DFI NB71-BC Bedienungsanleitung
NB71-BC
NB70-BC
Rev.A+
System Board User’s Manual
Carte Mère Manuel Pour Utilisateur
System-Platine Benutzerhandbuch
Manual del Usuario de Placas Base
935-NB7102-000
61400231
Copyright
This publication contains information that is protected by copyright.
No part of it may be reproduced in any form or by any means or
used to make any transformation/adaptation without the prior
written permission from the copyright holders.
This publication is provided for informational purposes only. The
manufacturer makes no representations or warranties with respect to
the contents or use of this manual and specifically disclaims any
express or implied warranties of merchantability or fitness for any
particular purpose.The user will assume the entire risk of the use or
the results of the use of this document. Further, the manufacturer
reserves the right to revise this publication and make changes to its
contents at any time, without obligation to notify any person or
entity of such revisions or changes.
© 2002. All Rights Reserved.
Trademarks
Windows®98, Windows®98 SE, Windows®ME, Windows®2000
,Windows®XP and Windows NT®4.0 are registered trademarks of
Microsoft Corporation. Intel®and Pentium®4 are registered
trademarks of Intel Corporation.Award is a registered trademark of
Award Software, Inc. Other trademarks and registered trademarks
of products appearing in this manual are the properties of their
respective holders.
Caution
To avoid damage to the system:
• Use the correct AC input voltage range.....
To reduce the risk of electric shock:
• Unplug the power cord before removing the system chassis
cover for installation or servicing. After installation or servicing,
cover the system chassis before plugging the power cord.
Battery:
• Danger of explosion if battery incorrectly replaced.
• Replace only with the same or equivalent type recommend
by
the manufacturer.
• Dispose of used batteries according to the battery
manufacturer’s
instructions.
Joystick or MIDI port:
• Do not use any joystick or MIDI device that requires more than
10A current at 5V DC. There is a risk of fire for devices that
exceed this limit.
FCC and DOC Statement on Class B
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio TV technician for
help.
Notice:
1. The changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
2. Shielded interface cables must be used in order to comply with
the emission limits.
4
Quick Setup Guide
1
Quick Setup
Guide
Table of Contents
Chapter 1
Quick Setup Guide.............................................
Chapter 2
English......................................................................
Chapter 3
Français (French).................................................
Chapter 4
Deutsch (German)................................................
Chapter 5
Español (Spanish)..................................................
5
26
42
58
76
5
1
Quick Setup Guide
Quick Setup
Guide
Chapter 1 - Quick Setup Guide
Table of Contents
1.1 System Board Layout..................................................................................................
1.2 Jumpers.....................................................................................................................................
1.3 Ports and Connectors................................................................................................
1.4 Award BIOS Setup Utility.......................................................................................
6
8
11
21
Note:
The user’s manual in the provided CD contains detailed information
about the system board. If, in some cases, some information doesn’t
match those shown in this manual, this manual should always be
regarded as the most updated version.
6
Quick Setup Guide
1
Quick Setup
Guide
1.1 System Board Layout
KB
Mouse
USB 1
USB 2
Game/MIDI: CN6
Line-
out
(CN4)
Line-
in
(CN5)
Mic-
in
(CN7)
J5
J9
COM 1 (CN1)
Parallel (CN2)
COM 2 (CN3)
Wake-On-KB/Mouse (JP1)
Socket 478 CPU fan
(J3A)
ATX Main
Power
(ATXP1)
System
fan (J8)
FDD
(J18)
Secondary IDE (J11)
Primary IDE (J12)
Battery
15
11
51
Clear CMOS
(JP3)
Firmware
Hub
Wake-On-LAN (J20)
IrDA (J19)
I/O
chip
PCI Standby Power LED
Chassis fan
(J22)
AC’97
2
19
10
Front audio (J16)
+12V power
(ATXP2)
4
3
2
1
Intel
82845E
MCH
Intel
82801
ICH2
CD-in
(J10)
DIMM
Standby
Power LED
AGP Slot
PCI 1 Slot
PCI 2 Slot
PCI 3 Slot
PCI 4 Slot
PCI 5 Slot
TAD (J14)
Wake-On-
Ring (J15)
DDR SDRAM
DIMM 1
DDR
SDRAM
DIMM 2
USB 3, 4
(J21/J23)
Factory use only (J7)
HD-LED
RESET
SPEAKER
PWR-LED
ATX-SW
G-LED
G-SW
J27
Wake-On-USB 1/2
(JP5)
Wake-On-USB
3/4 (JP4)
CPU FSB select (JP2)
NB71-BC
(Uses the Intel 845E chipset)
7
1
Quick Setup Guide
Quick Setup
Guide
KB
Mouse
USB 1
USB 2
Game/MIDI: CN6
Line-
out
(CN4)
Line-
in
(CN5)
Mic-
in
(CN7)
J5
J9
COM 1 (CN1)
Parallel (CN2)
COM 2 (CN3)
Wake-On-KB/Mouse (JP1)
Socket 478 CPU fan
(J3A)
ATX Main
Power
(ATXP1)
System
fan (J8)
FDD
(J18)
Secondary IDE (J11)
Primary IDE (J12)
Battery
15
11
51
Clear CMOS
(JP3)
Firmware
Hub
Wake-On-LAN (J20)
IrDA (J19)
I/O
chip
PCI Standby Power LED
Chassis fan
(J22)
AC’97
2
19
10
Front audio (J16)
CPU FSB select (JP2)
+12V power
(ATXP2)
4
3
2
1
Intel
82845D
MCH
Intel
82801
ICH2
CD-in
(J10)
DIMM
Standby
Power LED
AGP Slot
PCI 1 Slot
PCI 2 Slot
PCI 3 Slot
PCI 4 Slot
PCI 5 Slot
TAD (J14)
Wake-On-
Ring (J15)
DDR SDRAM
DIMM 1
DDR
SDRAM
DIMM 2
USB 3, 4
(J21/J23)
Factory use only (J7)
HD-LED
RESET
SPEAKER
PWR-LED
ATX-SW
G-LED
G-SW
J27
Wake-On-USB 1/2
(JP5)
Wake-On-USB
3/4 (JP4)
NB70-BC
(Uses the Intel 845D chipset)
8
Quick Setup Guide
1
Quick Setup
Guide
1.2 Jumpers
1.2.1 Clear CMOS Data - JP3
2-3 On:
Clear CMOS Data
1-2 On:
Normal (default)
1.2.2 Wake-On-Keyboard /Wake-On-Mouse - JP1
1-2 On:
Disable the Wake-On-
KB/Mouse function
(default)
2-3 On:
Enable the Wake-On-
KB/Mouse function
Important:
The 5VSB power source of your power supply must support
≥
720mA.
Clear CMOS
(JP3)
123
123
123
123
Wake-On-
KB/Mouse (JP1)
123
123
9
1
Quick Setup Guide
Quick Setup
Guide
1.2.4 CPU’s Front Side Bus - JP2
2-3 On:
Auto (default)
1-2 On:
100MHz
1
2
3
1
2
3
1.2.3 Wake-On-USB Keyboard - JP5 and JP4
Wake-On-USB 3/4
(JP4)
Wake-On-USB 1/2
(JP5)
123
1
2
3
123
JP4
JP5
1
2
3
1-2 On: Disable
(default)
123
JP4
JP5
1
2
3
2-3 On: Enable
CPU FSB select
(JP2)
1
2
3
10
Quick Setup Guide
1
Quick Setup
Guide
1.2.5 Factory Use Jumper - J7
This jumper is for factory use only. Please leave it in its default setting -
pins 1 and 2 On. Reconfiguring this jumper may cause problems.
Factory use only
(J7)
123
123
1-2 On (default)
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere DFI Hauptplatine Handbücher
DFI
DFI Lanparty JR P45-T2RS Bedienungsanleitung
DFI
DFI NB78-BC Bedienungsanleitung
DFI
DFI AD75 Bedienungsanleitung
DFI
DFI NFII ULTRA-AL Bedienungsanleitung
DFI
DFI CB64-BX Bedienungsanleitung
DFI
DFI AD77 INFINITY Bedienungsanleitung
DFI
DFI MB331-CRM Bedienungsanleitung
DFI
DFI CMS100 Bedienungsanleitung
DFI
DFI PB61-V3 Bedienungsanleitung
DFI
DFI CM64-AL Bedienungsanleitung
DFI
DFI G486-EVB Bedienungsanleitung
DFI
DFI P5BV3+/e Bedienungsanleitung
DFI
DFI LanParty UT nF3 250 Gd Bedienungsanleitung
DFI
DFI SD101 Bedienungsanleitung
DFI
DFI PR810-C622 Bedienungsanleitung
DFI
DFI SD170 Bedienungsanleitung
DFI
DFI CB60-ZX Bedienungsanleitung
DFI
DFI LanParty LT X38 series Bedienungsanleitung
DFI
DFI G486VPA Bedienungsanleitung
DFI
DFI AK34-SC Bedienungsanleitung
Beliebte Hauptplatine Handbücher anderer Marken
Gigabyte
Gigabyte GA-9IVDT Bedienungsanleitung
Texas Instruments
Texas Instruments ADS8372EVM Bedienungsanleitung
Commell
Commell MS-C73 Bedienungsanleitung
IBT Technologies
IBT Technologies MB860 Bedienungsanleitung
Nvidia
Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung
Biostar
Biostar M7VIT Bravo Bedienungs- und Montageanleitung
