Dell XC6320 Bedienungsanleitung
Dell XC6320 Web-Scale
Hyperconverged Appliance
Getting
Started
With Your
System
Scan to see how-to videos, documentation, and
troubleshooting information.
Notes, Cautions, and Warnings
NOTE: A NOTE indicates important information that helps you make better
use of your computer.
CAUTION: A CAUTION indicates potential damage to hardware or
loss of data if instructions are not followed.
WARNING: A WARNING indicates a potential for property damage,
personal injury, or death.
Copyright © 2016 Dell Inc. All rights reserved. This product is protected by U.S. and international
copyright and intellectual property laws. Dell™ and the Dell logo are trademarks of Dell Inc. in the
United States and/or other jurisdictions. All other marks and names mentioned herein may be
trademarks of their respective companies.
Printed in Malaysia.
Regulatory Model: B08S RegulatoryType: B08S003
2016-03 P/N G40F3 Rev. A01
Getting Started With Your System
|
3
CAUTION: Restricted Access Location
This system is intended for installation only in restricted access locations as defined in
Cl. 1.2.7.3 of IEC 60950-1: 2001 where both these conditions apply:
•
Access can only be gained by service persons or by users who have been
instructed about the reasons for the restrictions applied to the location and about
any precautions that shall be taken.
•
Access is through the use of a tool or lock and key, or other means of security,
and is controlled by the authority responsible for the location.
Installation and Configuration
WARNING: Before performing the following procedure, review and follow
the safety instructions that came with the system.
Installing the Tool-less Rail Solution
WARNING: Whenever you need to lift the system, get others to assist
you. To avoid injury, do not attempt to lift the system by yourself.
WARNING: The system is not fixed to the rack or mounted on the
rails. To avoid personal injury or damage to the system, you must
adequately support the system during installation and removal.
WARNING: To avoid a potential electrical shock hazard, a third wire
safety grounding conductor is necessary for the rack installation.
The rack equipment must provide sufficient airflow to the system to
maintain proper cooling.
CAUTION: When installing rails in a square-hole rack it is important
to ensure that the square peg slides through the square holes.
4
|
Getting Started With Your System
1Push the latch release buttons on the midpoints of the end piece to open the
rail latches (see Figure 1).
2Align the end pieces of the rails on the vertical rack flanges to seat the pegs
in the bottom hole of the first U and the top hole of the second U.
NOTE: The rails can be used in both square-hole and round-hole
racks (see Figure 1).
Figure 1. Pushing the Latch Release Buttons
NOTE: To remove the rails, push the latch release button on the
midpoints of the end piece and unseat each rail.
3Engage the end of the rails and release the latch release button to have the
latches locked in place.
4On each vertical rack flange on the back, put two screw bases into the two
square holes right above the rail (see Figure 2).
5Install the chassis stabilizer shipping brackets (optional) on the back rack
flanges.
6Install and tighten the screws.
NOTE: To transport systems already installed in the rack, ensure
that the two chassis stabilizer shipping brackets (optional) are in
place.
Getting Started With Your System
|
5
Figure 2. Installing the Chassis Stabilizer Shipping Brackets
7Slide the system into the rack (see Figure 3).
8Tighten the thumbscrews to secure the ears of the system to the front of the
rack flanges.
Figure 3. Installing the Chassis into the Rack
6
|
Getting Started With Your System
Connectingthe Keyboard, Mouse, and Monitor (Optional)
Figure 4. Optional—Connecting the Keyboard, Mouse and Monitor
Connect the keyboard, mouse, and monitor (optional).
The connectors on the back of your system have icons indicating which cable to plug
into each connector. Ensure that you tighten the screws (if any) on the monitor’s cable
connector.
NOTE: The system supports only one USB port and a micro USB port. If
you require more than one USB outlet at a time, use USB hub or an
adapter cable.
Getting Started With Your System
|
7
Connecting the Power Cable(s)
Figure 5. Connecting the Power cable
Figure 6. Routing the cables
Connect the system’s power cable(s) to the system and, if a monitor is used, connect the
monitor’s power cable to the monitor. Plug the other end of the power cable(s) into a
grounded electrical outlet or a separate power source such as an uninterrupted power
supply (UPS) or a power distribution unit.
NOTE: The system supports both AC and HVDC power inputs. Your
system can support up to two 1600 W power supply units (PSUs)
(200−240 VAC nominal input voltage).
8
|
Getting Started With Your System
Turning on the System
Figure 7. Pressing the Power Button in Front of the System
Press the power button(s) either in front or back of the system. The power indicators
glow in green color.
Installing Operating System
To install an operating system for the first time, see the installation and
configuration documentation for your operating system. Ensure that the
operating system is installed before installing hardware or software not
purchased with the system. For more information about the Dell XC6320
system, refer to the Dell XC6320 Owner’s Manual available at
Dell.com/xcseriesmanuals.
NOTE: For more information about supported operating systems, see
Dell.com/ossupport.
Andere Handbücher für XC6320
3
Inhaltsverzeichnis
Sprachen:
Andere Dell Server Handbücher
Dell
Dell PowerEdge SC1425 Leitfaden
Dell
Dell PowerEdge R210 II Kurzanleitung
Dell
Dell DL4300 Bedienungsanleitung
Dell
Dell POWEREDGE CLUSTER SE100 Montageanleitung
Dell
Dell poweredge t330 Bedienungsanleitung
Dell
Dell OptiPlex 9020 Bedienungsanleitung
Dell
Dell ECS EX Series Montageanleitung
Dell
Dell PowerEdge R620 Bedienungsanleitung
Dell
Dell PowerEdge Bedienungsanleitung
Dell
Dell PowerEdge 2970 Technisches Handbuch
Dell
Dell EMC Connectrix EC-1700 Series Benutzerhandbuch
Dell
Dell DR4000 Restore Manager Bedienungsanleitung
Dell
Dell PowerEdge R830 Bedienungsanleitung
Dell
Dell POWEREDGE R710 Bedienungsanleitung
Dell
Dell XC6320 Bedienungsanleitung
Dell
Dell Force10 S25-01-GE-24P Bedienungsanleitung
Dell
Dell PER4402A Handbuch
Dell
Dell PowerEdge 2600 Bedienungsanleitung
Dell
Dell PowerEdge 4600 Bedienungsanleitung
Dell
Dell EMC PowerEdge XE7440 Handbuch
