Desa W23FT Gebrauchsanweisung

ASSEMBLING MANTEL

WARNING: Use only 1/2" screws to attach metal

angle brackets. Damage to mantel will result if other

screws are used for this purpose.

IMPORTANT: More than one person is required to lift

assembled mantel. Lift mantel by leg assemblies. Lifting

by header or mantel top could damage mantel.

When assembling mantel do not tighten screws completely

until told to do so. There should be some play in the pieces

to allow for proper alignment and best possible t. It is very

important that more than one person assemble mantel. Panels

must be held in proper alignment to each other while tighten-

ing screws to assure fewer gaps and proper surface align-

ment. When tightening screws, do not over tighten. This may

cause threads to strip. The supplied Allen wrench should be

used rather than a power screwdriver. Panels have threaded

inserts installed at screw locations. Screws should start and

turn easily in threaded holes when assembled according to

instructions. Do not force screws into holes.

IMPORTANT: A serial number label is located inside of right

side panel and on outside package. When calling to request

technical assistance or for replacement parts please have

serial number ready.

W23FT MANTEL AND BASE

ASSEMBLY AND INSTALLATION INSTRUCTIONS

IMPORTANT: Read entire instruction sheet before

assembling or installing mantel kit.

This mantel is only approved for use with DESA



Do not use mantel with any other product.

     



This mantel kit contains the following:

• Mantel pieces - unassembled and marked as follows:

#1 Base

#2 Right Side with arrow

#3 Right Front Leg with arrow

#4 Left Side with arrow

#5 Left Front Leg with arrow

#6 Header with arrow

#7 Top

• Hardware Kit*

10 - Metal Brackets 118937-01

20 - Screws M6 x 12 mm (1/2") 121149-01

8 - Screws M6 x 30 mm (1 1/4") 121335-01

8 - Washers M6 121336-01

1 - Allen Wrench 121337-01

* Extra hardware may be included.

If any wood pieces are missing or damaged, contact the

dealer where you purchased this mantel for replacement.

If hardware or trim is missing or damaged, contact DESA

Heating Products at 1-866-672-6040 for referral. You can

also visit DESA Heating Products' technical service web site

at www.desatech.com.

Note: Gather all mantel pieces together before assembling.

www.desatech.com

www.desatech.com 121869-01B

Figure 3 - Installing Header

Left Leg

Assembly

Right Leg

Assembly

Header

Shoulder

Figure 2 - Attaching Front Leg

Figure 4 - Attaching Header to Leg Assembly

Header

Leg

Assembly

1 1/4" Screw

Brackets

Right Side

Figure 1 - Attaching Brackets to Side

1. Lay right side panel (#2) face down on a soft surface

to avoid marking nish. Attach three brackets with 1/2"

screws to bottom of right front leg (#3) leaving screws

slightly loose. Face brackets out (see Figure 1). Place

right front leg (#3) over right side (#2) as shown in Figure

2, paying close attention to direction arrow pointing up on

panels. Align threaded holes with brackets on side. Start

three 1/2" screws through brackets. Align bottom of side

and leg assembly so they are ush with each other. Hold

these pieces securely in alignment while tightening (but

not over tightening) screws.

2. Assemble left side (#4) and left leg (#5) as described in

step 1.

3. You may prefer to lay mantel face down on a soft surface

instead of upright to position header. Position header (#6)

between leg assemblies with direction arrow pointing

up (see Figure 3). Attach header with 1 1⁄4" screws and

washers (see Figure 4).

1/2" Screws

Right Side

Right Front Leg

1/2" Screws

Washer

www.desatech.com

121869-01B 3

Top

Leg

Assemblies

11/4" Screw

Figure 5 - Attaching Top to Leg and Header Assembly



1. Place mantel top (#7) onto upright leg assembly (see

Figure 5). Align back of top with back of sides.

2. Using four 1 1⁄4" screws with washers, attach top to

header/leg assembly (see Figure 5).

Washer

Back of Top

Flush with

Back of Leg

Assembly



Attach mantel to base using 4 brackets and 1/2" screws, 2 per

leg assembly, into threaded holes in base and leg assembly

(see Figure 6).



1. Fireplace should be fully assembled. See Assembling

Fireplace in replace owner’s manual.

2. Place mantel base close to installation location. See

replace owner’s manual for installation clearances.

3. Mantel must be installed flush with wall. Remove

baseboard along wall where mantel is to be installed.

Baseboard will prevent proper installation of mantel and

base.

4. If installing gas replace, install gas line. See Connecting

to Gas Supply in replace owner’s manual. Remember

to leave access to the gas shutoff valve somewhere on

the base or where it is accessible to the user. Check

for leaks. See Checking Gas Connections in replace

owner’s manual.

5. Position replace inside mantel through front opening.

Carefully position gas lines if applicable. IMPORTANT:

Use caution when positioning replace on base. Base

may scratch easily. Make sure replace is in proper po-

sition within the mantel opening before continuing with

installation.



This mantel can be used with DESA Heating Products 23"

Electric Fireplace. Electric replaces install from the front of

mantel. To install electric replace see replace instruction

manual. Use caution when positioning replace on base.

Base may scratch easily.

Figure 6 - Attaching Mantel Assembly to Mantel Base

Bracket with 1/2"

Screws

NOT A UPC

121869-01

Rev. B

08/07

121869 01

DESA Heating, LLC

2701 Industrial Drive

P.O. Box 90004

Bowling Green, KY 42102-9004, USA

www.desatech.com

1-866-672-6040

Inhaltsverzeichnis

Andere Desa Kaminzubehör Handbücher

Desa

Desa 102865-01 Bedienungsanleitung

Desa

Desa Wall Mantel with Base and Trim WD26CP Gebrauchsanweisung

Desa

Desa C36TO Gebrauchsanweisung

Desa

Desa Wall Mantel and Base with Trim W32WP Gebrauchsanweisung

Desa

Desa W32GO Gebrauchsanweisung

Desa

Desa VCBK4L Bedienungsanleitung

Desa

Desa PC-BVBN Bedienungsanleitung

Desa

Desa C26TO Gebrauchsanweisung

Desa

Desa GA9150A Bedienungsanleitung

Desa

Desa Wall Mantel and Base W26LC Gebrauchsanweisung

Desa

Desa PCBM-325 Bedienungsanleitung

Desa

Desa Mantel and Base W26TO Gebrauchsanweisung

Desa

Desa PCDM-36VB Bedienungsanleitung

Desa

Desa PC-BDV37N Bedienungsanleitung

Desa

Desa Mantel and Base W26RO Gebrauchsanweisung

Desa

Desa DS37 Bedienungsanleitung

Desa

Desa W23OT Gebrauchsanweisung

Desa

Desa HFL200 SERIES Bedienungsanleitung

Desa

Desa GA6050 Bedienungsanleitung

Desa

Desa GA3555 Bedienungsanleitung

Desa

Desa W32AOSA Gebrauchsanweisung

Desa

Desa W26GO Gebrauchsanweisung

Desa

Desa Mantel and Base W32RO Gebrauchsanweisung

Desa

Desa BK3 Bedienungsanleitung

Beliebte Kaminzubehör Handbücher anderer Marken

Valor

Valor L2 1700K Bedienungsanleitung

Exodraft

Exodraft Xzense Bedienungsanleitung

Whalen

Whalen Ruso MNFP62BF23-6 Bedienungsanleitung

Lopi

Lopi Hearthview 864 Bedienungsanleitung

Woodstock Soapstone

Woodstock Soapstone Fireview 201 Bedienungsanleitung

EdilKamin

EdilKamin SERBATOIO 250 Kurzanleitung

Bronpi

Bronpi KIT-1 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces 22150051 Bedienungsanleitung

Travis Industries

Travis Industries 33 DVI Bedienungsanleitung

Superior

Superior ASD3628-TI Bedienungsanleitung

pleasant hearth

pleasant hearth OFP28WG Bedienungsanleitung

IHP

IHP Astria Series Bedienungsanleitung

Firegear

Firegear FG-H-2110SS Bedienungsanleitung

Nibe

Nibe Contura C i31 Bedienungsanleitung

kozy heat

kozy heat KZK-052 Bedienungsanleitung

SimpliFire

SimpliFire SF-WM36 Bedienungsanleitung

Bluegrass Living

Bluegrass Living BC18NR Kurzanleitung

pleasant hearth

pleasant hearth IRIS SCROLL Bedienungsanleitung