DFI AM33-EC Bedienungsanleitung
AM33-EC
AM33-EL
Rev. A+
System Board Users Manual
Carte Mère Manuel Pour Utilisateur
System-Platine Benut erhandbuch
Manual del Usuario de Placas Base
50500132
Copyright
This publication contains information that is protected by
copyright. No part of it may be reproduced in any form or by
any means or used to make any transformation/adaptation
without the prior written permission from the copyright holders.
This publication is provided for informational purposes only. The
manufacturer makes no representations or warranties with respect to
the contents or use of this manual and specifically disclaims any
express or implied warranties of merchantability or fitness for any
particular purpose. The user will assume the entire risk of the use or
the results of the use of this document. Further, the manufacturer
reserves the right to revise this publication and make changes to its
contents at any time, without obligation to notify any person or
entity of such revisions or changes.
© 001. All Rights Reserved.
Trademarks
Microsoft® MS-DOS®, WindowsTM, Windows® 95, Windows® 98,
Windows® 98 SE, Windows® ME, Windows® 000 and Windows
NT® 4.0 are registered trademarks of Microsoft Corporation.
AMD, AthlonTM and DuronTM are registered trademarks of
Advanced Micro Devices, Inc. VIA is a registered trademark of
VIA Technologies, Inc. Award is a registered trademark of Award
Software, Inc. Other trademarks and registered trademarks of
products appearing in this manual are the properties of their
respective holders.
Caution
To avoid damage to the system:
Use the correct AC input voltage range.
To reduce the risk of electric shock:
Unplug the power cord before removing the system chassis
cover for installation or servicing. After installation or servicing,
cover the system chassis before plugging the power cord.
Battery:
Danger of explosion if battery incorrectly replaced.
Replace only with the same or equivalent type recommend by
the manufacturer.
Dispose of used batteries according to the battery
manufacturers instructions.
Joystick or MIDI port:
Do not use any joystick or MIDI device that requires more than
10A current at 5V DC. There is a risk of fire for devices that
exceed this limit.
FCC and DOC Statement on Class B
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio TV technician for
help.
Notice:
1. The changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
. Shielded interface cables must be used in order to comply with
the emission limits.
4
Quick Setup Guide
Quick Setup
Guide
Table of Contents
Chapter 1
Quick Setup Guide.............................................
Chapter 2
English......................................................................
Chapter 3
rançais ( rench).................................................
Chapter 4
Deutsch (German)................................................
Chapter 5
Español (Spanish)..................................................
5
24
45
66
89
Note:
The users manual in the provided CD contains detailed information
about the system board. If, in some cases, some information doesnt
match those shown in this manual, this manual should always be
regarded as the most updated version.
5
Quick Setup Guide
Quick Setup
Guide
Chapter 1 - Quick Setup Guide
Table of Contents
1.1 System Board Layout..................................................................................................
1. Jumpers.....................................................................................................................................
1.3 Ports and Connectors................................................................................................
1.4 Award BIOS Setup Utility.......................................................................................
6
8
10
19
Important:
To ensure proper boot up and operation of your system, you must
power-off the system then turn off the power supplys switch or
unplug the AC power cord prior to altering the setting of a umper
or replacing the CPU.
6
Quick Setup Guide
Quick Setup
Guide
1.1 System Board Layout
AM33-EC
7
Quick Setup Guide
Quick Setup
Guide
Note:
The illustrations on the following pages are based on the AM33-EL
system board, which is the board that supports onboard LAN.
AM33-EL
(Supports onboard LAN)
8
Quick Setup Guide
Quick Setup
Guide
1.2.1 Clear CMOS Data - JP8
1.2.2 Onboard Audio Codec - JP5, JP6 and JP7
1- On:
Enable the
Onboard Audio
Codec (default)
-3 On: Disable
the Onboard
Audio Codec
1.2 Jumpers
-3 On:
Clear CMOS Data
1- On:
Normal (default)
1
3
1
3
JP5
1 3
JP6
JP7
JP5
1 3
JP6
JP7
9
Quick Setup Guide
Quick Setup
Guide
1.2.4 Power Select for USB 1 and USB 2 - JP2
Power Select for USB 3 and USB 4 - JP9
1.2.3 CPUs ront Side Bus - JP10
1
On: 100MHz
( 00MHz DDR) CPU
(default)
Off: 133MHz
( 66MHz DDR) CPU
1
To ensure proper boot up and operation of your system, you must power-
off the system then turn off the power supplys switch or unplug the AC
power cord prior to altering the setting of the jumper.
-3 On: 5VSB
1- On: 5V
(default)
1 3
1
3
JP
JP9
1 3
1
3
JP
JP9
10
Quick Setup Guide
Quick Setup
Guide
1.3 Ports and Connectors
1.3.1 PS/2 Mouse and PS/2 Keyboard Ports
Make sure to turn off your
computer prior to connecting or
disconnecting a mouse or
keyboard. Failure to do so may
damage the system board.
PS/ Mouse
PS/ Keyboard
1.3.2 RJ45 ast-Ethernet Port (AM33-EL)
RJ45 LAN
Andere Handbücher für AM33-EC
1
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere DFI Hauptplatine Handbücher
DFI
DFI CS62-TC Bedienungsanleitung
DFI
DFI SU256-SCM Bedienungsanleitung
DFI
DFI PB61-V3 Bedienungsanleitung
DFI
DFI NB71-SC Bedienungsanleitung
DFI
DFI AD72-SC Bedienungsanleitung
DFI
DFI WL051-BCC-4305UE Bedienungsanleitung
DFI
DFI AD73 Pro Bedienungsanleitung
DFI
DFI MB630-CRM Bedienungsanleitung
DFI
DFI BL630-DR Bedienungsanleitung
DFI
DFI PE10-SA/RAMA Bedienungsanleitung
DFI
DFI CMS632-W480E Bedienungsanleitung
DFI
DFI NB32-SL Bedienungsanleitung
DFI
DFI CW35 Series Bedienungsanleitung
DFI
DFI CMS330-Q470E Bedienungsanleitung
DFI
DFI G586VPM/T Bedienungsanleitung
DFI
DFI CP100-NRM Bedienungsanleitung
DFI
DFI NB71-BC Bedienungsanleitung
DFI
DFI KD632-C236 Bedienungsanleitung
DFI
DFI LanParty X58-T3eH8 Bedienungsanleitung
DFI
DFI BT253 Bedienungsanleitung
Beliebte Hauptplatine Handbücher anderer Marken
Gigabyte
Gigabyte GA-9IVDT Bedienungsanleitung
Texas Instruments
Texas Instruments ADS8372EVM Bedienungsanleitung
Commell
Commell MS-C73 Bedienungsanleitung
IBT Technologies
IBT Technologies MB860 Bedienungsanleitung
Nvidia
Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung
Biostar
Biostar M7VIT Bravo Bedienungs- und Montageanleitung
