Dell S5000 Series Bedienungsanleitung

Dell S5000 Series Servers for SAP HANA

Customer Service Guide

Regulatory Model: M3S2G8, M3UX16

September 2022

Rev. A01

or its subsidiaries. Other trademarks may be trademarks of their respective owners.

WARNING: Please read carefully the safety instructions in the

Multilingual Safety Notices Guide

before you

perform the procedures described in this document.

Intended audience

This document is intended for use by administrators and operators.

Related documents

For the most recent product information, documentation, firmware updates, software fixes, and service offers, see the Dell

Technologies Support Site.

Preface

Preface 3

Contents i

Table of Contents

Chapter 1. Servicing Compute Unit Components 1-1...............................

1.1. Servicing a FDB Disk 1-1...................................................

1.1.1. Removing a Disk 1-2..............................................

1.1.2. Installing a Disk 1-5...............................................

1.2. Servicing a Front Disk Blade (FDB) 1-7.....................................

1.2.1. Removing a FDB 1-8..............................................

1.2.2. Installing a FDB 1-11...............................................

1.3. Servicing a Memory Module 1-14............................................

1.3.1. Removing a Memory Module 1-15...................................

1.3.2. Installing a Memory Module 1-24...................................

1.4. Servicing a USB Raid SD Card (URS) 1-33...................................

1.4.1. Removing a USB Raid SD Card (URS) 1-34..........................

1.4.2. Installing a USB Raid SD Card (URS) 1-44...........................

Chapter 2. Servicing Optional Unit Components 2-1...............................

2.1. Removing a SAS fan assembly 2-2.........................................

2.2. Installing a SAS fan assembly 2-5..........................................

Chapter 3. Servicing Rear Components 3-1.........................................

3.1. Servicing a Power Supply Unit (PSU) 3-1...................................

3.1.1. Removing a PSU 3-2..............................................

3.1.2. Installing a PSU 3-3...............................................

3.2. Servicing a Phy Ethernet Board (PEB) 3-5..................................

3.2.1. Removing a PEB 3-5...............................................

3.2.2. Installing a PEB 3-7...............................................

3.3. Servicing a Phy Ethernet Board SFP+ (PEBS) 3-9...........................

3.3.1. Removing a PEBS 3-10.............................................

3.3.2. Installing a PEBS 3-12..............................................

3.4. Servicing a PCIe Blade 3-14.................................................

3.4.1. Removing a PCIe Blade 3-15........................................

3.4.2. Installing a PCIe Blade 3-17........................................

3.5. Servicing a sWitch Ethernet One Gigabit (WEO) 3-19........................

3.5.1. Removing a sWitch Ethernet One Gigabit (WEO) 3-19...............

3.5.2. Installing a sWitch Ethernet One Gigabit (WEO) 3-21................

Chapter 4. Servicing UBox Components 4-1........................................

4.1. Servicing a UBox Power Supply Unit (PSU) 4-1.............................

4.1.1. Removing a UBox PSU 4-2.........................................

4.1.2. Installing a UBox PSU 4-3.........................................

4.2. Servicing a UBox UNB fan module 4-5......................................

4.2.1. Removing a UBox UNB fan module 4-6.............................

4.2.2. Installing a UBox UNB fan module 4-8.............................

ii Customer Service Guide

Chapter 5. Other Maintenance Tasks 5-1...........................................

5.1. Resetting the Baseboard Management Controller (BMC) 5-1................

5.1.1. Restarting the BMC 5-2............................................

5.1.2. Resetting the BMC to Default Factory Settings 5-3..................

5.2. Resetting the Local Management Controller (LMC) 5-4......................

5.2.1. Using the Reset Button 5-5........................................

5.2.2. Using the Server Hardware Console (SHC) 5-5.....................

5.2.3. Using the Command Line 5-6......................................

5.3. Recovering Firmware 5-7..................................................

5.3.1. Recovering the BMC Firmware 5-8.................................

5.3.2. Recovering the BIOS Firmware 5-9................................

5.3.3. Recovering the PEB or PEBS Flash Firmware 5-10....................

5.3.4. Recovering the LMB Firmware 5-11.................................

Chapter 1. Servicing Compute Unit Components 1-1

Chapter 1. Servicing Compute Unit Components

1.1. Servicing a FDB Disk

Important ATTENTION: Please read carefully the safety instructions

before you perform the procedures described in this

manual.

Multilingual Safety Notices Guide

C009 CAUTION

C009:

Cabinet doors must remain locked at all times except during

maintenance operations.

Qualified personnel only are authorized to open the cabinet doors.

C004 CAUTION

C004:

Static electricity can damage the server and other electronic devices. To

avoid damage, keep static-sensitive devices in their static-protective

packages until you are ready to install them.

To reduce the possibility of damage from electrostatic discharge,

observe the following precautions:

Limit your movement. Movement can cause static electricity to build up

around you.

Wear an electrostatic-discharge wrist strap.

Handle the device carefully, holding it by its edges or its frame.

Do not touch solder joints, pins, or exposed circuitry.

Do not leave the device where others can handle and damage it.

While the device is still in its static-protective package, touch it to an

unpainted metal surface on the outside of the server for at least 2

seconds. This drains static electricity from the package and from your

body.

Remove the device from its package and install it directly into the

server without setting down the device. If it is necessary to set down

the device, put it back into its static-protective package. Do not place

the device on the server cover or on a metal surface.

Take additional care when you handle devices during cold weather.

Heating reduces indoor humidity and increases static electricity.

See Description Guide to locate the FDB disk

1-2 Customer Service Guide

1.1.1. Removing a Disk

Required Tools

None

Procedure

1. Unpack the new component on a clean ESD-protected work surface

2. Open the cabinet front door

3. Remove the bezel

1. Press the latches (A) to unlock the bezel

Chapter 1. Servicing Compute Unit Components 1-3

2. Remove the bezel

4. Remove the disk from the Front Disk Blade (FDB)

1. Push the latch to the right to unlock the disk.

1-4 Customer Service Guide

2. Remove the disk by using its latch.

Andere Handbücher für S5000 Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Dell Server Handbücher

Dell

Dell Wyse 3000-Xenith 2 Bedienungsanleitung

Dell

Dell POWEREDGE SC1430 Bedienungsanleitung

Dell

Dell EMC PowerEdge R750 Handbuch

Dell

Dell Force10 MXL Blade Bedienungsanleitung

Dell

Dell PowerEdge HS5620 Handbuch

Dell

Dell PowerEdge R610 Bedienungsanleitung

Dell

Dell PowerEdge C8000 Bedienungsanleitung

Dell

Dell PowerVault MD3600i Series Bedienungsanleitung

Dell

Dell PowerEdge R620 Bedienungsanleitung

Dell

Dell PowerEdge FC630 Bedienungsanleitung

Dell

Dell POWEREDGE R710 Technisches Handbuch

Dell

Dell PowerEdge R420 Bedienungsanleitung

Dell

Dell PowerEdge 600SC Technisches Handbuch

Dell

Dell PowerEdge 2950 Technisches Handbuch

Dell

Dell PowerEdge 800 Technisches Handbuch

Dell

Dell PowerEdge T620 Kurzanleitung

Dell

Dell PowerEdge C6105 Bedienungsanleitung

Dell

Dell PowerEdge System 840 MVT01 Bedienungsanleitung

Dell

Dell Force10 MXL Blade Bedienungsanleitung

Dell

Dell PowerEdge T420 Bedienungsanleitung

Dell

Dell PowerEdge C8000 Bedienungsanleitung

Dell

Dell PowerEdge C6100 Bedienungsanleitung

Dell

Dell EMC VxFlex Appliance R840 Bedienungsanleitung

Dell

Dell PowerEdge 2550 Bedienungsanleitung

Beliebte Server Handbücher anderer Marken

HP AlphaServer ES47 Bedienungsanleitung

PowerNAS

PowerNAS CMA Bedienungsanleitung

Supero

Supero FatTwin F617R3-FT Bedienungsanleitung

EtroVISION

EtroVISION EV3151 Bedienungsanleitung

HP ProLiant Gen9 Bedienungsanleitung

Compaq

Compaq ProLiant 3000 Handbuch

iRobo

iRobo IPC2U Bedienungsanleitung

Nortel

Nortel 1000 Con?guration guide Bedienungsanleitung

Asus

Asus AP7500 Bedienungs- und Wartungshandbuch

Avid Technology

Avid Technology AirSpeed 5000 Bedienungsanleitung

HP Integrity rx2600 Installationsanleitung

Milestone

Milestone Husky IVO 350T Bedienungsanleitung

Planet

Planet NAS-7410 Bedienungsanleitung

Lenovo

Lenovo ThinkSystem SR635 V3 Bedienungsanleitung

Fujitsu

Fujitsu PRIMERGY BX900 Bedienungsanleitung

Asus

Asus RS700DA-E6 PS4 Bedienungsanleitung

Vertiv

Vertiv Avocent ACS6000 Montage- und Wartungsanleitung

A & T Internationale

A & T Internationale Xserve Service-Handbuch