ Rev. A00

Safety Instructions

Safety Caution and Warnings

Use the following safety guidelines to ensure your own personal safety and to help protect

your server, storage system, or appliance from potential damage. For complete safety,

regulatory, and warranty information, refer to your system’s System Information document.

Precautions for Rack-Mountable Products

Observe the following precautions for rack stability and safety. Also refer to the rack

installation documentation accompanying the system and the rack for specific warning

and/or caution statements and procedures.

Servers, storage systems, and appliances are considered to be components in a rack. Thus,

“component” refers to any server, storage system, or appliance, as well as to various

peripherals or supporting hardware.

WARNING: Installing Dell system components in a Dell rack without the front

and side stabilizers installed could cause the rack to tip over, potentially

resulting in bodily injury under certain circumstances. Therefore, always install

the stabilizers before installing components in the rack.

WARNING: After installing system/components in a rack, never pull more than

one component out of the rack on its slide assemblies at one time. The weight of

more than one extended component could cause the rack to tip over and injure

someone.

NOTE: Dell’s servers, storage systems, and appliances are certified as components for use in

Dell’s rack cabinet using the Dell customer rack kit. The final installation of Dell systems and

rack kits in any other brand of rack cabinet has not been approved by any safety agencies. It is

the customer’s responsibility to have the final combination of Dell systems and rack kits for use

in other brands of rack cabinets evaluated for suitability by a certified safety agency.

• System rack kits are intended to be installed in a Dell rack by trained service

technicians. If you install the kit in any other rack, be sure that the rack meets the

specifications of a Dell rack.

• Do not move large racks by yourself. Due to the height and weight of the rack, Dell

recommends a minimum of two people to accomplish this task.

• Before working on the rack, make sure that the stabilizers are secured to the rack,

extend to the floor, and that the full weight of the rack rests on the floor. Install front

and side stabilizers on a single rack or front stabilizers for joined multiple racks before

working on the rack.

www.dell.com | support.dell.com

• Always load the rack from the bottom up, and load the heaviest item in the rack first.

• Make sure that the rack is level and stable before extending a component from

the rack.

• Use caution when pressing the component rail release latches and sliding a component

into or out of a rack; the slide rails can pinch your fingers.

• After a component is inserted into the rack, carefully extend the rail into a locking

position, and then slide the component into the rack.

• Do not overload the AC supply branch circuit that provides power to the rack. The

total rack load should not exceed 80 percent of the branch circuit rating.

• Ensure that proper airflow is provided to components in the rack.

• Do not step on or stand on any system/component when servicing other

systems/components in a rack.

Contents 5

Contents

Rack Installation Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Rack Kit Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Rack Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2

Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Important Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Kit Installation Restrictions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Rack Stabilizer Feet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Recommended Tools and Supplies . . . . . . . . . . . . . . . . . . . . . . . 1-4

Installation Tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-4

Removing the Doors From the Rack . . . . . . . . . . . . . . . . . . . . . . 1-5

Marking the Rack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5

Installing the Slide Assemblies in the Rack . . . . . . . . . . . . . . . . . 1-7

Installing a System in the Rack . . . . . . . . . . . . . . . . . . . . . . . . . 1-9

Installing the System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-9

Installing the Cable Tray . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-11

Installing the Cable-Management Arm . . . . . . . . . . . . . . . . . . . 1-13

Replacing the Rack Doors . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-13

Index

Figures

Figure 1-1. Rack Kit Contents . . . . . . . . . . . . . . . . . . . . . . . . 1-2

Figure 1-2. One Rack Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-6

Figure 1-3. Marking the Rack . . . . . . . . . . . . . . . . . . . . . . . . 1-7

Figure 1-4. Installing the Slide Assemblies . . . . . . . . . . . . . . . 1-8

Figure 1-5. Installing the System in the Rack . . . . . . . . . . . . 1-10

Figure 1-6. Installing the Cable Tray and

Cable-Management Arm . . . . . . . . . . . . . . . . . . 1-12

6Contents

FILE LOCATION:

FILE LOCATION:FILE LOCATION:

FILE LOCATION: S:\SYSTEMS\Bordeaux\rack_inst\RIG\54UMJ_a00\post\54UMJebk0LOF.fm

DELL CONFIDENTIAL – PRELIMINARY 7/24/01

DELL CONFIDENTIAL – PRELIMINARY 7/24/01DELL CONFIDENTIAL – PRELIMINARY 7/24/01

DELL CONFIDENTIAL – PRELIMINARY 7/24/01

Figures

Figure 1-1. Rack Kit Contents . . . . . . . . . . . . . . . . . . . . . . . . 1-2

Figure 1-2. One Rack Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-6

Figure 1-3. Marking the Rack . . . . . . . . . . . . . . . . . . . . . . . . 1-7

Figure 1-4. Installing the Slide Assemblies . . . . . . . . . . . . . . . 1-8

Figure 1-5. Installing the System in the Rack . . . . . . . . . . . . 1-10

Figure 1-6. Installing the Cable Tray and Cable-Management Arm

1-12

FILE LOCATION:

FILE LOCATION:FILE LOCATION:

FILE LOCATION: S:\SYSTEMS\Bordeaux\rack_inst\RIG\54UMJ_a00\post\54UMJebk0LOF.fm

DELL CONFIDENTIAL – PRELIMINARY 7/24/01

DELL CONFIDENTIAL – PRELIMINARY 7/24/01DELL CONFIDENTIAL – PRELIMINARY 7/24/01

DELL CONFIDENTIAL – PRELIMINARY 7/24/01

Rack Installation Guide 1-1

Rack Installation Guide

This installation guide provides instructions for trained service technicians to install one or

more Dell™ systems in a Dell four-post rack cabinet. All Dell four-post rack cabinets are

accommodated. One rack kit is required for each system to be installed in the rack cabinet.

Before attempting this installation, you should read this entire document carefully.

Rack Kit Contents

The rack kit includes the following items (see Figure 1-1):

• One pair of slide assemblies with mounting brackets

• One cable-management arm

• Three 6-32 x 0.25-inch pan-head hex-head taptite screws

• Two 6-32 x.0.25 flat-head Phillips screws

•Onecabletray

• One rack template

NOTE: The number of parts may vary for rack kits preinstalled by Dell.

NOTE: If you have purchased a Dell rack cabinet with your system, some of the hardware may

be preinstalled in the rack.

NOTE: The nonmetric screws described in illustrations and procedural steps are identified by

size and the number of threads per inch. For example, a #10 Phillips-head screw with

32 threads per inch is identified as a 10-32 screw.

1-2 Rack Installation Guide

www.dell.com | support.dell.com

Figure 1-1. Rack Kit Contents

Rack Requirements

The rack kit is designed for use in a Dell rack with an extended-depth back door. If you

have a Dell rack cabinet with a white finish, check that the back door does not contain

flush-mounted glass. If it does, you will need to order a new rack door from Dell before

installing your new system in the rack.

NOTICE: This rack kit is intended to be installed in a Dell rack by trained service technicians.

If you install the kit in any other rack, be sure that the rack meets the specifications of American

National Standards Institute (ANSI)/Electronic Industries Association (EIA) standard

ANSI/EIA-310-D-92, International Electrotechnical Commission (IEC) 297, and Deutsche

Industrie Norm (DIN) 41494. One rack kit is required for each system that is installed in a rack.

slide assemblies with

mounting brackets (2)

cable-management arm

cable tray

6-32 x 0.25-inch

hex-head taptite

screws (3)

rack template

6-32 x 0.25-inch

flat-head Phillips

screws (2)

Andere Handbücher für PowerEdge 7150

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Dell Server Handbücher

Dell

Dell PowerEdge R530 Bedienungsanleitung

Dell

Dell DX6004S Bedienungsanleitung

Dell

Dell PowerEdge R620 Bedienungsanleitung

Dell

Dell EMC PowerEdge R450 D K 0 Series Handbuch

Dell

Dell 1955 Bedienungsanleitung

Dell

Dell EMC PowerEdge T640 Handbuch

Dell

Dell PowerEdge FC830 Bedienungsanleitung

Dell

Dell XC Core XC760 Handbuch

Dell

Dell PowerEdge C6145 Bedienungsanleitung

Dell

Dell EMC PowerEdge R6525 Handbuch

Dell

Dell PowerEdge R640XL Bedienungsanleitung

Dell

Dell PowerEdge T110 Bedienungsanleitung

Dell

Dell EMC PowerEdge R7525 Handbuch

Dell

Dell PowerEdge NF0DD Bedienungsanleitung

Dell

Dell PowerEdge 1655MC Bedienungsanleitung

Dell

Dell PowerEdge R430 Bedienungsanleitung

Dell

Dell PowerEdge T630 Bedienungsanleitung

Dell

Dell EMC PowerEdge GPH2C Handbuch

Dell

Dell PowerEdge R730xd Bedienungsanleitung

Dell

Dell PowerEdge T605 Bedienungsanleitung

Dell

Dell PowerEdge R660xs Handbuch

Dell

Dell Active Fabric Manager Kurzanleitung

Dell

Dell POWEREDGE 4300 Bedienungsanleitung

Dell

Dell Wyse 5020 Bedienungsanleitung

Beliebte Server Handbücher anderer Marken

HP AlphaServer ES47 Bedienungsanleitung

PowerNAS

PowerNAS CMA Bedienungsanleitung

Supero

Supero FatTwin F617R3-FT Bedienungsanleitung

EtroVISION

EtroVISION EV3151 Bedienungsanleitung

HP ProLiant Gen9 Bedienungsanleitung

Compaq

Compaq ProLiant 3000 Handbuch

iRobo

iRobo IPC2U Bedienungsanleitung

Nortel

Nortel 1000 Con?guration guide Bedienungsanleitung

Asus

Asus AP7500 Bedienungs- und Wartungshandbuch

Avid Technology

Avid Technology AirSpeed 5000 Bedienungsanleitung

HP Integrity rx2600 Installationsanleitung

Milestone

Milestone Husky IVO 350T Bedienungsanleitung

Planet

Planet NAS-7410 Bedienungsanleitung

Lenovo

Lenovo ThinkSystem SR635 V3 Bedienungsanleitung

Fujitsu

Fujitsu PRIMERGY BX900 Bedienungsanleitung

Asus

Asus RS700DA-E6 PS4 Bedienungsanleitung

Vertiv

Vertiv Avocent ACS6000 Montage- und Wartungsanleitung

A & T Internationale

A & T Internationale Xserve Service-Handbuch