Rev
B:
December 2006
DEMl)Cii
3. Installation Instructions
This section contains instructions for the unpacking, placement and installation
of
the Pro-
Tester™. Carefully review the following information, sub-sections and each procedure before
beginning unpacking and installation
of
the system.
The Pro-Tester™ comes complete in a reusable portable shipping/transport container. The
system can be operated from within the container our removed and placed onto a work bench or
appropriate platform for use. When not in use the Pro-Tester™ should always be stored in the
shipping/transport container
to
protect
if
from the elements and potential damage.
Note: The system illustrated in this manual shows ALL available features for the Pro-
Tester™, therefore, your system may vary slightly in appearance from that depicted.
3.1. Unpacking andPreparation
1.
Before opening the shipping/transport container and unpacking the system, inspect the
outside
of
the container thoroughly for any signs
of
mishandling or damage during
shipping. Report any damage
to
the shipping carrier immediately and do not proceed
with unpacking. Since the shipment is made FOB factory, you should consult your
administration concerning claims for shipping damage. Please notify DEMTECH
Services, Inc. immediately in writing
of
any shipping damage.
2.
Unlatch and open the shipping/transport container lid and inspect inside the container and
equipment thoroughly for any signs
of
mishandling or damage during shipping. Report
any damage
to
the shipping carrier immediately and do not proceed with unpacking.
Since the shipment is made FOB factory, you should consult your administration
concerning claims for shipping damage. Please notify DEMTECH Services, Inc.
immediately in writing
of
any shipping damage.
3.
Make note
of
the orientation
of
the equipment and packing foam inserts inside the
shipping container
to
facilitate any repackaging requirements in the future.
Page 3 Pro-Tester™ Operator's Manual T-Manual
RB
